2021 GENESIS GV80 tow

Quick Reference Guide I 0201 I Quick Reference Guide
Remote start using Smart Key (if equipped)
You can start the vehicle using the Remote Start button on the smart key.
To start the vehicle remotely:
1. Press the door lock button on the smart key within 32 feet (10m) from
the vehicle.
2. Press the Remote Start button for more than 2 seconds within 4
seconds after pressing the door lock button.
3. The hazard warning lights will blink and the engine will start.
4. To turn off the remote start function, press the Remote Start button once.
Lock
Unlock
Trunk open
Panic
SMART KEYDOOR LOCK
PP
PP
Type AType B
Remote Start
PPPP
PP
Remote Smart Parking Assist
Lamp ON
Accessing mechanical key
Operating Door Locks from Outside the Vehicle
Mechanical Key
1. Place a soft cloth over the groove A, and pry open the smart key
cover.
2. Press the mechanical key and
remove it from the smart key FOB.
A
After pulling the door handle 1, turn the key 2 toward the front of the
vehicle to lock A or turn the key toward the rear of the vehicle to unlock B.
If you lock the driver’s door with a mechanical key while the engine is
running, turn the key 2 TWICE toward the front of the vehicle to lock A.
If you lock/unlock the driver's door with the mechanical key, only the
driver's door will lock/unlock automatically, not others.
Once the doors are unlocked, they can be opened by pulling the door
handle. When closing the door, push the door by hand. Make sure that
doors are closed securely.
* CAUTION
· If you locked the door with the touch sensor on the door handle, th\
e
doors cannot be unlocked with the sensor within 3 seconds.
· If you unlocked the door with the touch sensor on the door handle, \
the doors cannot be locked with the sensor within 2 seconds.
NOTE: User selectable option: Please see section 5 from your Owner’s
Manual for more details.
1
2
AB
Driver’s door Lock / Unlock
· To Unlock : Place your hand
inside the door handle
· To Lock : Press the touch sensor
on the outside of the handle to lock.
FEATURES AND CONTROLS
GENESIS GV80

Quick Reference Guide I 1211 I Quick Reference Guide
WIPERS AND WASHER
Windshield Washer
Pull the lever gently toward you to
spray washer fluid onto the windshield
and to run the wipers1-3 cycles.
Push the lever away from you to spray
rear washer fluid and to run the rear
wipers 1-3 cycles.
Fastest wiper speed
Adjust the control knob.
Slowest wiper speed
MIST - Single wipe
AUTO - Auto control wipe
LO - Low wiper speed
HI - High wiper speed
OFF
PULL
Auto Control Wipe AdjustmentHeadlight delay
Headlights may stay on for 15 seconds after exiting and locking up
the vehicle. Press the remote lock button twice to turn the headlights
off. Please refer to your Owner’s Manual for further information.
Auto headlights
Headlights
Parking lights
All lights Off
Turn signals A and lane change B signals
High beam
NOTE: To turn off the high
beam, pull the lever
towards you.
Flashing headlights
High Beam Assist
HEADLIGHTS AND FOG LIGHTS
PUSH
Function operation
1. Select auto position on stalk.
2. Push lever forward to engage Auto
High beam.
3. Push lever forward again to
disengage.
Wiper Blade Removal
1. Within 20 seconds of turning off
the engine, lift and hold the wiper
lever up to MIST position for about
2 second until the wipers move to
the top wipe position
2. At this position, you are able to lift
the wipers off the windshield.
3. Gently put wipers back down onto
windshield
4. Turn the wipers to any ON position
to return to resting position
NOTE: To prevent damage to the
hood and wiper arms, the wiper
arms should only be lifted when in
the top wiping position.
FEATURES AND CONTROLS
GENESIS GV80

Quick Reference Guide I 1817 I Quick Reference Guide
3rd ON
-+
DEFOGGING / DEFROSTINGSYSTEM OFF
Pressing the OFF button will
place the system in below settings.
• Front blower will turn off.
• Outside (fresh) air position
will be selected.
• Vented air will be at last set
temperature.
Front seat control
MODE SELECTION
NOTE: To reduce window fogging and improve visibility, keep the interior
surface of the windshield clean by wiping it with a clean cloth and glas\
s
cleaner. In addition, position the air intake control to circulate fresh air
whenever possible while operating the vehicle.
NOTE: Use a microfiber towel to
prevent scratches on the climate
controls while removing
fingerprints, dust, or stains.
Immediately wipe off any interior
cleaning products to prevent
damage to the climate controls.
AIR INTAKE CONTROL
Automatically controls the
modes, fan speeds, air intake
and air-conditioning functions.
AUTOMATIC HEATING /
AIR CONDITIONING
Rear seat control (if equipped)
If cabin humidity increase while
Climate Control is off, fresh air will
be circulated into the cabin.
Please refer to the Owner's Manual
for further details.
SMART VENT
When Fresh mode is
selected, air enters the
vehicle from outside and is
heated or cooled
according to the function
selected.
When Recirculation mode
is selected, air from the
passenger compartment
will be recirculated
through the system and
heated or cooled
according to the function
selected.
CLIMATE CONTROL SYSTEM
3. Set the fan speed to
the highest speed
setting.
2. Select warmest
temperature.
1. Press the front defrost
button.
NOTE: Outside (fresh) air position will
be selected when front defrost button
is selected.
FaceLevelFloorLevelFloor &Defrost
Passenger/Rear
Recirculation mode
Fresh mode
Front
Bi-Level
1 Driver’s temperature control
2 Passenger’s temperature control
3 Fan speed control
4 Driver’s mode selection
5 Passenger’s mode selection
6 AUTO (automatic control)
7 OFF (system off)
8 Front windshield defroster
9 Air intake control
10 SYNC
11 Rear window defroster
12 A/C (air conditioning)
13 Rear temperature control
1 Fan speed control
2 Temperature control
3 OFF (system off)
4 AUTO (automatic control)
5 Mode selection
10
9
8
12
7
11
4
4
63
2
5
55
13
13
12
Touch the arrows on the
climate control
information screen to
select air flow direction.
FEATURES AND CONTROLS
GENESIS GV80