REAR VIEW MIRROR
Auto-dimming Mirror(if equipped)
When driving at night, the auto-dimming function
senses brightness from vehicle headlights behind you
and automatically dims to reduce glare. Pressing the
switch will turn this function on or off. A green LED
indicator on the switch will illuminate when the
function is on.
HomeLink®5 Accessory Mirror(if equipped)
The HomeLink®5 accessory mirror provides three
buttons to replace up to three hand-held radio
frequency remotes used to activate devices, such as
garage door openers, gate openers, entry door locks,
security systems and home lighting. Please see the
Owner’s Manual for programming instructions or visit
www.subaru.com/homelink to view a how-to video.
NOTE: HomeLink
®5 may not be compatible with some older door
openers or additional equipment may be required.
GETTING COMFORTABLE
10
CRUISE CONTROL
1RES:To resume your speed after
canceling, push the lever up to the “RES”
side.
2CANCEL:To cancel the cruise control,
pull the lever toward you, push the brake
pedal or press the “ON-OFF” button. If
you have a manual transmission, you can
push in the clutch pedal.
3SET:Press the accelerator pedal until your vehicle reaches the desired speed. Push
the lever down to the “SET” side and release. Ease off the accelerator pedal. Your
vehicle will maintain the desired speed.
4ON/OFF:To activate the cruise control, press the “ON-OFF” button. The cruise
control indicator light on the instrument panel will turn on. To deactivate cruise
control, press the “ON-OFF” button again.
Increase speed
Push the lever up to the “RES” side; hold until your vehicle reaches the desired speed and
release. To increase speed using the accelerator pedal, press the pedal until you reach the
desired speed. Push the lever down to the “SET” side to set the speed.
Decrease speed
Push the lever down to the “SET” side; hold until your vehicle slows to the desired speed
and release. To decrease the speed using the brake pedal, press the pedal to release
cruise control temporarily. When the speed decreases to the desired speed, push the lever
down to the “SET” side to set the speed.
LIGHT CONTROLS
1AUTO:If equipped, rotate the end of the
lever to automatically turn your headlights
on or off, depending on the level of
outside light.
2Daytime Running Lights:Rotate the end
of the lever to turn on the instrument
panel lights, parking lights, side marker
lights, tail lights, and license plate lights.
3Headlights:Rotate the end of the lever to
turn on the headlights, instrument panel
lights, parking lights, side marker lights,
tail lights, and license plate lights.
CONTROLS
16
4High Beams:Push the lever forward to change from low beam to high beam. Pull the
lever back to center to return to low beam. If equipped, this also activates the High
Beam Assist (HBA) system.
5Fog Lights:If equipped, rotate the dial to turn on the fog lights.
Illumination Brightness
While the light switch is on, rotating the dial on
the instrument panel upward will make the
illumination brighter. When the dial is fully
rotated upward (dots aligned), the instrument
panel illumination stays at full brightness.
Rotating the dial downward dims the
instrument panel illumination.
For map equipped vehicles this setting also
affects the day/night view and illumination
level.
Daytime Running Lights
The daytime running lights automatically turn on when the engine has started, the parking
brake is fully released, the light switch is in the Off, “AUTO” (if equipped) or “
”
position, and the select lever is not in the “P” position. Always turn on the headlights when
it’s dark outside by rotating the dial to the “
” or “AUTO” position.
TURN SIGNALS
Push slightly up for right lane change or fully
up for right turn signal. Push slightly down for
left lane change or fully down for left turn
signal.
CONTROLS
17
