SEDONA FEATURES & FUNCTIONS GUIDE36*IF EQUIPPED †LEGAL DISCL AIMERS ON BACK INSIDE COVER
These illustrations are for demonstration purposes only. Actual features on vehicle
may vary. These illustrations are for demonstration purposes only. Actual
features on vehicle may vary.
Front Seat Headrest Adjustment†1 0
To raise headrest: Pull headrest up
To lower headrest: Press lock
A and then press the headrest down
Driver Position Memory System *
The integrated system stores into memory the position of the Driver’s Seat and
the Outside Rearview Mirrors
To store positions into memory, first place the Gear Shift into P (Park) while the
Engine Start /Stop button* is in the ON position Then:
1 Adjust the Driver’s Seat and the Outside Rearview Mirrors
2 Press the SET button
B on the control panel System will beep once
3 Press one of the memory buttons
C within 5 seconds The system will beep
twice when memory has been stored
Easy Access Function*
• The system will automatically move the driver's seat forward when the
ignition or the Engine Start /Stop button is pressed to ON or the ACC position
• The system will automatically move the driver's seat rearward when
the ignition or the Engine Start /Stop button is pressed to OFF
• To activate or deactivate the Easy Access Function, go to User
Settings in the LCD Instrument Cluster modes
(Buttons located on Driver's Door Panel)
REMINDER: Do not operate the vehicle with the headrests removed Headrests can
provide critical neck and head support in an accident
REMINDER: Do not attempt to operate the driver
position memory system while the vehicle is moving
This could result in loss of control of the vehicle
SEATING
For easy adjustments, hold a headrest post with one hand while using
the other hand to pull the headrest from underneath QUICK TIP
A
B
C
C
Refer to section 3 in the Owner’s Manual for more information.
Refer to section 3 in the Owner’s
Manual for more information.
43
OTHER KEY FEATURES
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS *IF EQUIPPED †LEGAL DISCL AIMERS ON BACK INSIDE COVER
Refer to section 4 in the Owner’s Manual for more information.
Refer to section 4 in the Owner’s Manual for more information.
(Lamp controls located in the overhead consoles) Type A shown
Rear
Front
AA
BC
DD
Map/Room Lamps
Automatic turn off function*
The interior lights automatically turn off approximately 30 seconds after
the Engine Start /Stop button is OFF
Map/Room Lamp Operation
Press the lens
A to turn the Map Lamp ON/OFF This light produces a
spot beam for convenient use as a map lamp or as a personal lamp for
the driver or the front passenger
When the
button B is pressed, the following occurs:
• When any door or the liftgate is opened, the Map and Room Lamps turn ON
• When doors are unlocked from the Smart Key or key removed from
ignition, the Map and Room Lamps turn ON for approximately 30
seconds or until a door is opened
• When doors are closed, the lamps will gradually turn OFF after
approximately 30 seconds
• When all doors are locked or the ignition is turned ON, the Map Lamp
will turn OFF immediately
When the
button C is pressed, the lamps stay ON continuously
Room Lamp – Press the lens
D to turn the Room Lamp ON/OFF
•When the doors are unlocked by the Smart Key*, the lamp turns ON for
approximately 30 seconds
•If your vehicle is equipped with the theft alarm system, the interior lights
automatically turn off approximately 3 seconds after the system is in the
armed stage
•Using interior lights for an extended period of time may cause battery discharge
QUICK TIPS
Sunvisor†24
Use the Sunvisor to shield direct light through the front or side windows
Slide the Sunvisor out and adjust as needed
REMINDERS:
•The Sunvisor may not shield all direct light
•The Sunvisor may impair visibility if not adjusted properly
•
Be aware of the seating position when adjusting or swinging Sunvisor around to
or from the front or side windows
•Do not operate the vehicle if the Sunvisor is impairing your visibility
REMINDER: When the Room Lamp lens is pressed ON it will remain ON, even when the Map
Lamp switch is in the OFF position
SEDONA FEATURES & FUNCTIONS GUIDE44*IF EQUIPPED
(Front overhead console for
Front Sunroof controls)
(Front overhead console for Rear Sunroof controls)
Sunroof Operation *
The Sunroof and Sunshade operation is controlled through a multidirectional switch/
lever The ignition needs to be in the ON position to operate the Sunroof/Sunshade
The front and rear Sunroof/Sunshade are operated from separate controls
Front Sunshade and Sunroof Controls:
• Auto Open: Slide lever
A backward to the farthest position and release
• Auto Close (Sunroof only): Slide the lever
A forward to the farthest position
and release
Slide the Sunroof (with Sunshade open):
• Open: Press the Sunroof lever
A backward and press again forward/backward
until you reach the desired detent position (manual slide feature)
• Close: Press the Sunroof lever
A forward and press again forward/backward until
you reach the desired detent position (manual slide feature)
Tilt the Sunroof:
• To raise, push the lever
A upward; to lower, push the lever A forward
REMINDER: The Front Sunroof will automatically open all the way The Rear Sunroof will only
partially open To open all the way, slide the Rear Sunroof lever again
Rear Sunshade and Sunroof Controls:
• Auto Open: Slide lever
B backward to the farthest position and release
• Auto Close (Sunroof only): Slide the lever
B forward to the farthest
position and release
Slide the Sunroof (with Sunshade open):
• Open: Press the Sunroof lever
B backward and press again forward/
backward until you reach the desired detent position (manual slide feature)
• Close: Press the Sunroof lever
B forward and press again forward/backward
until you reach the desired detent position (manual slide feature)
Tilt the Sunroof:
• To raise, push the lever
B upward; to lower, push the lever B forward
To stop the Sunroof/Sunshade at any position, push or
pull the Sunroof control lever in any direction QUICK TIP
Sunroof Operation
Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website
Refer to page 2 for more
information QR CODE
www.youtube.com/KiaFeatureVideos
REMINDERS:
•
When the Power Window Lock is depressed, the Rear Sunroof
controls cannot operate the Rear Sunroof
•
The Sunshade needs to remain OPEN while the Sunroof is open
and the vehicle is moving
•
Do not adjust the Sunroof or Sunshade while driving This could
result in loss of control of the vehicle
A
B
Refer to section 4 in the Owner’s Manual for more information.
OTHER KEY FEATURES
45ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS *IF EQUIPPED †LEGAL DISCL AIMERS ON BACK INSIDE COVER
(Navigation screen display shown)
P
R
N
DSHIFTL OCK
RELEASE
Parking Distance Warning–Forward*
and Reverse *†6
The Parking Distance Warning–Forward* and Reverse* is a supplemental
system that is designed to assist the driver by chiming if any object is
detected within the sensing area to the front, rear and side of the vehicle
when moving forward or backing up
To activate, press button
A (LED
illuminated) The system is also activated
when the ignition is ON and the gear shift
is moved into R (Reverse) To deactivate the
system, press the Parking Distance Warning
–Forward* and Reverse* button
A (LED not
illuminated)
REMINDERS:
•
If the vehicle is moving at speeds over 3 mph, the system may not activate correctly
•
When more than two objects are sensed at the same time, the closest one will be
recognized first
The Parking Distance Warning– Forward* and Reverse* is not a substitute for proper and safe
backing-up procedures. Always drive safely and use caution when backing up. The Parking Distance
Warning– Forward* and Reverse* may not detect every object in front of or behind the vehicle.
These illustrations are for demonstration purposes only. Actual features on vehicle may vary.
Refer to section 4 in the Owner’s Manual for more information.
P
R
N D
ECO
+ _
(Button located below Gear shift)
Rear View Monitor†6
The Rear View Monitor system is a supplemental system that displays the
view behind the vehicle through the audio control head unit screens while
the vehicle is in Reverse
The Rear View Monitor activates when the:
• Ignition or the Engine Start /Stop button* is in the ON position
(Green Light)
• Gear Shift Lever is in the R (Reverse) position
REMINDERS:
•The Rear View Monitor is ON by default when the ignition is cycled
•
The screen image above is for illustration purposes only The actual image or graphics may
differ in your vehicle
The Rear View Monitor is not a substitute for proper and safe backing-up procedures. The Rear
View Monitor may not display every object behind the vehicle. Always drive safely and use
caution when backing up.
Refer to section 4 in the Owner’s Manual for more information.
A
OTHER KEY FEATURES
49ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS *IF EQUIPPED †LEGAL DISCL AIMERS ON BACK INSIDE COVER
OTHER KEY FEATURES
Driver Attention Warning (DAW) *†7
The DAW system is designed to detect certain inattentive driving practices and, in certain situations, can give a
warning signal to the driver to take a break from driving
The DAW system is set to OFF by default To turn the DAW System ON, turn the ignition on and then select User
Settings in the LCD Display on the Instrument Cluster Then go to Driving Assist and select Driver Attention Warning
Set the DAW System to Normal or Early
Driver Attention Warning (DAW) System modes:
OFF: The Driver Attention Warning system is deactivated
A
Normal: The Driver Attention Warning system alerts the driver of inattentive driving practices
High Sensitivity*/ Early*: The Driver Attention Warning system alerts the driver of inattentive driving practices faster
than Normal mode
If the DAW System is activated, the DAW information will appear on the LCD Display
B when you select the ASSIST
mode
A message, “Consider taking a break,” appears on the LCD display and a warning sounds to suggest the driver to take
a break when the driver’s attention level is below 1
C
REMINDERS:
•The setup of the DAW system will be maintained, as selected, when the ignition is cycled
•
When activated, the DAW system does not display the “Consider taking a break” message when the total trip
driving time is less than 10 minutes
•
The DAW system will enter a standby mode if the camera does not detect the lanes and/or the driving speed
remains under 40 mph
These illustrations are for demonstration purposes only. Actual features on vehicle may vary.
Refer to section 5 in the Owner’s Manual for more information.
Attention Alert System Off
Level Time ——:——Attention Level
LOW HIGH
Level Time 05:27 Attention Level
LOW
HIGH
Level Time 05:27
Consider taking a break
22.4
°C4025km
Attention Alert System Off
Level Time ——:——Attention Level
LOW HIGH
Level Time 05:27
Attention Level
LOWHIGH
Level Time 05:27
Consider taking a break
22.4
°C4025km
Attention Alert System Off
Level Time ——:—— Attention Level
LOW
HIGH
Level Time 05:27
Attention Level
LOWHIGH
Level Time 05:27
Consider taking a break
22.4 °C4025km
ABC