Page 469 of 632
469
LC200_OM_OM60T03U_(U)
6-3. Do-it-yourself maintenance
6
Maintenance and care
Engine compartment
Power steering fluid reservoir( P. 477)
Engine oil level dipstick ( P. 471)
Engine coolant reservoir ( P. 474)
Cooling fans ( P. 475)
Engine oil filler cap ( P. 472) Brake fluid reservoir
( P. 475)
Fuse box ( P. 501)
Washer fluid tank ( P. 481)
Battery ( P. 478)
Condenser ( P. 475)
Radiator ( P. 475)1
2
3
4
5
6
7
8
9
10
11 
     
        
        Page 471 of 632
LC200_OM_OM60T03U_(U)
4716-3. Do-it-yourself maintenance
6
Maintenance and care
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■Checking the engine oil
Park  the  vehicle  on  level  ground.  After  warming  up  the  engine
and  turning  it  off,  wait  more  than  5  minutes  for  the  oil  to  dra in
back into the bottom of the engine.
Holding  a  rag  under  the  end,
pull the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding  a  rag  under  the  end,  pull  the  dipstick  out  and  check  th e
oil level.
Low
Normal
Excessive
The shape of the dipstick may
differ  depending  on  the  type
of vehicle or engine.
Wipe the dipstick and reinsert it fully.
Engine oil
1
2
3
4
5
1
2
3
6 
     
        
        Page 472 of 632

472
LC200_OM_OM60T03U_(U)
6-3. Do-it-yourself maintenance
■Adding engine oil
If  the  oil  level  is  below  or  near
the  low  level  mark,  add  engine
oil  of  the  same  type  as  already
in the engine.
Make  sure  to  check  the  oil  type  and  prepare  the  items  needed
before adding oil.Remove the oil fille r cap by turning it counterclockwise.
Add engine oil slowly,  checking the dipstick.
Install the oil filler cap  by turning it clockwise.
■Engine oil consumption
A certain amount of engine oil will be consumed while driving.  In the following
situations,  oil  consumption  may  increase,  and  engine  oil  may  ne ed  to  be
refilled in between oil maintenance intervals.
● When the engine is new, for example directly after purchasing t he vehicle or
after replacing the engine
● If low quality oil or oil of an inappropriate viscosity is used  
● When  driving  at  high  engine  speeds  or  with  a  heavy  load,  when  t owing,  or
when driving while accelerating or decelerating frequently
● When  leaving  the  engine  idling  for  a  long  time,  or  when  driving   frequently
through heavy traffic
Engine oil selectionP. 574
Oil quantity (Low  Full)1.6 qt. (1.5 L, 1.3 Imp.qt.)
ItemsClean funnel
1
2
3 
     
        
        Page 473 of 632

LC200_OM_OM60T03U_(U)
4736-3. Do-it-yourself maintenance
6
Maintenance and care
■After changing the engine oil
The engine oil maintenance data should be reset. Perform the fo llowing pro-
cedures:
Press   or   of the meter control switches, select  .
Press    or    of  the  meter  control  switches,  select  “Oil  Maintenan ce”
and then press  .
Select the “Yes” and press  .
A message is displayed on the multi-information display.
WARNING
■ Used engine oil
● Used  engine  oil  contains  potentially  harmful  contaminants  which  may
cause skin disorders such as inflammation or skin cancer, so ca re should
be taken to avoid prolonged and repeated contact. To remove used engine
oil from your skin, wash thoroughly with soap and water.
● Dispose  of  used  oil  and  filters  only  in  a  safe  and  acceptable  manner.  Do
not dispose of used oil and filters in household trash, in sewe rs or onto the
ground.  Call  your  Toyota  dealer,  service  station  or  auto  parts  store  for
information concerning recycling or disposal.
● Do not leave used engine oil within the reach of children.
NOTICE
■To prevent serious engine damage
Check the oil level on regular basis.
■ When replacing the engine oil
● Be careful not to spill engine oil on the vehicle components.
● Avoid overfilling, or the engine could be damaged.
● Check the oil level on the dipstick every time you refill the v ehicle.
● Be sure the engine oil filler cap is properly tightened.
1
2
3
4 
     
        
        Page 574 of 632
574
LC200_OM_OM60T03U_(U)
8-1. Specifications
*: The engine oil  capacity is a reference  quantity to be  used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
Engine
Model5.7L V8 (3UR-FE)
Ty p e8-cylinder V type, 4-cycle, gasoline
Bore and stroke3.70   4.02 in. (94.0   102.0 mm)
Displacement345.6 cu.in. (5663 cm3)
Valve clearanceAutomatic adjustment
Drive belt tensionAutomatic adjustment
Fuel
Fuel typeUnleaded gasoline only
Octane rating87 (Research octane number 91) or higher
Fuel tank capacity
(Reference)24.5 gal. (93 L, 20.4 Imp.gal)
Lubrication system
Oil capacity
(Drain  and  refill  —  refer-
ence
*)
With filter
Without filter8.5 qt. (8.0 L, 7.0 Imp.qt.)
7.9 qt. (7.5 L, 6.6 Imp.qt.)