2022 HYUNDAI ELANTRA N check oil

09
9-23
Checking the Brake/Clutch Fluid
Level
OCN7N091036NOCN7N091036N
Check the fluid level in the reservoir
periodically. The fluid level should be
between MAX and MIN marks on the side
of the reservoir.
Before removing the reservoir cap and
adding brake fluid, clean the area around
the reservoir cap thoroughly to prevent
brake fluid contamination.
If the level is low, add fluid to the MAX
level. The level will fall with accumulated
mileage. This is a normal condition
associated with the wear of the brake
linings.
If the fluid level is excessively low, have
the system be checked by an authorized
HYUNDAI dealer.
Information
Use only the specified brake/clutch fluid.
Refer to “Recommended lubricants and
capacities” in chapter 2.
Information
Before removing the brake/clutch filler
cap, read the warning on the cap.
Information
Clean the filler cap before removing. Use
only DOT4 brake/clutch fluid from a
sealed container.
WARNING
Do not allow brake fluid to come in
contact with your eyes. If brake/clutch
fluid comes in contact with your eyes,
flush your eyes with clean water for
at least 15 minutes and get immediate
medical attention.
NOTICE
• Do not allow brake/clutch fluid to
contact the vehicle’s body paint, as
paint damage will result.
• Brake/clutch fluid, which has been
exposed to open air for an extended
time should never be used as its
quality cannot be guaranteed. It
should be disposed of properly.
• Don’t put in the wrong kind of fluid. A
few drops of mineralbased oil, such
as engine oil, in your brake system
can damage system parts.
• To maintain the best braking
performance and ABS/ESC
performance, have you use genuine
brake/clutch fluid that conform to
specifications.
(Standard : SAE J1704 DOT-4 LV,
ISO4925 CLASS-6 and FMVSS 116
DOT-4)
BRAKE/CLUTCH FLUID
CN7 N HMA 9.indd 9-23 2021-09-08  9:30:17

09
9-25
Filter Replacement
OCN7N091005OCN7N091005
The air cleaner filter can be cleaned for
inspection using compressed air. Do not
attempt to wash or to rinse it, as water
will damage the filter. If soiled, the air
cleaner filter must be replaced.
OCN7N091006 OCN7N091006
1. Loosen the air cleaner cover attaching clip (1) and open the cover.
OCN7N091007 OCN7N091007
2. Replace the air cleaner filter.
OCN7N091008 OCN7N091008
OCN7N091009OCN7N091009
3. Insert the air cleaner cover in the hinge (2) and engage the clip (3) after
closing the cover.
4. Check that the cover is firmly installed.
AIR CLEANER
CN7 N HMA 9.indd 9-25 2021-09-08  9:30:17

Maintenance9-32
Battery Recharging
WARNING
Always follow these instructions when
recharging your vehicle’s battery to
avoid the risk of SERIOUS INJURY or
DEATH from explosions or acid burns:
• Before performing maintenance or
recharging the battery, turn off all
accessories and place the ignition
switch to the LOCK/OFF position.
• Keep all flames, sparks, or smoking
materials away from the battery.
• Always work outdoors or in an area
with plenty of ventilation.
• Wear eye protection when checking
the battery during charging.
• The battery must be removed from
the vehicle and placed in a well
ventilated area.
• Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin boiling
violently.
• Vehicle is equipped with the
Absorbent Glass Mat (AGM) battery.
Do not charge the AGM battery with
a general charger. It may damage
or explode the AGM battery. Only
charge the AGM battery with a
charger that has AGM battery
setting.
• The negative battery cable must
be removed first and installed last
when the battery is disconnected.
Disconnect the battery charger in the
following order:
1. Turn off the battery charger main
switch.
2. Unhook the negative clamp from the negative battery terminal.
3. Unhook the positive clamp from the positive battery terminal.
• Always use a genuine HYUNDAI
approved battery when you replace
the battery.
NOTICE
AGM battery (if equipped)
• Absorbent Glass Matt (AGM)
batteries are maintenance-free and
have the AGM battery be serviced
by an authorized HYUNDAI dealer.
For charging your AGM battery, use
only fully automatic battery chargers
that are specially developed for AGM
batteries.
• When replacing the AGM battery,
have you use parts for replacement
from an authorized HYUNDAI dealer.
• Do not open or remove the cap on
top of the battery. This may cause
leaks of internal electrolyte that
could result in severe injury.
By jump starting
After a jump start from a good battery,
drive the vehicle for 20-30 minutes
before it is shutoff. The vehicle may
not restart if you shut it off before the
battery had a chance to adequately
recharge. See “Jump Starting” in chapter
7 for more information on jump starting
procedures.
Information
An inappropriately disposed
battery can be harmful to
the environment and human
health. Dispose of the battery
according to your local law(s) or
regulations.
Reset Items
Items should be reset after the battery
has been discharged or the battery has
been disconnected.
• Auto up/down window (See chapter 5)
• Sunroof (See chapter 5)
• Trip computer (See chapter 4)
• Climate control system (See chapter 5)
CN7 N HMA 9.indd 9-32 2021-09-08  9:30:22

09
9-47

v Cartridge type

v
Blade type

v Multi fuse Normal Blown
Normal Blown
Normal Blown
OTM078035OTM078035
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
This vehicle has 2 (or 3) fuse panels, one
located in the driver’s side panel bolster,
the other in the engine compartment
near the battery.
If any of your vehicle’s lights,
accessories, or controls do not work,
check the appropriate circuit fuse. If a
fuse has blown, the element inside the
fuse will be melted or broken.
If the electrical system does not work,
first check the driver’s side fuse panel.
Before replacing a blown fuse, turn the
engine and all switches off, and then
disconnect the negative battery cable.
Always replace a blown fuse with one of
the same rating.
If the replacement fuse blows, this
indicates an electrical problem.
Avoid using the system involved and
immediately consult an authorized
HYUNDAI dealer.
WARNING
NEVER replace a fuse with anything but
another fuse of the same rating.
• A higher capacity fuse could cause
damage and possibly cause a fire.
• Do not install a wire or aluminum
foil instead of the proper fuse -
even as a temporary repair. It may
cause extensive wiring damage and
possibly a fire.
NOTICE
Do not use a screwdriver or any other
metal object to remove fuses because
it may cause a short circuit and damage
the system.
FUSES
CN7 N HMA 9.indd 9-47 2021-09-08  9:30:24

09
9-55
Engine compartment fuse panel
Type Fuse NameFuse Rating Circuit Protected
MIDI
FUSE
-3 ALT
180A[G4FM/G4FG/G4NA] Alternator, (Fuse - F33, F34,
F35, F37)
[G4FP] Alternator, (Fuse - F33, F34, F35, F37)
MDPS1 100A MDPS Unit
MIDI
FUSE-2 COOLING
FAN2 80A [G4FP] Cooling Fan Controller
EOP 60A Electronic Oil Pump
RR HTD 50A Rear Glass Heated
MIDI
FUSE-1 B+5
60APCB Block (Engine Control Relay, Fuse - F1, F2,
F3, F4, F6)
B+1 60A ICU Junction Block (IPS2/IPS5/IPS6/IPS7/IPS14)
B+2 60AICU Junction Block (IPS1/IPS4/IPS8/IPS9/IPS10/
IPS13)
B+3 50AICU Junction Block (Fuse - F13, F14, F22, F23,
F32,F40, F41, Long Term Load Latch Relay)
BLOWER 40A BLOWER Motor, Multipurpose Check Connector
IG1 40A E/R Junction Block (RLY.4/6), Ignition Switch
IG2 40A E/R Junction Block (RLY.3/5), Ignition Switch
DCT1 60A TCU
PTC
HEATER 50A PTC HEATER
CN7 N HMA 9.indd 9-55
2021-09-08  9:30:27

09
9-57
Engine compartment fuse panel (PCB block) (Smartstream 2.5 GDI)
Type Fuse NameFuse Rating Circuit Protected
FUSE E
CS (15A)
15A ECS Unit
A/C 10A [G4FM] A/C Compressor
HORN 15A Horn, Horn Switch
IGN COIL 20A[G4FM/G4NA/G4FP] Ignition Coil #1~#4
[G4FG] Ignition Coil #1~#4
ECU3 10A PCM/ECM, [MT] IGN LOCK CLUTCH SW
SENSOR3 10A E/R Junction Block (RLY.8)
ECU2 15A PCM/ECM
SENSOR2 10A[G4FM] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, E/R Junction Block (RLY.1/11),
A/C Relay
[G4FG] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, E/R Junction Block (RLY.1/11)
[G4NA] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, Oil Pump Solenoid Valve, E/R
Junction Block (RLY.1/11)
[G4FP] Oil Control Valve (Intake/Exhaust),
Variable Intake Solenoid Valve, Purge Control
Solenoid Valve, RCV Control Solenoid Valve,
Cooling Fan Controller
[Theta 2 T-GDI] Oil Control Valve(Exhaust),
Electronic Water Pump, RCV, Cooling Fan, Purge
Control Solenoid Valve, A/C Comp RLY, Oil Level
Sensor, Canister Closing Valve, Active Exhaust
Valve
SENSOR1 15A Oxygen Sensor (UP/DOWN)
ABS3 10AABS Control Module, ESP Control Module,
Multipurpose Check Connector
ECU1 20A PCM/ECM
CN7 N HMA 9.indd 9-57
2021-09-08  9:30:28

IndexI-4
D
Declaration of conformity........................................................................\
............ 7-78
Dimensions .............................................................\
............................................... 2-8
Drive Mode Integrated Control System ............................................................... 6-44
Drive Mode ........................................................................\
.............................. 6-44
N Mode ........................................................................\
..................................... 6-46
NGS (N Grin Shift) ........................................................................\
.................. 6-48
Vehicle Characteristic ........................................................................\
............... 6-49
Driver Attention Warning (DAW) ...................................................................... 7-43
Driver Attention Warning Malfunction and Limitations .................................. 7-47
Driver Attention Warning Operation ................................................................ 7-45
Driver Attention Warning Settings .................................................................. 7-43
Dual Clutch Transmission ........................................................................\
........... 6-18
Dual Clutch Transmission Operation ............................................................... 6-18
Good Driving Practices ........................................................................\
............ 6-27
LCD Display for Transmission Temperature and Warning Message ............... 6-20
Paddle Shifter (Manual Shift Mode) ............................................................... 6-26
Parking ........................................................................\
..................................... 6-26
E
Electronic Control Suspension (ECS) ................................................................. 6-40
Electronic Limited Slip Differential .................................................................... 6-41
Warning messages ........................................................................\
.................... 6-42
Emission Control System ........................................................................\
............ 9-73
Engine Compartment ........................................................................\
............. 2-7, 9-3
Engine Coolant ........................................................................\
............................ 9-19
Changing Engine Coolant ........................................................................\
........ 9-22
Checking the Engine Coolant Level ................................................................. 9-19
Engine Number ........................................................................\
............................ 2-15
Engine Oil ........................................................................\
.................................... 9-16
Checking the Engine Oil and Filter .................................................................. 9-17
Checking the Engine Oil Level ........................................................................\
9-16
Engine Specification ........................................................................\
...................... 2-8
Engine Start/Stop Button ........................................................................\
.............. 6-5
Explanation of Scheduled Maintenance Items .................................................... 9-14
Drive Axle Shafts and Boots ........................................................................\
.... 9-15
Dual clutch transmission fluid ........................................................................\
. 9-15
CN7 N HMA Index.indd I-4 2021-09-08  11:16:48