Page 94 of 641

92
uuIndicators u
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
High 
Temperature 
Indicator 
(Red)
•Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Blinks when the engine coolant 
temperature goes up, and stays on 
if the temperature continues to 
rise.
• Goes off, then comes on in blue when 
the engine coolant temperature is low.
• Blinks while driving  - Drive slowly to 
prevent overheating.
• Stays on while driving  - Immediately 
stop in a safe place and allow the engine 
to cool.
2 Overheating  P. 601
Low 
Temperature 
Indicator 
(Blue)•Comes on while the engine 
coolant temperature is low, then 
goes off once the engine reaches 
normal operating temperature.• If the indicator stays on after the engine 
has reached normal operating 
temperature, there may be a problem 
with the temperature sensors. Have your 
vehicle inspected by a dealer.
—
Auto High-
Beam 
Indicator
*
•Comes on when all the operating 
conditions of the auto high-beam 
are met.
2 Auto High-Beam* P. 180—
* Not available on all models
22 HR-V HDMC-31T7A6600.book  92 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 95 of 641

93
uuIndicators u
Continued
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Vehicle 
Stability 
Assist
TM (VSA®) 
System 
Indicator
• Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Blinks when VSA ® is active.
• Comes on if there is a problem 
with the VSA ® system or hill start 
assist system.
• Stays on constantly  - Have your vehicle 
checked by a dealer.
2 Vehicle Stability AssistTM (VSA ®), aka 
Electronic Stability Control (ESC), 
System  P. 454
Vehicle 
Stability 
Assist
TM (VSA®) 
OFF  Indicator
•Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Comes on when you deactivate 
VSA ®.2VSA ® On and Off  P. 455—
Door and 
Tailgate Open 
Indicator
*
•Comes on for a few seconds if you 
turn the ignition switch to ON 
(w*1, then goes off.
• Comes on if any door or the 
tailgate is not completely closed.
• The beeper sounds and the 
indicator comes on if any door or 
the tailgate is opened while 
driving.
•Goes off when all doors and the tailgate 
are closed.
—
* Not available on all models
22 HR-V HDMC-31T7A6600.book  93 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 96 of 641

94
uuIndicators u
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Electric Power 
Steering (EPS) 
System 
Indicator•Comes on when you turn the 
ignition switch to ON 
(w*1, and 
goes off when the engine starts.
• Comes on if there is a problem 
with the EPS system.
• Stays on constantly or does not come 
on at all - Have your vehicle checked by 
a dealer.
2 If the Electric Power Steering (EPS) 
System Indicator Comes On  P. 605
Low Tire 
Pressure/TPMS 
Indicator
•Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• May come on briefly if the ignition 
switch is turned to ON 
(w*1 and 
the vehicle is not moved within 45 
seconds, to indicate the calibration 
process is not yet complete.
• Comes on and stays on when:
- One or more tires’ pressures are 
determined to be significantly 
low.
- The system has not been 
calibrated.
• Comes on while driving  - Stop in a safe 
place, check tire pressures, and inflate 
the tire(s) if necessary.
• Stays on after the tires are inflated to 
the recommended pressures  - The 
system needs to be calibrated.
2 TPMS Calibration  P. 460
•Blinks for about one minute, and 
then stays on if there is a problem 
with the TPMS, or when a 
compact spare tire is temporarily 
installed.• Blinks and remains on  - Have your 
vehicle checked by a dealer. If the vehicle 
is fitted with a compact spare, get your 
regular tire repaired or replaced and put 
back on your vehicle as soon as you can.
U.S. 
models 
only
* Not available on all models
22 HR-V HDMC-31T7A6600.book  94 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 97 of 641

95
uuIndicators u
Continued
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Keyless Access 
System 
Indicator
*
•Comes on for a few seconds when 
you set the power mode to ON, 
then goes off.
• Comes on as soon as a problem is 
detected in the keyless access 
system or push button starting 
system.•Stays on constantly or does not come 
on at all  - Have your vehicle checked by 
a dealer.
System 
Message 
Indicator
*
• Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Comes on along with a beep 
when a problem is detected. A 
system message on the multi-
information display appears at the 
same time.
•While the indicator is on, press the 
 (information) button to see the 
message again.
• Refer to the Indicators  information in this 
chapter when a system message appears 
on the multi-information display. Take 
the appropriate action for the message.
• The multi-information display does not 
return to the normal screen unless the 
warning is canceled, or the   
button is pressed.
—
Turn Signal 
and Hazard 
Warning 
Indicators•Blinks when you operate the turn 
signal lever.
• Blink if you press the hazard 
warning button.•Does not blink or blinks rapidly  - A 
turn signal light bulb has blown. Change 
the bulb immediately.
2 Replacing Light Bulbs  P. 547, 550, 551
—
High Beam 
Indicator•Comes on when the high beam 
headlights are on.——
* Not available on all models
22 HR-V HDMC-31T7A6600.book  95 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 98 of 641

96
uuIndicators u
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Lights On 
Indicator
•Comes on whenever the light 
switch is on, or in  AUTO* when 
the exterior lights are on.
• If you remove the key  from the ignition 
switch*, or set the power mode* to 
VEHICLE OFF (LOCK) while the exterior 
lights are on, a chime sounds when the 
driver’s door is opened.
Fog Light 
Indicator*
• Comes on when the fog lights are 
on.——
Immobilizer 
System 
Indicator
•Comes on briefly when you turn 
the ignition switch to ON 
(w*1, 
then goes off.
• Comes on if the immobilizer 
system cannot recognize the key 
information.
• Blinks -
You cannot start the engine. Turn the 
ignition switch to LOCK 
(0, pull the key 
out, and then insert the  key and turn it to 
ON 
(w again.
You cannot start the engine. Set the 
power mode to VEHICLE OFF (LOCK), 
then select the ON mode again.
• Repeatedly blinks  - The system may be 
malfunctioning. Have your vehicle 
checked by a dealer.
• Do not attempt to alter this system or add 
other devices to it. Electrical problems 
can occur.
—
Models without keyless access system
Models with keyless access system
* Not available on all models
22 HR-V HDMC-31T7A6600.book  96 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 99 of 641
97
uuIndicators u
Continued
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
ECON Mode 
Indicator
•Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Comes on when you press the 
ECON button.2 ECON Button  P. 450
Security 
System Alarm 
Indicator
•Blinks when the security system 
alarm has been set.
2 Security System Alarm  P. 163—
CRUISE MAIN 
Indicator*• Comes on when you press the 
CRUISE button.2 Cruise Control* P. 451—
CRUISE 
CONTROL  
Indicator
*
• Comes on if you have set a speed 
for cruise control.
2 Cruise Control* P. 451—
Maintenance 
Minder 
Indicator
*
•Comes on when the scheduled 
maintenance is due soon.
2 Maintenance MinderTM P. 525—
Indicator
Indicator
* Not available on all models
22 HR-V HDMC-31T7A6600.book  97 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 100 of 641
98
uuIndicators u
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
All-Wheel 
Drive (AWD) 
System 
Indicator
*
• Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Comes on if there is a problem 
with the AWD.
• Blinks when the AWD system is 
overheated. The system is inactive.
• Stays on constantly  - the engine drives 
only the front wheels in this state. Have 
your vehicle checked by a dealer.
• Blinks while driving  - the engine drives 
only the front wheels in this state. Stop in 
a safe place, shift to 
(P, and idle the 
engine until the indicator goes off. If the 
indicator does not stop blinking, take 
your vehicle to a dealer.
2 Real Time AWD with Intelligent 
Control SystemTM* P. 458
* Not available on all models
22 HR-V HDMC-31T7A6600.book  98 ページ  2021年4月12日 月曜日 午前10時50分 
         
        
        
     
        
        Page 101 of 641

99
uuIndicators u
Continued
Instrument Panel
*1:Models with the keyless access system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Road 
Departure 
Mitigation 
(RDM) 
Indicator
*
•Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.
• Comes on if there is a problem 
with the RDM system.
•Stays on constantly  - Have your vehicle 
checked by a dealer.
• Comes on when the RDM system 
shuts itself off.•Stays on  - The temperature inside the 
camera is too high.
Use the climate contro l system to cool 
down the camera.
The system activates when the 
temperature inside the camera cools 
down.
2 Front Sensor Camera  P. 504
•Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your 
vehicle in a safe place, and wipe it off 
with a soft cloth.
• Have your vehicle checked by a dealer if 
the indicator and message come back on 
after you cleaned the area around the 
camera.
2 Front Sensor Camera  P. 504
•Comes on if anything covers the 
radar sensor cover and prevents 
the sensor from detecting a 
vehicle in front.
• May come on when driving in bad 
weather (rain, snow, fog, etc.)•When the radar sensor ge ts dirty, stop your 
vehicle in a safe place, and wipe off dirt using 
a soft cloth. Indicator may take some time to 
go off after the radar sensor is cleaned.
• Have your vehicle checked by a dealer if 
the indicator does not go off even after 
you clean the sensor cover.
2 Radar Sensor P. 506
* Not available on all models
22 HR-V HDMC-31T7A6600.book  99 ページ  2021年4月12日 月曜日 午前10時50分