Page 7 of 56

5
Security indicator
Smart Key system indicator
SPORT mode indicator4
Turn signal indicator
Vehicle Stability Control (VSC) OFF
indicator1
Rear passengers’ seat belt reminder
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
For details, refer to “Warning lights and indicators,” Section 2-1, 2\
021 Owner’s
Manual.
Airbag SRS warning1
iMT indicator (orange/green)1,4
Low fuel level warning
Low engine oil pressure warning
Low outside temperature indicator
Low tire pressure warning1
Malfunction/Check engine indicator1
Parking brake indicator2
Pre-Collision System (PCS) warning1,2
Lane Tracing Assist (LTA)4/
Lane Departure Alert (LDA) indicator
(white/green/orange
3)
High coolant temperature warning
Auto EPB OFF indicator1,4
Automatic High Beam (AHB) indicator
Blind Spot Monitor (BSM) indicator4
BSM outside rear view mirror indicators1,4
Brake hold operated indicator1,2
Brake hold standby indicator1
Brake system warning1
Brake system warning (yellow)1
Charging system warning1
ECO driving indicator light1,4
Driver’s and front passenger’s seat belt
reminder (alarm will sound when the engine
switch is in the “IGNITION ON” mode)
Electric power steering system warning
(red/yellow)1
Front fog light indicator4
Fuel tank door position
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
Full-Speed Dynamic Radar
Cruise Control (DRCC) indicator/
DRCC SET indicator
Headlight low/high beam
indicators
Brake Override System/Drive-Start
Control warning
1 If the indicator does not turn off within a few seconds of starting the en\
gine, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owne\
r’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.
Anti-lock Brake System (ABS) warning1
“AIR BAG ON/OFF” indicator1
Slip indicator1,3
RCTA OFF indicator1,2,4
Indicator symbols
Page 11 of 56
9
P
R
N
D
M
Park*
Reverse
Neutral
Drive
“M” mode
FEATURES & OPERATIONS
* The engine switch must be “IGNITION ON” mode and the brake pedal \
depressed to shift from Park.
Push shift lever to the left from “D” position, to “M” position.\
Downshifting increases power going uphill, or provides engine braking downhill. For
best fuel economy during normal driving conditions, always drive with the sh\
ift lever in
the “D” position.
“M” 10-SPEED SPORT SEQUENTIAL SHIFTMATIC MODE
Continuously variable transmission (if equipped)
Lift up ring to shift into reverse
Manual transmission (if equipped)
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES+ (“M” mode)
Shift lever
Paddle shifters*
*If equipped
- (“M” mode)
- (“M” mode)
+ (“M” mode)
Shift lever type:
+ : Upshift (push and release)
- : Downshift (pull and release) Paddle shifters type (if equipped):
+ : Upshift (pull and release)
- : Downshift (pull and release)
Page 20 of 56
18
Audio
FEATURES & OPERATIONS
NOTE: Always use safe driving practices and follow all traffic rules.
Refer to the “Navigation and Multimedia System Owner’s Manual” or vi\
sit www.
toyota.com/audio-multimedia for additional resources.
Touch screen display
Access
AUDIO screen
Push to turn ON/OFF or
turn to adjust volume Turn to tune radio stations
manually or select tracks or filesAccess
Bluetooth
hands-free system
Seek station/
track/file
select
Access
HOME screen
Access
MENU screen
Access
apps screen
Access
MAP screen
USB charge port
(Charge-only)
The engine switch must be in the “ACCESSORY” or “IGNITION ON” m\
ode for use.
Page 21 of 56

19
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Qi Wireless charger (if equipped)
A mobile device can be charged wirelessly on the tray. (1) Press the wireless
charger power switch and the green operation indicator light turns on. (2) Place
a compatible mobile device on the tray as shown in the illustration. An a\
mber
indicator illuminates while charging is in progress. When charging is complete, t\
he
indicator illuminates green. Some phones, cases or cover type wireless chargers
may not cause the green indicator to illuminate even though it is fully cha\
rged.
Refer to the Owner‘s Manual for limitations and more details on this syste\
m before
attempting to use it.
Power switch
Charge area
Operation indicator light
Press (1)
When the engine is turned off, the last state (ON/
OFF) of the charger is memorized.
Place device nearest the center of charging area for
best results. Moving device may result in stopping
or restarting the charging process.
Place (2)
Power outlet-12V DC
The engine switch must be in the “ACCESSORY” or “IGNITION ON” m\
ode for use.
Page 22 of 56
20
FEATURES & OPERATIONSUSB media port
Connecting a compatible device and cable into the USB media port will support
charging and music playback through the audio multimedia system.
Seat heaters (if equipped)
The engine switch must be in the “IGNITION ON” mode for use.
Page 29 of 56

27
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
CHANGING PCS ALERT TIMING
DISABLING PRE-COLLISION SYSTEM (PCS)
Far Middle
(default) Near
(1) Press “” switches and select “” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ (PCS)” and then press “.” The setting
screen is displayed.
(3) Press “
” switches and select “Adjust alert timing” and then press “” to
select the desired setting. Each time it is pressed, the response to the PCS a\
lert
timing changes as shown above.
(4) Press “
” to go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
(1) Press “
” switches and select “” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ (PCS)” and then press “.” The setting
screen is displayed.
(3) Press “
” switches and select “PCS” and then press “” to select the desired
setting.
(4) Press “
” to go back to the menu.
Note: The system is enabled each time the power switch is turned to ON mode.
Refer to the Toyota Owner’s Manual for additional information on PCS opera\
tion,
settings adjustments, limitations, and precautions before attempting to use it.
Page 30 of 56

28
TOYOTA SAFETY SENSE™
LDA in TSS 2.0 uses a forward-facing camera designed to detect visible white and
yellow lane markers or road edge in front of the vehicle and the vehicle’s \
position
on the road. If the system determines that the vehicle is starting to unin\
tentionally
deviate from its lane, the system alerts the driver with an audio and visual al\
ert.
When the alerts occur, the driver must check the surrounding road situation \
and
carefully operate the steering wheel to move the vehicle back to the center part \
of
their lane.
LDA is designed to function at speeds of approximately 32 mph (50 km/h) or higher
on relatively straight roadways.
In addition to the alert function, LDA w/SA also features a steering assis\
t
function. When enabled, if the system determines that the vehicle is on a path to\
unintentionally depart from its lane, the system may provide small corrective steering
inputs to the steering wheel for a short period of time to help keep the vehic\
le in its
lane.
If the vehicle repeatedly deviates from the lane, the vehicle drifts withi\
n the lane due
to inattention, or the driver abruptly operates the steering wheel after a\
n inattentive
period, when enabled, the vehicle sway warning function alerts the driver with \
an
audio and visual alert, urging them to take a break.
Lane Departure Alert with Steering Assist
(LDA w/SA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it off.\
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LDA opera\
tion,
settings adjustments, limitations, and precautions before attempting to use it.
Page 32 of 56

30
ADJUSTING LDA ALERT SENSITIVITY
DISABLING STEERING ASSIST
The driver can adjust the sensitivity of the LDA (warning) function from \
the
Multi-Information Display (MID) customization screen.High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
TOYOTA SAFETY SENSE™
SWAY WARNING SYSTEM
SWS is a function of LDA and is designed to detect swaying based on the veh\
icle
location in the lane and the driver’s steering wheel operation. To help preve\
nt
swaying, the system alerts the driver using a buzzer sound and a warning display\
s
in the MID.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
(1) Press “” switches and select “” from the Multi-Information Display (MID).
(2) Press “
” switches and select the “ (LDA)” and then press “.” The
setting screen is displayed.
(3) Press “
” switches and select the “Alert sensitivity” and then press “” to
select the desired setting.
(4) Press “
” to go back to the menu.
(1) Press “
”
switches and select “” from the Multi-Information Display (MID).
(2) Press “
” switches and select the “ (LDA)” and then press “.” The
setting screen is displayed.
(3) Press “
” switches and select the “Steering assist function” and then press\
“”
to select the desired setting.
(4) Press “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.