2020 Seat Tarraco infotainment

Infotainment system
and receive SMS and e-mails through the tel-
ephone int erf
ace.
Send an SMS

Infotainment operation

Infotainment system
Multimedia USB por t Fig. 159
Centre console: USB port. Fig. 160
Rear part of the centre console: USB
connect ors with po
wer outlet function. The USB port can be found in the storage
compartment ar
ea of the fr

ont centre con-
sole ››› Fig. 159
. Depending on the equipment and the coun-
try, the vehicl

e may also have USB connec-
tions exclusively for charging or as a power
socket.
These USB ports are located at the rear of
the console, between the front seats
››› Fig. 160.
216

Driving
turning the Driving Experience button or se-
l
ect fr
om the infotainment display.

Driving
Switching distance warning on and off
The dist ance w
arning can be switched on or
off in the infotainment system using the func-
tion button  ! SETTINGS ! Driver as-
sistance ››› page 90
.
The system will store the setting for the next
time the ignition is switched on.
SEAT recommends keeping the distance
warning active.
Deactivating Front Assist tempora-
rily in the foll
owing situationsIn the following situations the Front Assist
shoul
d be deactiv

ated due to the system's
limitations:

Driver assistance systems
ACC detects it and adapts the speed au-
t omatically, maint
aining a distance set by
the driver.
Does my vehicle have ACC?
Your vehicle has ACC if it has a configuration
menu in the infotainment system ››› page 90
and if it has the ACC function buttons on the
multifunction steering wheel ››› Fig. 185
.
Speed range
ACC regulates speeds between 30 km/h (20
mph) and 210 km/h (130 mph). 1)
If the vehicle is fitted with an automatic gear-
box, the ACC can bring the vehicle to a
standstill if a vehicle in front of it stops.
If your vehicle is fitted with a manual gearbox,
you must pay attention to speed and gear
changes. The ACC is deactivated if the
speed is too low (less than 30 km/h) of the
engine RPM is too low or high.
Driver intervention prompt ACC is subject to certain limitations in-
herent to the system. This means that
the driver will have to control the speed
and distance from other vehicles in cer-
tain situations. In this case, the instru-
 ment cluster display will tell you t
o in-
tervene by applying the brake, and an
audio warning will be played.
Radar sensors
The ACC uses the front radar technology.
Read its maintenance instructions and infor-
mation about its limitations ››› page 243
. WARNING
The ACC’s technology cannot overcome
the syst em's inher

ent limitations or change
the laws of physics. If used negligently or
involuntarily, it may cause serious acci-
dents and injuries. The system is not a re-
placement for driver awareness.

Driver assistance systems
accelerator pedal. ACC regulation is suspen-
ded until you r el
ease the accelerator pedal
››› .
Set the def ault dist

ance setting
In the Infotainment system, you can pre-se-
lect the distance level when connecting the
ACC from:

Driving
Lane line detected. The system does not
int erv
ene.
Switching the lane assist system on or off
In some countries, the Lane Assist System is
always activated when the ignition is switch-
ed on. The connection status is shown in the
Driver assistance menu of the Infotainment
system or the driver assistance systems menu
after pressing the corresponding button. The
Lane Assist system can be activated and de-
activated in these menus.
The Lane Assist system is ready to actively in-
tervene as of approximately 60 km/h (35
mph) and if it has detected the lane limits
(system status: active). The control lamp