2021 FORD EXPEDITION Owners Manual

Page 169 of 574

FORD EXPEDITION 2021  Owners Manual Adjusting the Manual Second Row
Outermost Seats for Easy Entry
WARNING: Do not drive your
vehicle with a seat that is unlatched or
in the folded position. Failure to follow
this instruction could resu

Page 170 of 574

FORD EXPEDITION 2021  Owners Manual Adjusting the Second Row
Outermost Seats for Easy Exit
When exiting your vehicle from the third
row seats, pull the lever up on the upper
corner of the outermost seats. Then, push
the seat forward unt

Page 171 of 574

FORD EXPEDITION 2021  Owners Manual Adjusting the Second Row Center
Seat (If Equipped)
Note: Move this seat forward to keep a
child in a child restraint close to the front
seat occupants. Move the seat to the full
rearward position when

Page 172 of 574

FORD EXPEDITION 2021  Owners Manual Folds the right-hand third-row
seat.
C
Folds the left-hand second-row
seat.
D
Folds the second-row bench
center seat or both second-row
captain chair seats.
E
Folds the right-hand second-row
seat.
F
T

Page 173 of 574

FORD EXPEDITION 2021  Owners Manual CLIMATE CONTROLLED SEATS
(IF EQUIPPED)
Heated Seats
WARNING: Use caution when using
the heated seat if you are unable to feel
pain to your skin because of advanced
age, chronic illness, diabetes, spin

Page 174 of 574

FORD EXPEDITION 2021  Owners Manual Press this symbol to cycle through the
various ventilation settings and off. More
indicator lights indicate higher fan speeds.
If the engine falls below 350 RPM while
the ventilated seats are on, the

Page 175 of 574

FORD EXPEDITION 2021  Owners Manual WHAT IS THE REAR
OCCUPANT ALERT SYSTEM
The rear occupant alert system monitors
vehicle conditions and notifies you to check
for rear seat occupants when you switch
the ignition off.
HOW DOES THE REAR

Page 176 of 574

FORD EXPEDITION 2021  Owners Manual SWITCHING REAR OCCUPANT
ALERT SYSTEM ON AND OFF -
VEHICLES WITH: SYNC 3
1. Press Settings on the touchscreen.
2. Press 
Vehicle.
3. Switch 
Rear Occupant Alert on or off.
Note: The default setting is