2022 HYUNDAI I10 Screen

5-66
Convenient features
Temperature control
OAI3059111I
The temperature will increase by
turning the knob to the right.
The temperature will decrease by
turning the knob to the left.
The temperature will increase or
decrease by 0.5°C (1°F) for each
incremental location. When set to the
lowest temperature setting, the air
conditioning will operate continuously.
7emperature conversion
If the battery has been discharged or
disconnected, the temperature mode
display will reset to Centigrade.
To change the temperature unit from
°C to °F or °F to °C :
- Automatic climate control system
Press the AUTO button for 3 sec-
onds whilst pressing the OFF but-
ton.
- Instrument cluster
Go to User Settings o Other
Features o Temperature Unit.
The temperature unit on both the
cluster LCD display and the climate
control screen will change.
Air intake control
OAI3059106I
This is used to select the outside
(fresh) air position or recirculated air
position.
To change the air intake control posi-
tion, push the control button.
Recirculated air position
With the recirculated air
position selected, air
from the passenger
compartment will be
drawn through the heat-
ing system and heated
or cooled according to
the function selected.
2utside (fresh) air position
With the outside (fresh)
air position selected, air
enters the vehicle from
outside and is heated or
cooled according to the
function selected.

5-67
05
i Information
2perating the system primarily in
Fresh mode is recommended. 8se
Recirculation mode temporarily only
when needed.
Prolonged operation of the heater in
Recirculation mode and without the
A/C 21 can cause fogging of the wind-
screen.
In addition, prolonged use of the A/C
21 in Recirculation mode may result
in excessively dry, dehumidified air in
the cabin and may promote formation
of musty vent odor due to stagnant air.
WARNING

5-68
Convenient features
Air conditioning
OAI3059107I
3XVKWKH$&EXWWRQWRPDQXDOO\WXUQ
the air conditioning system on (indi-
cator light will illuminate).
Push the button again to turn the air
conditioning system off.
OFF mode
OAI3059116I
Push the OFF button of the front to
turn off the air climate control system.
However, you can still operate the
mode and air intake buttons as long
as the ignition switch is in the ON
position.
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to fresh
mode.
3. Set the temperature control to the
desired position.
4. Set the fan speed control to the
desired speed.
5. If desired, turn the air conditioning
ON with the temperature control
knob set to heat in order to dehu-
midify the air before it enters into
the cabin.
If the windscreen fogs up, select the
Floor & Defrost
mode or press
the Front Defrost
mode.

5-73
05
WARNING
Windscreen heating
Do not use the or position
during cooling operation in
extremely humid weather. The dif-
ference between the temperature
of the outside air and that of the
windscreen could cause the outer
surface of the windscreen to fog
up, causing loss of visibility. In
this case, set the mode selection
knob or button to the
position
and fan speed control knob or but-
ton to lower speed.

5-74
Convenient features
Automatic climate control
system
To defog inside windscreen
OAI3059108I
1. Select desired fan speed.
2. Select desired temperature.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature, outside (fresh) and
higher fan speed will be selected
automatically.
If the air-conditioning, outside (fresh)
air position and higher fan speed are
QRWVHOHFWHGDXWRPDWLFDOO\DGMXVWWKH
corresponding button or knob manu-
ally.
If the
position is selected, lower
IDQ VSHHG LV DGMXVWHG WR KLJKHU IDQ
speed.
To defrost outside windscreen
OAI3059109I
1. Set the fan speed to the highest
position.
6HWWKHWHPSHUDWXUHWRWKHH[WUHPH
hot (HI) position.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature and outside (fresh)
mode will be selected automatical-
ly.
If the position is selected, lower fan
VSHHGLVDGMXVWHGWRKLJKHUIDQVSHHG

5-75
05
Defroster
NOTICE
To prevent damage to the conduc-
tors bonded to the inside surface
of the rear window, never use
sharp instruments or window
cleaners containing abrasives to
clean the window.
i Information
If you want to defrost and defog the
front windscreen, refer to “Windscreen
'efrosting and 'efogging” in this
chapter.
Rear window defroster
OAI3059102
„Manual climate control system
„Automatic climate control system
OAI3059102I
The defroster heats the window to
remove frost, fog and thin ice from
WKH LQWHULRU DQG H[WHULRU RI WKH UHDU
window, whilst engine is running.

5-97
05
6\VWHPOD\RXW²FRQWUROSDQHO
AUDIO
ãWITHOUT TOUCH SCREEN
ä
à The system’s actual appearance and layout may differ depending on the
vehicle model and specification. (1) 5$',2EXWWRQ

5-103
05
i Information
$ERXWKDQGOLQJWKHV\VWHP
‡ 'o not apply excessive force to the
system. Excessive pressure on the
screen may damage the LC' panel
or the touch panel.
‡ When cleaning the screen or button
panel, make sure to stop the engine
and use a soft, dry cloth. Wiping the
screen or buttons with a rough cloth
or using solvents (alcohol, ben]ene,
paint thinner, etc.) may scratch or
chemically damage the surface.
‡ If you attach a liquid-type air fresh-
ener to the fan louvre, the surface of
the louvre may become deformed
due to the flowing air.
‡ If you want to change the position of
the installed device, please inquire
with your place of purchase or ser-
vice maintenance centre. 7echnical
expertise is required to install or dis-
assemble the device.
NOTICE