
822-1. Instrument cluster
LC500
LC500h
The units used on the meters may diff er depending on the target region.
Engine oil temperature gauge/Eco Driving Indicator (LC500)
Displays the engine oil temperat ure or Eco Driving Indicator (P.80)
Outside temperature
Gauges and meters
When the main meter is in the side posi tion, some of the meter displays and the 
gauge layout will be changed.
Meter display
A
B 

852-1. Instrument cluster
2
Vehicle status information and indicators
■Liquid crystal display
Small spots or light spots may appear on the 
display. This phenomenon is characteristic 
of liquid crystal displays, and there is no 
problem continuing to use the display.
■Customization
The meter display can be customized on 
the multi-information display. ( P.405)
The odometer and trip meter displays 
can be switched. When the trip meter 
is displayed, pressing and holding the 
button will reset the trip meter. The brightness of the instrument panel 
lights can be adjusted.
1
Darker
2 Brighter
■Instrument panel brightness adjustment
The instrument panel  brightness levels 
when the tail lights are on and off can be 
adjusted individually. However, when the 
surroundings are bright (daytime, etc.), 
turning on the tail lights will not change the 
instrument pa nel brightness.
The display can be switched between 
the center and side positions.
NOTICE
■To prevent damage to the engine and 
its components
●Do not let the indicator of the tachom-
eter enter the red zone, as it rep-
resents the engine speed range which 
exceeds the maximum safe engine 
speed.
●In the following situations, the engine 
may be overheating. In this case, 
immediately stop the vehicle in a safe 
place, and check the engine after it has 
cooled completely. ( P.376, 379)
• The engine coolant temperature  gauge is in the red zone (H).
• LC500: The engine oil temperature  gauge is in the red zone (H).
Changing between the odome-
ter and trip meter
Changing the Instrument panel 
light brightness
Changing the display 

1484-1. Before driving
Cargo capacity depends on the total 
weight of the occupants.
(Cargo capacity) = (Total load capac-
ity)  (Total weight of occupants)
NOTICE
●The vehicle will make abnormal 
sounds or vibrations.
●The vehicle will lean abnormally.
Information on what to do in case of a flat 
tire ( P.362)
■When encountering flooded roads
Do not drive on a road that has flooded 
after heavy rain etc. Doing so may cause 
the following serious damage to the vehi-
cle:
●Engine stalling
●Short in electrical components
●Engine damage caused by water 
immersion
In the event that you drive on a flooded 
road and the vehicle is flooded, be sure 
to have your Lexus dealer check the fol-
lowing:
●Brake function
●Changes in quantity and quality of oil 
and fluid used for the engine, transmis-
sion, differential, etc.
●Lubricant condition for the propeller 
shaft, bearings and suspension joints 
(where possible), and the function of 
all joints, bearings, etc.
If the shift control system is damaged by 
flooding, it may not  be possible to shift 
the shift position to P, or from P to other 
positions. In this case, contact your Lexus 
dealer.
■When parking the vehicle
Always set the parking brake, and shift 
the shift position to P. Failure to do so 
may cause the vehicle to move or the 
vehicle may accelerate suddenly if the 
accelerator pedal is accidentally 
depressed.
Cargo and luggage
Take notice of the following infor-
mation about storage precautions, 
cargo capacity and load:
WARNING
■Things that must not be carried in the 
trunk
The following things may cause a fire if 
loaded in the trunk:
●Receptacles containing gasoline
●Aerosol cans
■Storage precautions
Observe the following precautions. 
Failure to do so may prevent the pedals 
from being depressed properly, may 
block the driver’s vision, or may result in 
items hitting the driver or passengers, 
possibly causing an accident.
●Stow cargo and luggage in the trunk 
whenever possible.
●Do not place cargo or luggage in or on 
the following locations.
• At the feet of the driver
• On the front passenger or rear seats  (when stacking items)
• On the package tray
• On the instrument panel
•On the dashboard
• In front of the Center Display
●Secure all items in the occupant com-
partment.
Capacity and distribution 

3597-2. Steps to take in an emergency
7
When trouble arises
■If a message that indicates the need for the shift lever operation is shown
To prevent the shift lever from being operated incorrectly or the vehicle from moving unex-
pectedly, a message that requires  shifting the shift lever may be shown on the multi-informa-
tion display. In that case, follow the instruction of the me ssage and shift the shift lever.
■If a message that indicates the malfunction of front camera is displayed
The following systems may be suspended un til the problem shown in the message is 
resolved. ( P.198, 347)
●PCS (Pre-Collision System)
●LKA (Lane-Keeping Assist)
●Automatic High Beam
●Dynamic radar cruise control with full-speed range
■If “Engine Stopped Steering  Power Low” (LC500) or “H ybrid System Stopped Steer-
ing Power Low” (LC500h) is shown
The steering wheel may become extremely heavy. If the steering wheel becomes heavier 
than usual when operating, hold firmly and operate using more force than usual.
■If “Warming Up Maximum Vehicle Speed: 65MPH” is shown (LC500h)
The transmission is being warmed up and the ve hicle is unable to be driven over 65 mph 
(110 km/h). Wait until th e transmission warms up.
■If “Stop the vehicle in a safe place Shift to P position” is shown (LC500h)
There may be a malfunction in th e hybrid system or the shift position may be shifted to N for 
a long time. Immediately stop the vehicle and contact your Lexus dealer.
■If “Oil Maintenance Required Soon” is shown (LC500h)
The engine oil is scheduled to be changed. Check the engine oil, and change if necessary. 
After changing the engine oil,  the message should be reset. (P.295)
■If “Maintenance Required Soon” is shown
Indicates that all maintenance according to th e driven distance on the maintenance sched-
ule
* should be performed soon. The message  is shown approximately 4500 miles (7200 
km) after the message has been reset. If necessary, perform maintenance.
*: Refer to the separate “Sched uled Maintenance” or “Owner’s  Manual Supplement” for the 
maintenance interval app licable to your vehicle.
■If “Engine Oil Level Low Add or Replace” is shown
The engine oil level is low. Chec k the level of engine oil, and add if necessary. This message 
may appear if the vehicle is stopped on a slope. Move the vehicle to a level surface and 
check to see if the message disappears.
■If a message that indicates the need for referring to Owner’s Manual is shown
●If any of the following messages is shown on  the multi-information display, follow the 
instructions.
• “Engine Coolant Temp High” ( P.376, 379)
•“Battery low” ( P.369)
• “Transmission Fluid Temp High” ( P.163, 170)
●If any of the following messages is shown on the multi-information di splay, it may indicate 
a malfunction. Have the vehicle inspected by your Lexus dealer immediately.
• “Access System with  Elec. Key Malfunction” 

3898-1. Specifications
8
Vehicle specifications
in cold weather.
If SAE 5W-30 is not available, SAE 
10W-30 oil may be used. However, it 
should be replaced with SAE 5W-30 
at the next oil change.Outside temperature
Oil viscosity (5W-30 is explained here 
as an example):
• The 5W in 5W-30 indicates the  characteristic of the oil which allows 
cold startability. Oils with a lower 
value before the W allow for easier 
starting of the engine in cold 
weather.
• The 30 in 5W-30 indicates the vis- cosity characteristic of the oil when 
the oil is at high temperature. An oil 
with a higher viscosity (one with a 
higher value) may be better suited if 
the vehicle is operated at high 
speeds, or under extreme load con-
ditions.
How to read oil container label:
The International Lubricant Specifica-
tion Advisory Committee (ILSAC) 
Certification Mark is added to some oil 
containers to help you select the oil you 
should use.
LC500h
■Oil capacity (Drain and refill [Ref-
erence
*])
*: The engine oil capacity is a reference  quantity to be used when changing the 
engine oil. Warm up the engine and turn 
off the hybrid system , wait more than 5 
minutes, and check the oil level on the 
dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in 
your Lexus vehicle. Use Lexus 
approved “Toyota Genuine Motor Oil” 
or equivalent to satisfy the following 
grade and viscosity.
Oil grade: ILSAC GF-5 multigrade 
engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for 
good fuel economy and good starting 
in cold weather.
If SAE 0W-20 is not available, SAE 
5W-20 oil may be used. However, it 
must be replaced with SAE 0W-20 at 
the next oil change.
A
With filter6.0 qt. (5.7 L, 5.0 Imp.qt.)
Without filter5.8 qt. (5.5 L, 4.8 Imp.qt.) 

4178-3. Items to initialize
8
Vehicle specifications
8-3.Items to initialize
Items to initialize
The following items must be initialized for normal system operation after such 
cases as the 12-volt battery being re connected, or maintenance being per-
formed on the vehicle:
List of the items to initialize
ItemWhen to initializeReference
Tire pressure warning system
• When rotating the tires.
• When the tire inflation pressure is  changed by changing tire size. 
(When there are  multiple speci-
fied pressures)
• After registering the ID codes.
• When the tire inflation pressure is  changed such as when changing 
traveling speed.
P.318
Power windows• When functioning abnormallyP.138
Lexus parking assist monitor
• The steering wheel has been moved while the 12-volt battery 
was being reinstalled.
• 12-volt battery power is low.Refer to “NAV- IGATION SYSTEM 
OWNER’S 
MANUAL”.
Message indicating maintenance is 
required• After the maintenance is per- formedP.295
Oil maintenance (LC500h)• After the maintenance is per-formedP.307