Chevrolet Camaro High Performance Owner Manual Supplement (GMNA-
Localizing-U.S./Canada/Mexico-14584225) - 2021 - CRC - 9/30/20
Driving and Operating 23
PTM Sport 1
‐For use by drivers familiar with the track.
‐ Dry conditions only.
‐ StabiliTrak/ESC is on and more engine
power is available than lower modes.
PTM Sport 2
‐ For use by drivers familiar with the track.
‐ Dry conditions only.
‐ StabiliTrak/ESC is off and engine power
available is the same as in Sport 1.
PTM Race
‐ For use by drivers familiar with the track.
‐ Dry conditions only.
‐ StabiliTrak/ESC is off and engine power is
available for maximum cornering speed.
In any PTM Mode, Launch Control is
available. Use PTM Race for the most
consistent performance during drag strip
use. See “Custom Launch Control” in Track
Events and Competitive Driving in the
owner’s manual.
Press and release
Yto turn off PTM and
return to TCS and StabiliTrak/ESC. The
traction off light
iand StabiliTrak/ESC OFF
light
gwill go out.
Launch Control
If equipped, Launch Control is available
within Competitive Driving Mode and
Performance Traction Management (PTM) to
allow high levels of vehicle acceleration in a
straight line. Launch Control is a form of
traction control that manages tire spin while
launching the vehicle. This feature is
intended for use during closed course race
events where consistent zero to
60 and quarter mile times are desirable.
Launch Control is only available when the
following criteria are met:
.Competitive Driving Mode is selected or
any of the Performance Traction
Management modes are selected. The
traction off light comes on in the
instrument cluster and the appropriate
Driver Information Center (DIC) message
displays.
.The vehicle is not moving.
.The steering wheel is pointing straight.
Manual Transmissions
.The clutch is fully pressed and the
transmission is in 1 (First) gear.
.The accelerator pedal is rapidly applied
and held to wide open throttle. Launch Control will initially limit engine
speed as you rapidly apply the accelerator
pedal to wide open throttle. Allow the
engine rpm to stabilize. A smooth, quick
release of the clutch, while maintaining the
fully pressed accelerator pedal, will manage
wheel slip.
Automatic Transmissions
.The brake pedal is firmly pressed to the
floor, equivalent to a panic brake event.
.The accelerator pedal is rapidly applied to
wide open throttle. If the vehicle rolls due
to wide open throttle, release the
throttle, press the brake pedal more
firmly, and re-apply the accelerator to
wide open throttle.
Launch Control will initially limit engine
speed as you rapidly apply the accelerator
pedal to wide open throttle. Allow the
engine rpm to stabilize. A smooth, quick
release of the brake pedal, while
maintaining the fully pressed accelerator
pedal, will manage wheel slip.
After the vehicle is launched, the system
continues in Competitive Driving Mode
or PTM.
Chevrolet Camaro High Performance Owner Manual Supplement (GMNA-
Localizing-U.S./Canada/Mexico-14584225) - 2021 - CRC - 9/30/20
28 Vehicle Care
1. Windshield Washer Fluid Reservoir.
2. Engine Coolant Surge Tank andPressure Cap.
3. Engine Oil Dipstick.
4. Engine Oil Fill Cap.
5. Brake/Clutch Fluid Reservoir.
6. Engine Air Cleaner/Filter.
7. Engine Cooling Fan (Out of View).
8. Engine Compartment Fuse Block.
9. Negative (–) Battery Terminal.
10. Positive (+) Battery Terminal.
Engine Oil
To ensure proper engine performance and
long life, careful attention must be paid to
engine oil. Following these simple, but
important steps will help protect your
investment:
.Use engine oil approved to the proper
specification and of the proper viscosity
grade. See “Selecting the Right Engine
Oil” in this section.
.Check the engine oil level regularly and
maintain the proper oil level. See
“Checking Engine Oil” and“When to Add
Engine Oil” in this section.
.Change the engine oil at the appropriate
time. See“Engine Oil Life System” in the
owner’s manual.
.Always dispose of engine oil properly. See
“What to Do with Used Oil” in this
section.
Checking Engine Oil
Check the engine oil level regularly, every
650 km (400 mi), especially prior to a long
trip. The engine oil dipstick handle is a loop.
See Engine Compartment Overview 027 for
the location.
{Warning
The engine oil dipstick handle may be
hot; it could burn you. Use a towel or
glove to touch the dipstick handle.
If a low oil Driver Information Center (DIC)
message displays, check the oil level.
Follow these guidelines:
.To get an accurate reading, park the
vehicle on level ground. Check the engine
oil level after the engine has been off for
at least two hours. Checking the engine
oil level on steep grades or too soon after
engine shutoff can result in incorrect readings. Accuracy improves when
checking a cold engine prior to starting.
Remove the dipstick and check the level.
.If unable to wait two hours, the engine
must be off for at least 15 minutes if the
engine is warm, or at least 30 minutes if
the engine is not warm. Pull out the
dipstick, wipe it with a clean paper towel
or cloth, then push it back in all the way.
Remove it again, keeping the tip down,
and check the level.
When to Add Engine Oil
If the oil is below the cross-hatched area at
the tip of the dipstick and the engine has
been off for at least 15 minutes, add 1 L (1
qt) of the recommended oil and then
recheck the level. See
“Selecting the Right
Engine Oil” later in this section for an
explanation of what kind of oil to use. For
engine oil crankcase capacity, see Capacities
and Specifications 043.
Chevrolet Camaro High Performance Owner Manual Supplement (GMNA-
Localizing-U.S./Canada/Mexico-14584225) - 2021 - CRC - 9/30/20
30 Vehicle Care
sewers, or into streams or bodies of water.
Recycle it by taking it to a place that
collects used oil.
Engine Air Filter Life System
If equipped, this feature provides the engine
air filter’s remaining life and best timing for
a change. The timing to change an engine
air filter depends on driving and
environmental conditions.
When to Change the Engine Air Filter
When the Driver Information Center (DIC)
displays a message to replace the engine air
filter at the next oil change, follow this
timing.
When the DIC displays a message to replace
the engine air filter soon, replace the engine
air filter at the earliest convenience.
The system must be reset after the engine
air filter is changed.
If the DIC displays a message to check the
engine air filter system, see your dealer.
How to Reset the Engine Air Filter Life
System
Reset the system whenever the engine air
filter is replaced so that the system can
calculate the next engine air filter change.
To reset:1. Place the vehicle in P (Park).
2. Select Engine Air Filter Life on the DIC menu. See “Driver Information Center
(DIC)” in the owner manual.
3. Press
pto move to the Reset/Disable
display area. Select Reset then press SEL.
Then press Yes to confirm the reset.
4. 100% Air Filter Life will be displayed when the Engine Air Filter Life System is
successfully reset.
Engine Air Cleaner/Filter
The engine air cleaner/filter is in the engine
compartment on the driver side of the
vehicle.
When to Inspect the Engine Air Cleaner/
Filter
.For intervals on changing and inspecting
the engine air filter, see “Maintenance
Schedule” in the owner’s manual.
.If equipped with Engine Air Filter Life
System, see Engine Air Filter Life System
0 30.
.If driving in very dusty areas, follow the
engine air filter inspecting and changing
intervals, see “Maintenance Schedule” in
the owner’s manual.
How to Inspect/Replace the Engine Air
Cleaner/Filter
Do not start the engine or have the engine
running with the engine air cleaner/filter
housing open. Before removing the engine
air cleaner/filter, make sure that the engine
air cleaner/filter housing and nearby
components are free of dirt and debris.
Remove the engine air cleaner/filter. Lightly
tap and shake the engine air cleaner/filter
(away from the vehicle), to release loose
dust and dirt. Inspect the engine air cleaner/
filter for damage, and replace if damaged.
Do not clean the engine air cleaner/filter or
components with water or compressed air.
To inspect or replace the engine air cleaner/
filter: