Page 20 of 64
18
FEATURES & OPERATIONS
Right turn
Lane change
*
Lane change*
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on the remote is pushed after all doors are locked.
Automatic High Beams (AHB) system Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Owner’s Manual
for more details on the Automatic High Beams feature.
* Operating conditions must be met. Refer to the Owner’s Manual for details.
Type AType B
HEADLIGHTS
Parking lights
Low beam (Original position)
High beam (Push)
Automatic High beams*or Auto Headlights
DRL OFFParking lights
DRL ONHeadlights
OFF
High beam flasher
(Pull)
TURN SIGNALS
* Move lever partway and release. The signals will flash three times.
Page 21 of 64
19
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Windshield wipers & washers
Front fog lights come on only when the headlights are on low beam.
Turn OFFON
FRONT
* Intermittent windshield wiper
frequency adjustment Rotate to
increase/decrease wiper frequency.* Rain-sensing windshield wiper Rotate
to increase/decrease sensor sensitivity. Intermittent (if equipped)
Adjust frequency* Adjust frequency*
Interval wipeAuto
Slow Slow
FastFast
Pull to wash
and wipePull to wash
and wipe Off Off
Rain-sensing (if equipped)
REAR
On
Interval wipe
Off
Push to wash and wipe
' 0 ( - * ( ) 5 4 * ' & 2 6 * 1 1 & %
Cup holders
Mist and single wipeMist and single wipe
FRONT
REAR
Page 52 of 64
50
TOYOTA SAFETY SENSE™
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of the following conditions are met, the high beams will be automatically
U V S O F E P O B G U F S B Q Q S P Y J N B U F M Z T F D P O E
t 7 F I J D M F T Q F F E J T B C P W F B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights
turned on.
• There are few streetlights on the road ahead.
If any of the following conditions occur, the high beams will be automatically turned off:
t 7 F I J D M F T Q F F E E S P Q T C F M P X B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights turned on.
• There are many streetlights on the road ahead. 5 I F " V U P N B U J D ) J H I # F B N T " ) #
T B G F U Z T Z T U F N J T E F T J H O F E U P I F M Q Z P V T F F
more clearly at night. At speeds above 25 mph, AHB can detect the headlights of
oncoming vehicles and taillights of preceding vehicles, then automatically toggles
between high and low beams accordingly.
See Toyota.com/safety-sense for more information.
Refer to the Toyota Owner’s Manual for a list of additional situations in which the
system operation may be limited.
(2) (1)
1 S F T T U I F i
” switch.
1 V T I U I F M F W F S B X B Z G S P N Z P V X J U I U I F I F B E M J H I U T X J U D I J T J O U I F i
” or
“AUTO” position.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Pull the lever back toward you or press the AHB switch to turn the AHB
system off.
The AHB indicator will turn off and “
” or “” will turn on. To activate the
system again, push the lever its original position or press the “
” switch.
