101
"Natural"  mode, depending  on  which  mode
was  selected  before  the  engine  was
stopped.
When  the  engine  is  started  again,  the
"RACE"  mode  selected  previously  is  not
retained.  The  system  will  reactivate  in
"Dynamic" mode.
ALFA ACTIVE SUSPENSION 
(AAS) — IF EQUIPPED
The  vehicle's  electronic  suspension  manage-
ment  system  is  aimed  at  optimizing  the
vehicle's performance.
The  system  continuously  monitors  the
damping of the suspensions through the actu -
ator  installed  on  each  shock  absorber.  This
way,  the  calibration  of  the  shock  absorbers
can  be  adjusted to the conditions of  the  road
surface  and  to  the  dynamic  conditions  of  the
vehicle,  improving  its  comfort  and  road
holding.
The  driver  can  choose,  even  while  driving,
(only in “Dynamic” mode),  between  two types
of  suspension  calibration:  a  more  sporty  or  a
more comfortable one.
By  pushing  the  button,  the  system  changes
the shock absorber calibration. Alfa Active Suspension Button
In case of a system failure, the symbol   and
a  dedicated  message  will  be  shown  on  the
instrument cluster display.
STOP/START SYSTEM
The Stop/Start system automatically shuts off
the engine during a vehicle stop if the required
conditions are met. Releasing the brake pedal
or  accelerator  pedal  will  automatically  restart
the engine.
The  function  was  developed  to  increase
vehicle  efficiency  by  reducing  fuel  consump -
tion, gas emissions, and sound pollution.
NOTE:
When the Stop/Start system stops the engine,
the power steering is also disabled.
Operating Mode
Stopping The Engine
With  the  vehicle  at  a  standstill  and  brake  pedal
pressed, the engine switches off if the gear selector
is in a position other than REVERSE (R).
The  system  does  not  operate  when  the  gear
selector  is  in  REVERSE  (R),  in  order  to  make
parking maneuvers easier.
In the event of stops uphill, engine switching off is
disabled  to  make  the  “Hill  Start  Assist”  function
available (works only with running engine).
NOTE:
The  engine  can  only  be  automatically  stopped
after having run at about 6 mph (10 km/h). After
an  automatic  restart,  the  vehicle  only  needs  to
exceed  a  speed  of  0.3 mph  (0.5 km/h)  to  stop
the engine.
Engine stopping  is  signaled  by  the    symbol
lighting up on the instrument cluster display.
Restarting The Engine
To restart the engine, release the brake pedal
or,  turn  the  steering  wheel  slightly  (if
equipped).
With  the  brake  pressed  and  the  transmission
in  automatic  mode  DRIVE  (D),  the  engine  will
restart by shifting to REVERSE (R), to PARK (P)
or to “AutoStick”  
Ú
 page 94.
With  brake  pressed  if  the  gear  selector  is  in
“AutoStick”  mode,  the  engine  will  restart  by
shifting to  PARK  (P) or by moving the selector
to + or -  
Ú
 page 94.
21_GU_OM_EN_USC_t.book  Page 101   
STARTING AND OPERATING
134
4. When the fuel nozzle “clicks” or shuts off,before  removing  the  nozzle,  wait  for  at
least  10  seconds  in  order  for  the  fuel  to
flow inside the tank.
5. Remove  the  fuel  filler  nozzle,  tighten  the gas  cap  about  ¼  turn  until  you  hear  one
click. This is an indication that cap is prop-
erly tightened.
The label indicates the fuel type (UNLEAD -
ED FUEL = gasoline).
Fuel Door Label Emergency Fuel Door Opening
In  the  event  of  an  emergency,  the  fuel  filler
door can be opened from inside the liftgate.
Proceed as follows:
Models With Compact Spare Tire
1. Open the liftgate and lift up the load floor.
Load Floor
2. Unlock the locking device and remove the compact  spare  tire  to  reach  the  emer -
gency opening cable on the side of the fuel
door. Cargo Area
3. Pull the cable to release the fuel door lock.
Release Cable
4. Open the fuel door by pushing it.
1 — Locking Device
1 — Release Cable
21_GU_OM_EN_USC_t.book  Page 134   
SERVICING AND MAINTENANCE
230
Types Of Bulbs
Replacement Bulbs
The vehicle may be equipped with the following bulbs
Glass Bulbs (Type A) : They are press-fitted. Pull to extract.
Bayonet-Type Bulbs (Type B) : To remove them from their holder, press the bulb and turn it counterclockwise,
then extract it.
Tubular Bulbs (Type C) : Release them from their contacts to remove.
Halogen Bulbs (Type D) : To remove the bulb, turn the connector to the side and pull it out.
Halogen Bulbs (Type E) : To remove the bulb, turn it counterclockwise.
Xenon Gas Discharge Bulb (Type F) : to remove the bulb, contact an authorized dealer.
Light bulbsTypePower
Front direction indicators* PY24W24W
Rear Fog lights * H1155 W
Main beam headlights, front side lights/daylight running lights (DRL)* H1555/15W
Dipped beam headlights* H755W
Main beam/dipped beam headlights (Xenon gas discharge) D3S35W
21_GU_OM_EN_USC_t.book  Page 230