2022 HYUNDAI SANTA FE HYBRID charge

01
1-23
How to Connect Portable Charger
(ICCB: In-Cable Control Box)
PlugPlug Electric OutletElectric Outlet
OLFP0Q5020K
1. Connect the plug to a household electric outlet.
OOSEVQ018056
2. Check if the power lamp (green) illuminates on the control box.
3. Depress the brake pedal and apply the parking brake.
4. Turn OFF all switches, shift to P (Park), and turn OFF the vehicle.
OTMPHQ010005L
5. Press center edge of the charging door to open the charging door.
6. Check if there is dust on the charging connector and charging inlet.
OTMPHQ010006L
7. Hold the charging connector handle and connect it to the vehicle AC
charging inlet. Push the connector
until you hear a "clicking" sound. If
the charging connector and charging
terminal are not connected properly,
this may cause a fire.

Foreword / Hybrid System Overview
1-24
Information
Charging connector AUTO/LOCK mode
The charging connector is locked in the
inlet at a different period according to which mode is selected.
[ LOCK mode : The connector locks
when the charging connector is plugged into the charging inlet.

[ AUTO mode : The connector locks when charging starts.
For more details, refer to “Charging
Connector AUTO/ LOCK Mode” in this
chapter.
OOSEVQ018057
8. Charging starts automatically (charging lamp blinks).
„Type A „Type B
OTMPHQ010007LOTMPHQ010008L
9. Check if the charging indicator light of the high voltage battery
on the instrument cluster is turned
ON. Charging is not done when the
charging indicator lamp is OFF.
When the charging connector is not
connected properly, reconnect the
charging cable to charge it again.
Information

[ Even though charging is possible with
the ignition switch in the ON/START
position, for your safety, start charging when the ignition switch is in the
LOCK/OFF position and the vehicle
shifted to P (Park).
After charging has started, you can use electrical components such as the radio
by placing the ignition switch in ACC
or ON position.

[ Moving the shift lever from P (Park) to R (Reverse)/N(Neutral)/D (Drive) stops
the charging process.
To restart the charging process, move
the shift lever to P (Park), place the
ignition switch to the LOCK/OFF position, and disconnect the charging
cable. Then, connect the charging cable.

01
1-25
OAEPHQ049818L
10. After charging has started, the
estimated charging time is displayed
on the instrument cluster for about 1
minute.
If you open the driver seat door while
charging, the estimated charging time
is also displayed on the instrument
cluster for about 1 minute.
When scheduled charging is set, the
estimated charging time is displayed
as “--" .
Information
Depending on the condition and durability
of the high voltage battery, charger
specifications, and ambient temperature,
the time required for charging the battery
may vary. Checking Charging Status
OTMPHQ010003L
When charging the high voltage battery,
the charge level can be checked from
outside the vehicle.

1-27
01
Charging Status Indicator Lamp for Portable Charger
„Control Box
OOSEVQ018058
IndicatorDetails
PLUG
On : Power on
Blink : Plug temperature sensor failure
On : Plug high temperature protection
Blink : Plug high temperature warning
POWER
On : Power on
CHARGE
Blink : Charging In power saving mode, only the CHARGE
indicator is illuminated.
FAULT
Blink : Charging interrupted

Foreword / Hybrid System Overview
1-28
IndicatorDetails
CHARGE LEVEL
Type A Type B Type C
12 A 10 A 8 A
10 A 8 A 7 A
8 A 6 A 6 A
The charging current changes (3
level) whenever the button (1) is
pressed for 1 sec with the charger
plugged into an electrical outlet
but not the vehicle. * Back of the control box
OAEQ047025
VEHICLE
Charging connector plugged
Charging
Blink : Charging impossible

01
1-29
Status / Diagnosis / Countermeasure
OOSEVQ018059

[ Charging connector plugged into
vehicle (Green ON)

[ Plug temperature sensor failure
(Green blink)

[ Plug high temperature protection
(Red blink)

[ Plug high temperature warning (Red ON)
You contact an authorized HYUNDAI
dealer.
OOSEVQ018063
Charging connector plugged into vehicle
(Green ON)
OOSEVQ018060
While charging
[ Charge indicator (Green blink)

[ Vehicle indicator (Blue ON)
OOSEVQ018064
Before plugging charging connector into
vehicle (Red blink)
[ Abnormal temperature

[ ICCB (In-Cable Control Box) failure
You contact an authorized HYUNDAI
dealer.

01
1-31
How to Disconnect Portable Charger
(ICCB: In-Cable Control Box)
OTMPHQ010009L
1. Hold the charging connector handle and pull it while pressing the release
button.
Information
To prevent charging cable theft,
the charging connector cannot be
disconnected from the inlet when the
doors are locked. Unlock all doors to
disconnect the charging connector from the inlet.
However, if the vehicle is in the charging
connector AUTO mode, the charging
connector automatically unlocks from the inlet when charging is completed.
For more details, refer to “Charging
Connector AUTO/ LOCK Mode” in this
chapter.
OTMPHQ010010L
2. Make sure to completely close the charging door.

à The charging door dose not have a
locking system.
PlugPlug Electric OutletElectric Outlet
OAEEQ016061
3. Disconnect the plug from the household electric outlet. Do not pull the cable when disconnecting the plug.
4. Close the protective cover for the charging connector so that foreign
material cannot get into the terminal.
5. Put the charging cable inside the cable compartment to protect it.

Foreword / Hybrid System Overview
1-32
Unlock Charging Connector in
Emergency
OTMPHQ010011L
If the charging connector does not
disconnect due to battery discharge and
failure of the electric wires, open the
hood and slightly pull the emergency
cable. The charging connector will then disconnect. Precautions for Portable Charger
(ICCB: In-Cable Control Box)
[
Use the portable charger that is
certified by HYUNDAI Motors.

[ Do not try to repair, disassemble, or
adjust the portable charger.

[ Do not use an extension cord or
adapter.

[ Stop using immediately when failure
occurs.

[ Do not touch the plug and charging
connector with wet hands.

[ Do not touch the terminal part of the
AC charging connector and the AC
charging inlet on the vehicle.

[ Do not connect the charging
connector to voltage that does not
comply with regulations.

[ Do not use the portable charger if it
is worn out, exposed, or there exists
any type of damage on the portable
charger.

[ If the ICCB case and AC charging
connector is damaged, cracked, or the
wires are exposed in any way, do not
use the portable charger.

[ Do not let children operate or touch
the portable charger.