185
Non Quadrifoglio Model
The remote jump starting battery posts can be 
found inside the engine compartment.Remote Battery Post Locations
The remote positive  (+) post is located above the 
engine stabilizer bar, which can be accessed by 
opening the spring loaded protective red flap.
Remote Positive (+) Protective Flap Remote Positive (+) Post
The remote negative  (-) post is an exposed stud, 
positioned next to the passenger side hood lock 
on the upper frame rail.
Remote Negative (-) Post Location To carry out the operation, you need to have the 
correct cables to connect to the battery of 
another vehicle or a portable battery booster 
pack to the remote posts of the discharged 
battery. Usually, these cables have terminals at 
the ends and are identified by different sheath 
colors (red = positive, black = negative).
Quadrifoglio Model
Remote Battery Post Locations
Remote Positive 
(+) Post
Remote Negative  (-) Post
 WARNING!
Do not connect the jumper cable to the 
negative  (-) post of the discharged battery. The 
resulting electrical spark could cause the 
battery to explode and could result in serious 
injury. Only use the specific ground point, do 
not use any other exposed metal parts.
Remote Positive  (+) Post
Remote Negative  (-) Post
22_GU_OM_EN_USC_t.book  Page 185   
IN CASE OF EMERGENCY
186
The remote positive (+) post is located next to the 
passenger side hood lock on the inside of the 
upper frame rail, and can be accessed by 
removing the protective red flap.
Remote Positive (+) Protective Flap
Remote Positive (+) Post Location The remote negative 
(-) post is an exposed stud, 
positioned next to the passenger side hood lock 
on the upper frame rail.
Remote Negative (-) Post Location
To carry out the operation, you need to have the 
correct cables to connect to the battery of 
another vehicle or a portable battery booster 
pack to the remote posts of the discharged 
battery. Usually, these cables have terminals at 
the ends and are identified by different sheath 
colors (red = positive, black = negative).JUMP STARTING PROCEDURE
Preparation For Jump Starting:
1. Firmly apply the park brake, and cycle the  ignition to OFF.
2. Turn off all electrical features in the vehicle.
3. If using another vehicle to jump start the battery, park the vehicle within the jumper
cables reach, apply the park brake and make 
sure the ignition is OFF.
 WARNING!
Do not connect the jumper cable to the 
negative  (-) post of the discharged battery. The 
resulting electrical spark could cause the 
battery to explode and could result in serious 
injury. Only use the specific ground point, do 
not use any other exposed metal parts.
 WARNING!
Failure to follow this jump starting procedure 
could result in personal injury or property 
damage due to battery explosion.
 CAUTION!
Failure to follow these procedures could result 
in damage to the charging system of the 
booster vehicle or the discharged vehicle.
 WARNING!
Do not allow vehicles to touch each other as 
this could establish a ground connection and 
personal injury could result.
22_GU_OM_EN_USC_t.book  Page 186