2022 CITROEN C1 display

88
C1_en_Chap04_conduite_ed01-2016
Switching off
F Press  the   end   of   the   control   stalk. T
he   display   of   information   related   to   the  
sp

eed
 l
imiter
 d
isappears.
Operating fault
Illumination of this warning lamp in the   instrument   panel   indicates   a   fault  
w

ith   the   speed   limiter.
Have
  it   checked   by   a   CITROËN  
d

ealer   or   a   qualified   workshop.
The
  use   of   mats   not   approved   by  
C

ITROËN   may   inter fere   with   the  
o

peration   of   the   speed   limiter.
To
 
avoid   any   risk   of   jamming   of   the  
ped

als:
-
 
e
nsure   that   the   mat   is   secured  
c

o r r e c t l y,
-
 
d
o   not   fit   one   mat   on   top   of   another.
Temporarily exceeding the
programmed speed
F Press f irmly  on   the   accelerator   pedal,  g
oing   beyond   the   point of resistance, to
exceed
  the   programmed   speed   limit.
The
  speed   limiter   is   deactivated   temporarily  
a

nd   the   displayed   programmed   speed   flashes.
As
  soon   as   the   vehicle's   speed   returns   to   the  
p

rogrammed   value,   the   limiter   operates   again:  
t

he   display   of   the   programmed   speed   becomes  
s

teady   again.
An
  audible   signal   accompanies   the  
f

lashing   of   the   programmed   speed  
w

hen   exceeding   the   speed   is   not   due   to  
a

n   action   by   the   driver   (steep   hill...).
Driving

89
C1_en_Chap04_conduite_ed01-2016
Speed limiter (VTi 68 engine)
System which prevents the vehicle from exceeding the speed programmed by the driver.
T he   speed   limiter   is   switched on
 m
anually:
 t

his   can   be   done   whatever   the   speed   of   the  
v

ehicle.   However,   if   you   are   driving   at   less   than  
2

0   mph   (30   km/h),   the   programmed   speed   will  
b

e   fixed   at   20   mph   (30   km/h).
The
  speed   limiter   is   paused by operation of the
control.
The
  programmed   speed   can   be   exceeded  
t

emporarily   by   pressing   the   accelerator   firmly  
b

eyond   the   point   of   resistance.
To
  return   to   the   programmed   speed,   simply  
r

elease   the   accelerator   pedal   until   the   vehicle  
r

eturns   to   the   programmed   speed   limit.
The
  programmed   limit   speed   is   erased  
w

hen   switching   off   the   ignition.
Steering mounted controls
The controls are grouped together on this control   stalk   at   the   steering   wheel.
1.
 S

peed   limiter   on   /   off:   by   pressing   the   end  
o

f   the   control   stalk.
2.
 P

rogramming   the   speed
 D

ecrease   the   setting:   by   pushing   the  
c

ontrol   stalk   down.
3.
 R

estore   speed   limiter
 I

ncrease   the   setting:   by   pushing   the   control  
s

talk   up.
4.
 P

ause   speed   limiter:   by   pulling   the   control  
s

talk   towards   you.
Displays in the instrument panel
The information is grouped together in the instrument   panel   screen.
5.
 S

peed   limiter   on   /   pause   indication.
6.
 S

peed   value   setting.
The speed limiter cannot, in any circumstances,   replace   the   need   to   observe s

peed   limits,   nor   can   it   replace   the   need   for
 v

igilance   on   the   part   of   the   driver.
If you choose to display other information (trip  A
  for   example),   the   speed   limiter  
i

nformation   is   automatically   displayed   again  
a

fter   about   6   seconds.
4
Driving

91
C1_en_Chap04_conduite_ed01-2016
Switching off
F Press  the   end   of   the   control   stalk T
he   display   of   information   related   to   the  
sp

eed
 l
imiter
 d
isappears.
Operating fault
Illumination of this warning lamp in the   instrument   panel   indicates   a   fault  
w

ith   the   speed   limiter.
The
  use   of   mats   not   approved   by  
C

ITROËN   may   inter fere   with   the  
o

peration   of   the   speed   limiter.
To
 
avoid   any   risk   of   jamming   of   the  
ped

als:
-
 
e
nsure   that   the   mat   is   secured  
c

o r r e c t l y,
-
 
d
o   not   fit   one   mat   on   top   of   another.
Temporarily exceeding the
programmed speed
F Press f irmly  on   the   accelerator   pedal,  g
oing   beyond   the   point of resistance,
to
exceed
  the   programmed   speed   limit.
The
  speed   limiter   is   deactivated   temporarily  
a

nd   the   displayed   programmed   speed   flashes.Have
  it   checked   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
An
  audible   signal   accompanies   the  
f

lashing   of   the   programmed   speed  
w

hen   exceeding   the   speed   is   not   due   to  
a

n   action   by   the   driver   (steep   hill...).
As
  soon   as   the   vehicle's   speed   returns   to   the  
p

rogrammed   value,   the   limiter   operates   again:  
t

he   display   of   the   programmed   speed   becomes  
s

teady   again.
4
Driving

93
C1_en_Chap04_conduite_ed01-2016
Lane departure warning system
System which detects the unintended crossing of longitudinal traffic lane markings on the ground, using a camera that recognises both solid and broken   lines.
To
  improve   your   safety,   the   camera   analyses   the   image   and   then   triggers   a   warning   if   the   vehicle   wanders   over   a   lane   marking   (speed   higher   than  
3

0 mph   (50   km/h)).
This
  system   is   particularly   suitable   for   motor ways   and   dual   carriageways.
The
  lane   departure   warning   system  
c

annot   in   any   circumstances   replace  
t

he   need   for   vigilance   on   the   part   of   the  
d

river.
It
  is   necessary   to   observe   driving  
r

egulations   and   take   a   break   every  
two
  hours.
Activation
F Press  this   button,   located   on   the   steering  w
heel.
Detection
You are alerted by an audible signal and the display   of   a   warning   lamp   in   the   instrument   panel.
No
  alert   is   given   if   the   direction  
i

ndicators   are   on   and   for   around  
20
  seconds   after   they   stop   flashing.
The
 
s

ystem
 
s

hould
 
b

e
 
d

eactivated
 
w

hen
 
d

riving
 
with
 
snow
 
chains
 
or
 
the
 
spare
 
w

heel
 
fitted.
4
Driving

94
C1_en_Chap04_conduite_ed01-2016
Deactivation
Operating faultDisplays in the instrument panel
The detection may be impeded:
-  i f   the   ground   markings   are   worn,
-
 
i
f   there   is   little   contrast   between   the   markings   on   the   ground   and   the   road   sur face,
-
 
i
f   the   windscreen   is   dirty,
-
 
i
n   certain   extreme   weather   conditions:   fog,   heavy   showers,   bright   sunlight   or   direct  
e

xposure   to   the   sun   (low   sun,   leaving   a   tunnel...)   and   shadows.F
 
P
ress   this   button   again.
The   status   of   the   system   remains   in   the  
m

emory   when   the   ignition   is   switched   off.
In the event of a malfunction, this (orange) w
arning   lamp   comes   on   in   the   instrument   panel.
Contact a CITROËN dealer or a qualified workshop   without   delay.
Display
 
in
 
the
 
instrument
 
panel
Comments
The
 
function
 
has
 
been
 
activated
 
(green
 
indicator).
The
 
system
 
has
 
identified
 
a
 
marking
 
on
 
the
 
ground
 
(green
 
i

ndicator).
The
 
system
 
is
 
alerting
 
you
 
that
 
a
 
road
 
marking
 
is
 
being
 
crossed
 (

green
 
and
 
orange
 
warning).
The
 
display
 
of
 
this
 
warning
 
is
 
accompanied
 
by
 
an
 
audible
 
signal.
Driving

99
C1_en_Chap05_eclairage-visibilite_ed01-2016
Model without AUTO lighting
Model with AUTO lightingSelection ring for main lighting
mode
Turn the ring to position the symbol required f
acing   the   mark.
Lighting
  off   /   Daytime   running   lamps.
Sidelamps
 o

nly.
Dipped
  or   main   beam   headlamps.
Automatic
  illumination   of  
h

eadlamps.
Dipping the headlamps
With dipped beam on, push the control stalk away   from   you   to   change   to   main   beam.   Pull  
t

he   stalk   toward   you   change   back   to   dipped  
b

eam.
In
  the   lighting   off   and   sidelamps   modes,   the  
d

river   can   switch   on   the   main   beam   headlamps  
t

emporarily   ("headlamp   flash")   by   maintaining   a  
p

ull   on   the   stalk.
Displays
Illumination of the corresponding indicator lamp in   the   instrument   panel   confirms   the   lighting  
s

witched   on.
5
Lighting and visibility

111
C1_en_Chap06_securite_ed01-2016
Operation
Three levels of operation are possible:
●  P re-collision alert :
  if   a   risk   of   collision w

ith   a   vehicle   is   detected,   a   warning   lamp
 c

omes   on   in   the   instrument   panel   together
 w

ith   an   audible   signal   to   encourage   the
 d

river   to   make   an   avoiding   manoeuvre.   The
 t

hresholds   for   triggering   the   alert   can   be   set.
●
 
Br
aking assistance :
  increases   the  
b

raking   started   by   the   driver,   only   if   a   risk  
o

f   collision   is   detected.
●
 
A
utomatic pre-collision braking:
  when  
y

our   vehicle   is   too   close   to   or   closing  
t

oo   quickly   on   the   vehicle   ahead   of   you,  
t

he   system   automatically   operates   the  
b

rakes   to   reduce   the   speed   of   impact.   A  
c

ollision   can   be   avoided   automatically   if   the  
d

ifference   in   speed   between   your   vehicle  
a

nd  
t
he  
o
ne  
a
head  
i
s  
n
ot  
m
ore  
t
han  
1
8  
m
ph  
(

30   km/h).You
  are   then   alerted   by   the   display   of  
t

his   warning   lamp,   accompanied   by  
a

n   audible   signal. The
  automatic   braking   may   bring   the   vehicle   to  a
  complete   stop   if   the   situation   requires   it.
The
  brake   lamps   on   your   vehicle   come   on   to  
w

arn   other   road   users. The
  triggering   of   the   system   may   cause  
t

he   engine   to   stall,   unless   the   driver  
d

epresses   the   clutch   pedal   quickly  
e

nough   during   automatic   braking.
6
Safety

112
C1_en_Chap06_securite_ed01-2016
Setting the alert thresholds
Press this button repeatedly to cycle through   the   thresholds.
The
  default   setting   is   "Normal".
The
 
alert
 
thresholds   determine   how   you   want   to   be   warned   of   the   imminent   risk   of   collision   with   the  
v

ehicle
 
ahead   of   you.
You
 
can
 
choose   one   of   three   thresholds:
A.
 "

Far",
  to   be   given   early   warning   (cautious   driving).
B.
 "

Normal".
C.
 "

Close",   for   a   later   warning   (sporty   driving).
Deactivation / Reactivation
Press this button for more than 3 seconds.
P ress   the   button   again   to   reactivate   the   system.
The
  system   is   automatically   reactivated   every  
t

ime   the   engine   is   started   with   the   key   or   the  
"

START/STOP"   button.
This
  indicator   lamp   comes   on   in   the  
in

strument
 pan
el.
This
  indicator   lamp   comes   on   in   the  
i

nstrument   panel   and   the   message  
"

PCS   OFF"   is   displayed.
Safety