2020 Seat Tarraco turn signal

General views of the vehicle
Overview (left hand drive) Electric windows
››
› page 109
Central locking ››› page 94
Exterior mirror adjustment ››› page 125
Open bonnet lever ››› page 338
Headlight switch ››› page 115
Turn signal and main beam lever
››› page 117
Cruise control ››› page 247
Warning lamps ››› page 84
1 2
3
4
5
6
7 Wipers and rear window wiper
› ›
› page 123
Driver information system ››› page 82
Infotainment system ››› page 86
Front passenger airbag disconnection
display ››› page 28
Fuses ››› page 59
Steering wheel adjustment ››› page 15
Starter button ››› page 217
Air conditioning ››› page 157
8 9
10
11
12
13
14
15 Hazard warning lights
››
› page 120 16
9

General views of the vehicle
Overview (right hand drive) Open bonnet lever
››
› page 338
Infotainment system ››› page 86
Front passenger airbag disconnection
display ››› page 28
Turn signal and main beam lever
››› page 117
Cruise control ››› page 247
Warning lamps ››› page 84
Wipers and rear window wiper
››› page 123
1 2
3
4
5
6 Driver information system
››
› page 82
Headlight switch ››› page 115
Central locking ››› page 94
Exterior mirror adjustment ››› page 125
Electric windows ››› page 109
Fuses ››› page 59
Hazard warning lights ››› page 120
Air conditioning ››› page 157
Starter button ››› page 217
Steering wheel adjustment ››› page 15 7
8
9
10
11
12
13
14
15
16
10

Fuses and bulbs
Bulbs Changing bulbs Full-LED headlights
Y
our v
ehicle is equipped with full-lead head-
light systems.
Full-LED headlights handle all light functions
(daylight, side light, turn signal, dipped beam
and route light) with light emitting diodes
(LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the car and light bulbs cannot be
replaced. In case of headlight failure, go to an
authorised workshop to have it replaced.
Side turn signals
The side turn signals are LEDS and are inte-
grated in the exterior mirrors.
In case of failure, go to an authorised work-
shop to have them replaced.
Additional brake light
Taking into account that it consists of LED
bulbs, the change should be made at a tech-
nical service centre.
63

Operation
Opening and closing Set of v ehicl
e keys
Vehicle key Fig. 71
Assignment of buttons on the remote
contr ol k

ey. Fig. 72
Vehicle key with alarm button. Key to the
››

› Fig. 71
,
››› Fig. 72 Unlock the vehicle
Lock the v

ehicle
Unlock only the rear lid. Press the button
until all the turn signals on the vehicle
flash briefly. You have 2 minutes to open
the rear lid. Once this time has passed, it
will lock again. In addition, the lamp on
the key flashes.
Folding the key shaft in and out
Alarm button*. Only press in the event of
an emergency! When the alarm button is
pressed, the vehicle's sounds and the turn
signals light up for a short time. Press
again to disconnect.
With the vehicle key the vehicle may be
locked or unlocked remotely ››› page 94
.
The vehicle key includes an emitter and bat-
tery. The receiver is in the interior of the vehi-
cle. The range of the vehicle key with remote
control and new battery is several metres
around the vehicle.
If it is not possible to open or close the vehicle
using the remote control key, this should be
re-synchronised ››› page 94
or the battery
changed ››› page 93
.
Different keys belonging to the vehicle may
be used. 1 2
3
4
5 Control lamp on the vehicle key
When a butt
on on the v
ehicle key is pressed,
the control lamp flashes ››› Fig. 71
(arrow)
once briefly, but if the button is held down for
a longer period the control lamp flashes sev-
eral times, such as in convenience opening.
If the vehicle key control lamp does not light
up when the button is pressed, replace the
key's battery ››› page 93
.
Spare key
To obtain a spare key and other vehicle keys,
the vehicle ID number is required.
Each new key contains a microchip which
must be coded with the data from the vehicle
electronic immobiliser. A vehicle key will not
work if it does not contain a microchip or the
microchip has not been encoded. This is also
true for keys which are specially cut for the
vehicle.
The vehicle keys or new spare keys can be
obtained from a SEAT Official Service, a spe-
cialised workshop or an approved key service
qualified to create this kind of key.
New keys or spare keys must be synchronised
before use ››› page 94
. WARNING

Operation
Audible warnings to advise the driver that
the lights hav e not been s
witched off
If the ignition is not connected and the driver
door is open, an audible warning signal is
heard in the following cases: this will remind
you to turn the light off.

Lights
Turn signal and main beam lever Fig. 94
Turn signal and main beam lever. More the lever to the required position:
Right t urn light or right
-hand parking light
(ignition switched off).
Left turn light or left-hand parking light
(ignition switched off).
Turning main beam headlights on: control
lamp  lit up on the instrument panel.
The headlight flasher comes on while we
pull the lever. Control lamp  lit up.
Place the lever in rest position to turn off the
corresponding function.
Convenience turn signals
When the ignition is switched on, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times. 1 2
3
4 The convenience turn signals are switched on
and off in the inf
ot

ainment system by means
of the function button  ! SETTINGS ! Light ! Light Assist ! Convenience
turn signals
››› page 90
.
In vehicles that do not have the correspond-
ing menu, this function can be deactivated in
a specialised workshop.
Parking light 
The parking lights will only work with the igni-
tion off. If said light is on, an audible warning
will sound while the driver door is open.

Driver assistance systems
Operating the speed limiter with
the t urn signal l
everFig. 181
On the turn signal lever: buttons to op-
er at

e the speed limiter. Connecting

Driving
Avoid undertaking on the right 1)
If a v ehicl
e is detected in the left lane that is
travelling at a speed slower than that set by
the driver, it will brake the vehicle within the
comfort limits of the system to avoid passing
it on the right ››› Fig. 187
.
You can cancel this regulation by changing
the set speed or by pressing the accelerator
pedal.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
Overtaking
When the turn signal is switched on for over-
taking, the ACC reduces the distance from
the vehicle in front to help with the overtaking
manoeuvre. The set cruising speed will not be
exceeded.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
Stop&Go function
 Valid for: vehicles with an automatic gearbox
The ACC can bring the vehicle to a standstill
(0 km/h) if the vehicle in front stops. The ACC remains active and the message
ACC ready to start is displayed on the in-
strument clust
er for a few seconds. You can
extend or reactivate this warning by pressing
the button  or, depending on your vehicle’s equipment, by grabbing the steering wheel.
During this time, the vehicle will move off
again if the vehicle in front moves forwards.
To move off when the message ACC ready
to start is not longer displayed, once the
vehicle in front has moved off: