2020 SUZUKI JIMNY AC CON

FOR SAFE DRIVING
Floor mats (if equipped)
78RB05020
To prevent the driver's side floor mat from sliding forward and possibly interfering with the operation of the pedals, genuine SUZUKI floor mats are recommended. Whenever you put the driver's side floor mat back in the vehicle after it has been removed, hook the floor mat grommets to the fasteners and position the floor mat properly in the footwell.
When you replace the floor mats in your vehicle with a different type such as all­weather floor mats, we highly recommend to use genuine SUZUKI floor mats for proper fitting.
1-1
A. WARNING
Failure to take the following precau­tions may result in the driver's side floor mat interfering with the pedals and causing a loss of vehicle control or an accident. Check that the floor mat grommets are hooked to the fasteners. Never stack additional floor mats on top of the existing floor mat.

Front seats
A WARNING
Failure to take the following precau­tions may result in the driver's side floor mat interfering with the pedals and causing a loss of vehicle control or an accident. Check that the floor mat grommets are hooked to the fasteners. Never place additional floor mats on top of the existing floor mat.
Seat adjustment
A WARNING
Never attempt to adjust the driver's seat or seatback while driving. The seat or seatback could move unex­pectedly, causing loss of control. Check that the driver's seat and seat­back are properly adjusted before you start driving.
A WARNING
To avoid excessive seat belt slack, which reduces the effectiveness of the seat belts as a safety device, check that the seats are adjusted before the seat belts are fastened.
A WARNING
All seatbacks should always be in an upright position when driving, or seat belt effectiveness may be reduced. Seat belts are designed to offer maxi­mum protection when seatbacks are in the upright position.
A WARNING
Do not place any object under the front seat. If an object becomes caught under the front seat, the fol­lowing may occur. • The seat will not be latched.
A WARNING
Do not leave cigarette lighters or spray cans on the floor. If a cigarette lighter or spray can is on the floor, it may light accidentally when luggage is loaded or the seat is adjusted, causing a fire.
FOR SAFE DRIVING
1-2

A WARNING
Do not modify, remove, disassemble seat belts. Doing so may prevent them from functioning properly and cause the risk of severe injury or death in the event of a collision.
A WARNING
Never allow persons to ride in the cargo area of a vehicle. In the event of an accident, there is a much greater risk of injury for persons who are not riding in a seat with their seat belt securely fastened. Seat belts should always be adjusted as follows: -the lap portion of the belt should be worn low across the pelvis, not across the waist. -the shoulder straps should be worn on the outside shoulder only, and never under the arm. -the shoulder straps should be away from your face and neck, but not falling off your shoulder. (Continued)
FOR SAFE DRIVING
65D201
A WARNING
(Continued) • Seat belts should never be worn with the straps twisted and should be adjusted as tightly as is com­fortable to provide the protection for which they have been designed. A slack belt will provide less pro­tection than a snug belt. Check that each seat belt latch plate (tongue) is inserted into the proper buckle catch. It is possible to cross the buckles in the rear seat. (Continued)
1-8

FOR SAFE DRIVING
A. WARNING
(Continued) Pregnant women should use seat belts, although specific recommen­dations about driving should be made by the woman's medical advi• sor. Remember that the lap portion of the belt should be worn as low as possible across the hips, as shown in the illustration. Do not fasten your seat belt over hard or breakable objects in your pockets or on your clothing. If an accident occurs, objects such as glasses, pens, etc. under the seat belt can cause injury. (Continued)
1-9
A. WARNING
(Continued) • Never use the same seat belt for more than one occupant and never attach a seat belt over an infant or child being held on an occupant's lap. Such seat belt use could cause serious injury in the event of an accident. Periodically inspect seat belt assemblies for excessive wear and damage. Seat belts should be replaced if webbing becomes frayed, contaminated or damaged in any way. It is essential to replace the entire seat belt assembly after it has been worn in a severe impact, even if damage to the assembly is not obvious. Children aged 12 and under should ride properly restrained in the rear seat. Infants and small children should never be transported unless they are properly restrained. Restraint systems for infants and small chil• dren can be purchased locally and should be used. Check that the system you purchase meets appli• cable safety standards. Read and follow all the directions provided by the manufacturer. (Continued)
A. WARNING
(Continued) For child, if the seat belt irritates the neck or face, use a child restraint system appropriately for the child. The seat belts of your vehicle are principally designed for persons of adult size. Avoid contamination of seat belt webbing by polishes, oils, chemi• cals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. • Do not insert any items such as coins and clips into the seat belt buckles, and be careful not to spill liquids into these parts. If foreign materials get into a seat belt buckle, the seat belt may not work properly. All seatbacks should always be in an upright position when driving, or seat belt effectiveness may be reduced. Seat belts are designed to offer maximum protection when seatbacks are in the upright posi•
tion.

FOR SAFE DRIVING
60A039
To unfasten the seat belt, push the red "PRESS" button on the buckle and retract the belt slowly while holding the belt or/and the latch plate.
1-11
Lap-shoulder belt with detachable
connector (if equipped)
The rear lap-shoulder belt has a buckle, a latch plate and a detachable connector. The rear seat belt buckle and the connec­tor are designed so as not to allow a wrong latch plate to be inserted.
When the rear seatback is in the upright position, keep the detachable connector latched. Only when the rear seatback is folded down, unlatch the detachable con­nector. To latch and unlatch the connector, refer to "Unlatching and latching detach­able connector" in this section.
78RB02015
Fastening Before fastening the rear lap-shoulder belt, check the following precautions. The detachable connector (1) is securely
latched. The webbing is not twisted. The rear lap-shoulder belt is not put through the seat belt hanger.
To fasten the belt, sit up straight and far back into the seat, pull the latch plate (2) across your body and press it straight into the buckle (3) until you hear a click.

FOR SAFE DRIVING
A WARNING
To minimize risk of severe injury or death in the event of a collision, always fasten seat belt with both latches buckled.
1-13
Unlatching and latching detachable connector
Unlatching To unlatch the connector: 1) Insert a key into the slot (1) on the con­nector and allow the belt to retract. 2) Once the belt has completely retracted. stow the belt in the holder. Refer to "Stowing rear lap-shoulder belt"" for
details in this section.
Latching To latch the connector: 1) Pull the belt out from the holder.
78RB02017
2) Insert the connector latch plate (2) into the connector (3).
A WARNING
Check that the detachable connector is securely latched and the webbing is not twisted.

Driver's seat belt reminder If the driver's seat belt remains unbuckled when the ignition switch is turned to "ON" position, the reminder works as follows: 1) The driver's seat belt reminder light will come on. The front passenger's seat
belt reminder light will also come on if a front passenger does not fasten his/her seat belt. 2) After the vehicle's speed has reached about 15 km/h, the driver's seat belt reminder light will blink and a buzzer will sound for about 95 seconds. 3) The reminder light will remain on until the driver's seat belt is buckled. If the driver has buckled his or her seat belt and later unbuckles the seat belt, the reminder system will be activated from Step 1) or 2) according to the vehicle's speed. When the vehicle's speed is less than 15 km/h, the reminder will start from Step 1 ). When the vehicle's speed is more than 15 km/h, the reminder will start from Step 2). The reminder will be automatically can­celed when the driver's seat belt is buckled or the ignition switch is turned off.
Front passenger's seat belt reminder (if equipped) If there is a person sitting in the front pas­senger seat and the front passenger seat belt is unbuckled when the ignition switch is turned to "ON" position, the front pas­senger's seat belt reminder will activate. The front passenger's seat belt reminder works in the same manner as the driver's seat belt reminder.
NOTICE
The sensor of the front passenger's
seat belt reminder is located in the seat cushion. Therefore, if you spill liquid such as liquid aromatics1 soft drinks or juice on the front passen­ger's seat cushion, immediately wipe it dry with a soft cloth. Otherwise, the sensor of the front passenger's seat belt reminder can be damaged.
NOTE: If you put an object on the passenger's seat, the weight of the object will be sensed by the sensor and the front pas­senger's seat belt reminder light (if
equipped) will come on and then the interior buzzer may beep. ff a child or a sma/1 sized person sit on the front passenger's seat or the cushion is put on the front passenger's seat, the weight wi/1 not be sensed by the sensor and the interior buzzer may not beep.
FOR SAFE DRIVING
Rear passenger's seat belt reminder (if equipped) If there is a person sitting in the rear pas­senger seat and the rear passenger seat belt is unbuckled when the ignition switch is turned to "ON" position, the rear passen­ger's seat belt reminder will activate. The rear passenger's seat belt reminder works in the same manner as the driver's seat belt reminder.
NOTICE
The sensor of the rear passenger's seat belt reminder is located in the seat cushion. Therefore, if you spill liquid such as liquid aromatics, soft drinks or juice on the rear passen­ger's seat cushion, immediately wipe it dry with a soft cloth. Otherwise, the sensor of the rear passenger's seat belt reminder can be damaged.
NOTE: ff you put an object on the rear passen­ger's seat, the weight of the object will be sensed by the sensor and the rear pas­senger's seat belt reminder light (if equipped} wi/1 come on and then the interior buzzer may beep. ff a child or a small sized person sit on the rear passenger's seat or the cushion is put on the rear passenger's seat, the weight will not be sensed by the sensor and the interior buzzer may not beep.
1-16

FOR SAFE DRIVING
Seat belt hanger
NOTICE
When you move a seatback, make sure the belt webbing is hooked in the seat belt hangers so the seat belts are not caught by the seatback, seat hinge, or seat latch. This helps prevent damage to the belt system.
1-17
Seat belt inspection
65D209S
Periodically check if the seat belts work properly and are not damaged. Check the webbing, buckles, latch plates, retractors, anchorages and guide loops. Replace any seat belts which do not work properly ·or
are damaged.
A WARNING
Inspect all seat belt assemblies after any collision. Any seat belt assembly which was in use during a collision (other than a very minor one) should be replaced, even if damage to the assembly is not obvious. Any seat belt assembly which was not in use during a collision must be replaced if the airbags and the seat belt preten­sioners activated. The airbags, the pretensioners and the load limitter will only function once. In case they did not activate, consult with Suzuki dealer.