Page 62 of 494

60
uuAirbags uAirbag Care
Safe Driving
Airbag Care
You do not need to, and should not, perform any maintenance on or replace any
airbag system components yourself. However, you should have your vehicle
inspected by an authorized Acura NSX dealer in the following situations:
■When the airbags have deployed
If an airbag has inflated, th e control unit and other related parts must be replaced.
Similarly, once an automatic seat belt tensioner has been activated, it must be
replaced.
■When the vehicle has been in a moderate-to-severe collision
Even if the airbags did not inflate, have an authorized Acura NSX dealer inspect the
following: the weight sensors in the passeng er’s seat, seat belt tensioners, and each
seat belt that was worn during the crash.
■Do not remove or modify a seat without consulting an authorized Acura
NSX dealer
This would likely disable or affect the prop er operation of the weight sensors in the
passenger’s seat. If it is necessary to re move or modify a seat to accommodate a
person with disabilities, contact an authoriz ed Acura NSX dealer, or for U.S. vehicles,
Acura Client Relations at 1-844-682-2872 and for Canadian vehicles, Acura Client
Service at 1-888-9-ACURA-9 or 1- 844-9-MYNSX-9 (NSX-specific).
1Airbag Care
We recommend against the use of salvaged airbag
system components, includi ng the airbag, tensioners,
sensors, and control unit.
21 ACURA NSX PMC-31T6N6400.book 60 ページ 2020年10月8日 木曜日 午後3時7分
Page 73 of 494
71
Safe Driving
Safety Labels
Label Locations
These labels are in the locations shown. They warn you of potential hazards that can cause serious injury or death. Read these labels
carefully.
If a label comes off or becomes hard to read (except for the U. S. dashboard label which may be removed by the owner), contact a n
authorized Acura NSX dealer for a replacement.
Inverter Coolant
Filler Tank Cap Sun Visors
U.S. models Canadian models
Engine Coolant
Reserve Tank
Cap
High Voltage System Components
U.S. models Canadian models
Dashboard
U.S. models only
Air Conditioner System U.S. models Canadian models
21 ACURA NSX PMC-31T6N6400.book 71 ページ 2020年10月8日 木曜日 午後3時7分
Page 76 of 494

74
Instrument Panel
Indicators
IndicatorNameOn/BlinkingExplanationMessage
Brake System
Indicator (Red)
•Comes on for a few seconds when
you set the power mode to ON,
then goes off.
• Comes on when the brake fluid
level is low.
• Comes on if there is a problem with
the brake system.•Comes on while driving - Check the
brake fluid level.
2 What to do when the indicator comes
on while driving P. 457
•Comes on along with the brake
system indicator (amber) - Immediately
stop in a safe place. Contact an authorized
Acura NSX dealer for repair. The brake
pedal becomes harder to operate. Depress
the pedal further than you normally do.
• Comes on along with the ABS
indicator - Have your vehicle checked by
an authorized Acura NSX dealer.
2 If the Brake System Indicator (Red)
Comes On P. 457
Low Oil Pressure
Indicator
•Comes on when you set the power
mode to ON, and goes off when
the power system starts.
• Comes on when the engine oil
pressure is low.
• Comes on if there is a problem with
the engine oil pressure system.•Comes on while driving - Immediately
stop in a safe place and set the power
mode to VEHICLE OFF, then contact an
authorized Acura NSX dealer.
U.S.
Canada
(Red)
21 ACURA NSX PMC-31T6N6400.book 74 ページ 2020年10月8日 木曜日 午後3時7分
Page 77 of 494

75
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Electric Parking
Brake Indicator
•Comes on when the parking brake
is applied, and goes off when it is
released.
• Comes on for about 15 seconds
then goes off when you pull the
electric parking brake switch with
the power mode in OFF.
• Comes on for about 15 seconds
then goes off when you set the
power mode to OFF with the
parking brake applied.• Blinks and the electric parking brake
system indicator comes on at the same
time - There is a problem with the electric
parking brake system. The parking brake
may not be set.
• Comes on when you press the
electric parking brake switch
without depressing the brake
pedal.• Depress the brake pedal to release the
parking brake.
2 Parking Brake P. 361
Electric Parking
Brake System
Indicator
•Comes on for a few seconds when
you set the power mode to ON,
then goes off.
• Comes on if there is a problem with
the electric parking brake system.• Comes on while driving - Avoid using
the parking brake and have your vehicle
checked by an auth orized Acura NSX
dealer immediately.
2 If the Electric Parking Brake System
Indicator Comes On P. 458
U.S.
Canada
21 ACURA NSX PMC-31T6N6400.book 75 ページ 2020年10月8日 木曜日 午後3時7分
Page 78 of 494
76
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Automatic Brake
Hold System
Indicator•Comes on when the automatic
brake hold system is on.
2 Automatic Brake Hold P. 364
Automatic Brake
Hold Indicator
•Comes on for a few seconds when
you set the power mode to ON,
then goes off.
• Comes on when the automatic
brake hold is activated.
2 Automatic Brake Hold P. 364—
U.S.
Canada
21 ACURA NSX PMC-31T6N6400.book 76 ページ 2020年10月8日 木曜日 午後3時7分
Page 79 of 494
77
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Brake System
Indicator
(Amber)
•Comes on for a few seconds when
you set the power mode to ON,
then goes off.
• Comes on if there is a problem with
a system related to braking other
than the conventional brake
system.
• Comes on if there is a problem with
the cooperative control with
regenerative braking, the electric
servo brake system, or the hill start
assist system.• Comes on while driving - Have your
vehicle checked by an authorized Acura
NSX dealer.
• Stays on constantly - Avoid high speeds
and sudden braking. Take the vehicle to
an authorized Acura NSX dealer
immediately.
• With this indicator on, your vehicle still has
normal braking ability.
U.S.
Canada
(Amber)
U.S.
Canada
21 ACURA NSX PMC-31T6N6400.book 77 ページ 2020年10月8日 木曜日 午後3時7分
Page 80 of 494

78
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
POWER
SYSTEM
Indicator
• Comes on for a few seconds when
you set the power mode to ON,
then goes off.
• Comes on if there is a problem with
the electric vehicle system.• Comes on while driving - Have your
vehicle checked by an authorized Acura
NSX dealer immediately.
READY Indicator
•Comes on when the vehicle is ready
to drive.
2 Turning on the Power P. 325
Active Damper
System Indicator
•Comes on for a few seconds when
you change the power mode to
ON, then goes off.
• Comes on if there is a problem with
the Active Damper System. The
speed of the vehicle will be limited.• Stays on constantly - Have the vehicle
checked by an authorized Acura NSX
dealer. With this indicator on, your vehicle
has normal damping ability without the
active damper feature.
2 Integrated Dynamics System P. 340
Brake Wear
Indicator*
•Comes on for a few seconds when
you change the power mode to
ON, then goes off.
• Comes on if a worn brake pad is
detected.• Comes on while driving - The brake
pads may need to be replaced. Have your
vehicle inspected by an authorized Acura
NSX dealer.U.S.
Canada
U.S.
Canada
* Not available on all models
21 ACURA NSX PMC-31T6N6400.book 78 ページ 2020年10月8日 木曜日 午後3時7分
Page 81 of 494

79
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Malfunction
Indicator Lamp
•Comes on when you set the power
mode to ON, and goes off either
when the power system is on or
after several seconds if the power
system did not turn on. If
“readiness codes” have not been
set, it blinks five times before it
goes off.
• Comes on if there is a problem
with the emissions control system.
• Blinks when a misfire in the
engine’s cylinders is detected.• Readiness codes are part of the on board
diagnostics for the emissions control
systems.
2 Testing of Readiness Codes P. 477
•Comes on while driving - Have your
vehicle checked by an authorized Acura
NSX dealer.
• Blinks while driving - Stop in a safe
place where there are no flammable
objects. Stop the power system for 10
minutes or more, and wait for it to cool
down. Then, take the vehicle to an
authorized Acura NSX dealer.
2 If the Malfunction Indicator Lamp
Comes On or Blinks P. 456
•Comes on if there is a problem
with the gear shift mechanism.• Comes on and gear position indicator
blinks at the same time - Have your
vehicle checked by an authorized Acura
NSX dealer.
12-Volt Battery
Charging System
Indicator
• Comes on when you set the power
mode to ON, and goes off when
the power system is on.
• Comes on when the 12-volt
battery is not charging.• Comes on while driving - Turn off the
climate control system and rear defogger
in order to reduce electricity consumption.
2 If the 12-Volt Battery Charging
System Indicator Comes On P. 456
21 ACURA NSX PMC-31T6N6400.book 79 ページ 2020年10月8日 木曜日 午後3時7分