7
To use the door handles to lock
and unlock your vehicle, make
sure the INFINITI Intelligent
Key is with you (that is, in your
pocket or purse).
•
T
ouch the inside of the door
handle
to unlock the
corresponding front door.
•
Pushing the r
equest switch
while touching the inside
of the door handle will unlock
the rest of the doors.
•
T
o lock the vehicle,
push either door handle
request switch
once.
Locking and Unlocking your
Vehicle via the Door Handle
To change the settings for the door locking and unlocking system,
press the MENU button
, then select the “Settings” key on the
lower display followed by the “Comfort & Convenience” key.
•
T
o unlock all doors by touching the
inside of the door handle, select
“Selective Door Unlock”.
•
T
o disable unlocking by touching the
inside of the door handle, select “Touch Sensitive Door Sensor”.
Please see your Owner’s Manual for important safety information, system limitations, and
additional operating and feature information.
REMOTE ENGINE START
(IF SO EQUIPPED)
The remote engine start
system must be enabled in
the vehicle settings within the
lower display. To start your
vehicle remotely:
1.
Pr
ess the lock button
to
lock the vehicle.
2.
Pr
ess and hold the remote
engine start button
within 5 seconds of pressing
the lock button
and the
engine will start.
To start driving, depress the
brake pedal and push the
ignition switch START/STOP
button to the ON position.
State laws may apply, review
local laws before using.
Please see your Owner’s Manual for
important safety information, system
limitations, and additional operating and
feature information.
Infiniti Intelligent Key System
12
To turn the rain sensor function on and off:
1.
Pr
ess the MENU button below the lower display.
2.
Select the
“Settings” key and then the “Comfort &
Convenience” key
on the display.
3
.
Select the
“Rain Sensor” key
to toggle the
feature ON and OFF.
When the rain-sensing function is disabled, the AUTO
position on the wiper stalk will work in conventional
intermittent mode.
WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order
to replace the wiper blades. To move the wiper blades to the
service position:
• When the ignition swit
ch is in the ON position or within
60 seconds of placing the ignition switch in the OFF
position, lift the windshield wiper and washer lever
upwards twice in less than 0.5 seconds. The windshield
wipers will move to the service position automatically, and
the wiper blades can now be replaced.
To move the wiper blades back to the original position:
•
Plac
e the wiper arm in the down position and lift the wiper
and washer lever up for more than 1 second, or lower the
lever down to operate at any wiper speed.
Wiper and Washer Switch
Move the lever up or down to one of
the following positions to operate the
windshield wipers:
MIST
One sw
eep operation
OFF
Wipers ar
e OFF
AUTO
Speed-sensing and
r
ain-sensing automatic wipe
LO
C
ontinuous wipe, slow
HI
C
ontinuous wipe, fast
To adjust the wiper sensitivity for the AUTO
setting, twist the control ring
.
Pull the lever
toward you to operate the
windshield washer.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating and feature information.
