2021 SUZUKI JIMNY belt

FOR SAFE DRIVING
A seat belt helps keep you in the proper po_sition for maximum protection when an airbag infiates. Adjust your seat as far back as possible while still maintaining control of the vehicle. Sit fully back in your seat; sit up straight; do not lean over the steering wheel or dashboard. Front occu­pants should not lean on or sleep against the door. Refer to "Seat adjustment" sec­tion and "Seat belts and child restraint sys­tems" section in this section for details on proper seat and seat belt adjustments.
1-45
A WARNING
• The driver should not lean over the steering wheel. The front passen­ger should not rest his or her body against the dashboard, or other­wise get too close to the dash­board. For vehicles with side airbags and side curtain airbag, occupants should not lean on or sleep against the door. In these sit­uations, the out-of-position occu­pant would be too close to an inflating airbag, and may suffer severe injury. • Do not attach any objects to, or place any objects over, the steering wheel or dashboard. Do not place any objects between the airbag and the driver or front passenger. These objects may interfere with airbag operation or may be pro­pelled by the airbag in the event of a collision. Also, these objects may move when you start moving vehi­cle or while vehicle is moving, they may interfere with driver's view or safe driving. In each conditions may cause severe injury. (Continued)

A WARNING
(Continued) For vehicles with side airbags, do not use non-genuine seat covers on the front seats, because non­genuine seat covers may obstruct the inflation of side airbags. Suzuki highly recommends Suzuki-genu­ine seat covers to be used when covering the front seats of such vehicles with side airbags. Also, near the door, do not place cup holders, hangers or any other objects and do not lean an umbrella, as these objects could be propelled by the airbag in the event of a collision. Either of these condi­tions may cause severe injury. Do not strike or apply significant levels of impact to the airbag com­ponent areas. It can cause the air­bags to malfunction.
Even though your vehicle is moderately damaged by a collision, it may not be severe enough to trigger front, side or side curtain airbags to inflate. If your vehicle sustains any front-end or side damage, have the airbag system inspected by a SUZUKI dealer to ensure that ii works properly.
Your vehicle is equipped with a diagnostic module which records information about the airbag system if the airbags deploy in a collision. The module records information about overall system status, and which sensors activated the deployment, and for a certain vehicle only, whether the driver's seat belt was in use.
Servicing the airbag system If the airbags inflate, have the airbags and related components replaced by a SUZUKI dealer as soon as possible.
If your vehicle ever gets in deep water and the driver's floor is submerged, the airbag controller could be damaged. If this hap­pens, ask a SUZUKI dealer to check the airbag system as soon as possible.
FOR SAFE DRIVING
Special procedures are required for servic­ing or replacing an airbag. For that reason, only a SUZUKI dealer should be allowed to service or replace your airbags. Remind anyone who services your SUZUKI vehicle that it has airbags.
Service on or around airbag components or wiring must be performed only by a SUZUKI dealer. Improper service could result in unintended airbag deployment or could render the airbag inoperative. Either of these two conditions may result in severe injury.
To prevent damage or unintended inflation of the airbag system, check that the lead­acid battery is disconnected and the igni­tion switch has been in "LOCK" position for at least 90 seconds before performing any electrical service work on your SUZUKI vehicle. Do not touch airbag system com­ponents or wires. The wires are wrapped with yellow tape or yellow tubing, and the couplers are yellow for easy identification.
Scrapping a vehicle that has an uninflated airbag can be hazardous. Ask a SUZUKI dealer, body repair shop or scrap yard for help with disposal.
1-46

FOR SAFE DRIVING
Front passenger airbag deactiva­
tion system (if equipped)
(2)
78RB02027
The front passenger's front airbag system must be deactivated if a child restraint sys­tem is to be installed on the front passen­ger's seat. When the ignition switch is turned to "ON" position, "PASSENGER AIRBAG ON" indi­cator (1) or "PASSENGER AIRBAG OFF" indicator (2) shows whether the front pas­senger's airbag system is activated or deactivated.
1-47
When the front passenger's airbag system is activated, both "PASSENGER AIRBAG ON" indicator (1) and "PASSENGER AIR­BAG OFF" indicator (2) come on for a few seconds and then go out. After that, only "PASSENGER AIRBAG ON" indicator (1) comes on for about 1 minute and then goes out.
When the front passenger's airbag system is deactivated, both "PASSENGER AIR­BAG ON" indicator (1) and "PASSENGER AIRBAG OFF" indicator (2) come on for a few seconds and then go out. After that, only "PASSENGER AIRBAG OFF" indicator (2) comes on.
When you activate or deactivate the front passenger's airbag system, check which indicator is on before starting the engine.
Side airbags, side curtain airbags and seat belt pretensioners are not connected to the airbag deactivation system. Even if the front passenger's airbag system is deacti­vated, side airbags, side curtain airbags and seat belt pretensioners are still acti­vated.
58MS030
.A WARNING
When using child restraint system on the front passenger's seat, the front passenger's airbag system must be deactivated; otherwise deployment of the front passenger's airbag could result in the death or serious injury of the child.
.A WARNING
Check that the front passenger's air­bag system is activated and "PAS­SENGER AIRBAG ON" indicator (1) is on whenever there is no child restraint installed on the front pas­senger's seat.

Information display
Information display is shown when the igni­tion switch is turned to "ON" position.
,□
~
~ 160
(1) t=
(1) Trip meter selector knob (2) Indicator selector knob
(2)
78RB02032
~ I (A) (B) 0
= (C)
~
(D)
(E)
(F)
(3) Information display
~(3)
BEFORE DRIVING
The information display shows the follow­ing information.
Display (A) Temperature
Display (B) Clock
Display (C) Speed limiter (if equipped)
Display (D) . Selector position (for Automatic transmis­sion vehicles) I Gearshift indicator (if equipped) I Rear passenger's seat belt 1asso20,a reminder (if equipped)
Display (E) Trip meter I Odometer I Fuel consumption I Driving range
Display (F) Fuel gauge
2-18

BEFORE DRIVING
Clock
The display (B) shows the time.
To change the lime indication: 1) Push the trip meter selector knob (1) and the indicator selector knob (2) together. 2) To change the hour indication, turn _the indicator selector knob (2) left or nght repeatedly when the hour indication · blinks. To change the hour indication quickly, turn and hold the indicator selector knob (2). To set the hour indi­cation, push the indicator selector knob (2) and the minute indication will blink. 3) To change the minute indication, turn the indicator selector knob (2) left or right repeatedly when the minute indi­cation blinks. To change the minute indication quickly, turn and hold the indicator selector knob (2). To set the minute indication, push the indicator selector knob (2).
To select 12124H format, refer to "Setting mode"-in this section.
A WARNING
If you attempt to adjust the display while driving, you could lose control of the vehicle. Do not attempt to adjust the display while driving.
2-19
Thermometer
The display (A) shows the thermometer. The thermometer indicates the outside temperature.
, ,:la)
Cocl#}
78RB02089
If the outside temperature drops to freez­ing condition, the mark (a) will appear on the display.
NOTE: The outside temperature indication is not the actual outside temperature when driving at low speed, or when stopped. If there is something wrong with the ther­mometer, or just after the ignition switch is tumed to "ON" position, the display may not indicate the outside tempera­ture.
When the display (E) shows the driving range, you can change the unit of tem­perature. To change the unit of temperature, while pushing and holding the trip meter selector knob (1 ), turn the indicator selector knob (2).
-----------
2 5 oc (Initial setting)
78RB02092
Selector position (for Automatic
transmission vehicles)/ Gearshift
indicator (if equipped)/ Rear pas­
senger's seat belt reminder (if equipped)
I EXAMPLE
□ 52RM21360

Selector position (for Automatic trans­mission vehicles) When the ignition switch is turned "ON"; the display (D) indicates the gear position. For details on how to use the transmission, refer to "Using transmission" in "OPERAT­ING YOUR VEHICLE" section.
Gearshifl indicator (if equipped) Refer to "Gearshift indicator" in "OPERAT­ING YOUR VEHICLE" section.
Rear passenger's seat belt reminder (if equipped) Refer to "Seat belts and child restraint sys­tems" in the "BEFORE DRIVING" section for details.
Trip meter/ Odometer/ Fuel con­
sumption / Driving range
The display (E) shows one of the following indications; trip meter A, trip meter B, odometer, instantaneous fuel consump­tion, average fuel consumption or driving range. To switch the display indication (E), push the trip meter selector knob (1) or the indi­cator selector knob (2) quickly.
,-------------------------~ I (.,{1 t
(b)
Ill (c)
1,,-,,-,
1CC1 u:1km
,!}
.--,., Cl U_lkm
,!}
(d) 1-1-1111 , :1,:1ci1-1km __________ i} _-0, __________ ,
(e)
(f)
I 11:, I U_lkm/L
,!}
AVG. 1,,-
1c.:1km/L
,!}
RANGE ' (g) ,,-11 I C =f1-fkm 1 _________________________ _
78RB02034
BEFORE DRIVING
D--0-Push the trip meter knob (1 ).
D--0-Push the knob (2).
(b) Trip meter A (c) Trip meter B (d) Odometer
indicator
selector
selector
(e) Instantaneous fuel consumption (f) Average fuel consumption (g) Driving range
A WARNING
If you attempt to adjust the display while driving, you could lose control of the vehicle. Do not attempt to adjust the display while driving.
NOTE: Indications will change when you push and release a knob. The display shows estimated values. Indications may not be the same as actual values.
2-20

BEFORE DRIVING
Display (E) Trip meter I Rear passenger's seat belt reminder (if equipped)
Display (F) Odometer
Display (G) Fuel gauge
52RS20420
When the ignition switch is turned "ON", the message shown in the above illustra­tion will appear on the display for several seconds. Some warning and indicator messages may appear on the display when the igni­tion switch is in "ACC" or "LOCK".
2-29
Clock
When the ignition switch is in "ON", the dis­
play (A) shows the time.
To set the clock, follow "Setting mode" instructions in this section.
,A WARNING
If you attempt to adjust the display while driving, you could lose control of the vehicle. Do not attempt to adjust the display while driving.
Thermometer
When the ignition switch is "ON", the dis­play (B) shows the thermometer. The thermometer indicates the outside temperature.
-3°c
78RB02040
If the outside temperature nears freezing condition, the mark (a) will appear on the display.
NOTE: The outside temperature indication is not the actual outside temperature when driving at low speed, or when stopped. If there is something wrong with the ther­mometer, or just after the ignition switch is turned "ON", the display may not indi­cate the outside temperature.
When the display (C) shows the driving range, you can change the unit of tem­perature. To change the unit of temperature, refer to "Setting mode" in this section.
25°(
77 °F
(Initial setting)
52RM20880

Oil pressure light
50G051
When the ignition switch is turned "ON", this light comes on. When the engine is started, the light goes out. The light will come on and remain on if there is insuffi­cient oil pressure. If the light comes on when driving, pull off the road as soon as you can and stop the engine. Check the oil level and add oil if necessary. If there is enough oil, the lubrication sys­tem should be inspected by a SUZUKI dealer before you drive the vehicle again.
NOTICE
If you operate the engine with this light on, severe engine damage can result. Do not rely on the oil pressure light to indicate the need to add oil. Peri­odically check the engine oil level.
Charging light
50G052
When the ignition switch is turned "ON", this light comes on. When the engine is started, the light goes out. The light will come on and remain on if there is some­thing wrong with the battery charging sys­tem. If the light comes on when the engine is running, the charging system should be inspected immediately by a SUZUKI dealer.
BEFORE DRIVING
Driver's seat belt reminder light/ Front passenger's seat belt
reminder light (if equipped)
60G049
When the driver or front passenger does not buckle his or her seat belt, this light will come on and/or blink. For details of the seat belt reminder, refer to "Seat belts and child restraint systems" in this section.
2-44