2021 MERCEDES-BENZ E-CLASS CABRIOLET warning

SoT
SoT
t
t op
op Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
K
While stationary, apply the
brake before operating the
soft top *T
hevehicle is stationary and you try toopen or close the soT top. #
Depress the brake pedal. #
Operate the soT top operation again until the soT top opens or closes comple tely.
K
Soft top Operation only up
to 60 km/h *I
fyo u drive at speeds greater than 60 km/h you cannot open or close the soT top. #
Do not drive at speeds greater than 60 km/h. #
Fully open or close the soT top.
K
Soft top lowering *T
he soT top is not fully opened or closed. The hydraulics are depressuring. #
Fully open or close the soT top. Display messages and
warning/indicator lamps
377 377

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
K
Open/close soft top com-
pletely *T
he soT top is not loc ked. If you drive at speeds greater than 60 km/h you cannot open or close the soT top. #
Do not drive at speeds greater than 60 km/h. #
Fully open or close the soT top.
K
12 V battery See Owner's
Manual *T
he on-board elect rical system voltage is too lo w. #
Start theve hicle.
J
Close boot separator *T
he boot separator is open. #
Close the boot separator. 378 378
Display messages and
warning/indicator lamps

Lights
Lights
Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/conseq uences and
uences andM
MSolutions
Solutions
:
Left dipped beam (examp le) *T
he cor responding light source is defecti ve. #
Drive on carefull y. #
Consult a quali/ed specialist workshop immediatel y.
% LED light sources: the display message forth e cor responding light appears only when all the light-emitting diodes
in the light are faulty.
: Malfunction See Owner's
Manual *T
heexterior lighting is malfunctioning. #
Consult a quali/ed specialist workshop.
*V Vehicles wit ehicles wit h a tr
h a trailer hitc
ailer hitc h:
h:a fuse may ha veblown. #
Stop theve hicle in accordance with the tra1c conditions. #
Check the fuses and replace them if necessary (/ page 332).
:
Automatic driving lights
inoperative *T
he light sensor for automatic driving lights is malfunctioning. #
Consult a quali/ed specialist workshop. Displ
aymessages and warning/indicator lamps
379
379

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
:
Active Light System inoper-
ative *T
he active headlamps are malfunctioning. #
Consult a quali/ed specialist workshop.
:
Switch on headlamps *Y
ou are driving without lo w-beam headlamps. #
Turn the light switch totheL orà position.
:
Switch off lights *Y
ou are leaving theve hicle and the lights are still switched on. #
Turn the light switch totheà position.
:
Intelligent Light System
inoperative *T
he Intelli gent Light System is malfunctioning. The lighting system continues tofunction proper lywithout the functions
of the Intelligent Light System. #
Consult a quali/ed specialist workshop. 380 380
Displ
aymessages and warning/indicator lamps

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
Adaptive Highbeam Assist
currently unavailable See
Owner's Manual *A
daptive Highbeam Assist is tempo rarilyuna vailable.
The system limits ha vebeen reached (/ page 130).
Once the cause of the problem is no longer present, the system will be available again. The Adaptive Highbeam
Assist available again displaymessage will appear. #
Drive on #
Operate the high beam manually until Adaptive High Beam Assist is available again.
Adaptive Highbeam Assist
inoperative *A
daptive Highbeam Assist is malfunctioning. #
Drive on
or #
Stop theve hicle in accordance with the tra1c conditions and restart theve hicle. #
Ifth e display message does not disappear: consult a quali/ed specialist workshop. #
Until then, operate the high beam manuall y.
Adaptive Highbeam Assist
Plus currently unavailable
See Owner's Manual *A
daptive Highbeam Assist Plus is tempo rarilyuna vailable.
The system limits ha vebeen reached (/ page 131).
Once the cause of the problem is no longer present, the system will be available again. The Adaptive Highbeam
Assist Plus available again displaymessage will appear. #
Drive on #
Operate the high beam manually until Adaptive High Beam Assist Plus is available again. Displ
aymessages and warning/indicator lamps
381
381

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
Adaptive Highbeam Assist
Plus inoperative *A
daptive Highbeam Assist Plus is malfunctioning. #
Drive on
or #
Stop theve hicle in accordance with the tra1c conditions and restart theve hicle. #
Ifth e display message does not disappear: consult a quali/ed specialist workshop. #
Until then, operate the high beam manuall y.
Hazard warning lamps mal-
functioning *T
he hazard warning lamp switch is malfunctioning. #
Consult a quali/ed specialist workshop. Climat Climat
e contr
e contr ol
ol Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/conseq uences and
uences andM
MSolutions
Solutions
&
inoperative See Owner's
Man. *T
he stationary heater is temp orarily malfunctioning. #
When theve hicle is stationary on a le vel sur face and the engine has cooled down, make up tofour attem ptsto
switch on the stationary heater, waiting se veral minutes between each attem pt. #
Ifth e stationary heater does not switch on, consult a quali/ed specialist workshop. 382 382
Displ
aymessages and warning/indicator lamps

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
&
inoperative Battery low *T
he on-board elect rical system voltage is too lo w.
The stationa ryheater has switched itself o.. #
Drive an extended distance until the battery has reached a su1cient charge leve l again.
&
inoperative Refuel vehicle *T
here is too little fuel in the fuel tank. The stationary hea ter cannot be switched on. #
Refuel theve hicle. V
V
ehicle
ehicle Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/conseq uences and
uences andM
MSolutions
Solutions
d
Vehicle is operational
Switch off ignition before
exiting *Y
ou are leaving theve hicle in a ready-to-drive state. #
Get out of theve hicle, secure it against rolling away and take theke y with you. #
Ifyo u do not lea vetheve hicle, switch o. the electrical consumers, e.g. the seat heating. Otherwise, the 12‑V bat-
te ry may dischar geand starting the engine may be possible only with the help of a second battery (jump start). Display messages and
warning/indicator lamps
383 383

Displa
Displa
y messag
y messag es P
es Possible causes/conseq
ossible causes/consequences and uences andM
MSolutions
Solutions
ï
Check trailer hitch
lock (white display message) *T
he trailer hitch is not operational during a jou rney with a trailer. &
W WARNING
ARNING Risk of an accident if the ball neck is not loc ked
The trailer may become de tach ed. #
Stop theve hicle immediately in accordance with the tra1c conditions. Do not continue driving. #
Uncouple the trailer and secure it against rolling away. #
Initiate a new swivel mo vement and do not re-couple the trailer until thewa rning/indicator lamp goes out. #
Initiate a new swivel mo vement (/ page 240). #
When the display message disappears, couple up the trailer and drive on.
If th e display message does not disappear, the trailer hitch is malfunctioning and the ball neck is not loc ked. #
Do not couple up the trailer. Drive on without the trailer. No tethere duced ground clearance due tothe unloc ked
ball nec k. #
Consult a quali/ed specialist workshop.
*W hen theve hicle is stationary with a coupled trailer, the trailer hitch is not operational. #
Uncouple the coupled trailer and secure it against rolling away. #
If t
If t he ball nec
he ball nec k has been f
k has been f olded in:
olded in:unlockthe ball neck (/ page 240). #
Swivel the ball neck into the end position manually and let it engage. #
If t
If t he ball nec
he ball nec k has been f
k has been f olded out
olded out::unlock the ball neck (/ page 240).384
384
Display messages and
warning/indicator lamps