
1003-3. Route guidance
When more than 1 destination
has been set, the arrival order of
the destinations can be
changed.
1Select on the map
screen. (P.72)
2Select “Reorder”.
3Select the desired destina-
tion and select “Move Up” or
“Move Down” to change the
arrival order. Then select
“OK”.
1Select on the map
screen. (P.72)
2Select “Route Type”.
3Select the desired route type.
The entire route from the
starting point to the destina-
tion is displayed. (P.92)
During driving, the route guid-
ance starts after selecting the
desired route type.The conditions to determine the
route can be selected from vari-
ous choices such as freeways,
toll roads, ferries, etc.
1Select on the map
screen. (P. 7 2 )
2Select “Preference”.
3Select the desired route pref-
erences and select “OK”.
●Even if the “Avoid Freeways”
route preference is turned off, the
route may not be able to avoid
freeways in some cases.
●If the calculated route includes a
trip by ferry, the route guidance
shows a sea route. After traveling
by ferry, the current position may
be incorrect. Upon reception of
GPS signals, it is automatically
corrected.
During the route guidance, the
route can be changed to detour
around a section of the route
where a delay is caused by road
repairs, an accident, etc.
1Select on the map
screen. (P. 7 2 )
2Select “Detour”. Reordering destinations
Selecting route type
Setting route preferences
Detour setting

1153-5. Tips for operating the navigation system
3
Navigation system
• When driving on a long straight
road.
• When freeway and surface
streets run in parallel.
• After moving by ferry or vehicle
carrier.
• When a long route is searched
during high speed driving.
• When driving without setting the
current position calibration cor-
rectly.
• After repeating a change of direc-
tion by going forward and back-
ward, or turning on a turntable in
a parking lot.
• When leaving a covered parking
lot or parking garage.
• When a roof carrier is installed.
• When driving with tire chains
installed.
• When the tires are worn.
• After replacing a tire or tires.
• When using tires that are smaller
or larger than the factory specifi-
cations.
• When the tire pressure in any of
the 4 tires is not correct.
If the vehicle cannot receive
GPS signals, the current posi-
tion can be adjusted manu-
ally. For information on setting
the current position calibra-
tion: P. 1 0 8
Inappropriate route guidance
may occur in the following
cases:
• When turning at an intersection
off the designated route guid-
ance.• If you set more than 1 destination
but skip any of them, auto reroute
will display a route returning to
the destination on the previous
route.
• When turning at an intersection
for which there is no route guid-
ance.
• When passing through an inter-
section for which there is no route
guidance.
• During auto reroute, the route
guidance may not be available for
the next turn to the right or left.
• During high speed driving, it may
take a long time for auto reroute
to operate. In auto reroute, a
detour route may be shown.
• After auto reroute, the route may
not be changed.
• If an unnecessary U-turn is
shown or announced.
• If a location has multiple names
and the system announces 1 or
more of them.
• When a route cannot be
searched.
• If the route to your destination
includes gravel, unpaved roads or
alleys, the route guidance may
not be shown.
• Your destination point might be
shown on the opposite side of the
street.
• When a portion of the route has
regulations prohibiting the entry
of the vehicle that vary by time,
season or other reasons.
• The road and map data stored in
the navigation system may not be
complete or may not be the latest

1264-2. Radio operation
Turn to step up/down fre-
quencies/channels.
Turn to move up/down the
station list. Also, the knob
can be used to enter selec-
tions on the list screens by
pressing it.
●The radio automatically changes
to stereo reception when a stereo
broadcast is received.
●The radio automatically blends to
an HD Radio signal in AM or FM
where available.
Radio mode has a mix preset
function, which can store up to
36 stations (6 stations per page
x 6 pages) from any of the AM,
FM or SXM bands.
1Tune in the desired station.
2Select and hold “(Hold Edit)”.
To change the preset station
to a different one, select and
hold the preset station.
●The number of preset radio sta-
tions displayed on the screen can
be changed. (P.144)
*: This function is not made avail-
able in some countries or areas.
AM/FM* and SXM radio program
can be cached and played back
in a time-shifted manner.
*: Premium Audio only
■Automatic playback of the
cache
If the radio broadcast is inter-
rupted by another audio output,
such as an incoming phone call,
the system will automatically
cache the interrupted portion
and perform time-shift playback
when the interruption ends. This
function is available when “Auto
Pause” is set to on. (P.127)
■Playing back the cache
manually
The broadcast cached in the
program cache can be played
back manually.
1Select “SXM Replay”
*1 or
“Radio Replay”
*2.
*1: Audio with SiriusXM® Satellite
Radio
*2: Premium Audio
Presetting a station
B &