Page 272 of 405
Driving
The control lamps light up when the ignition is
s wit
ched on and should turn off after approxi-
mately 2 seconds. This is the time taken for
the function check.
If there are no indications from the control
lamp of the lane departure warning, this
means that the lane departure warning has
not detected any other vehicles at the rear
area ››› .
When the e xt
erior lighting is low, the intensity
with which the control lamps come on is dim-
med. The user can modify the intensity of the
control lamps with up to 5 levels in the info-
tainment system menu. WARNING
If the warning lamps and the corresponding
messages ar e ignor
ed when they light up,
the vehicle may stall in traffic and cause
accidents and severe injuries.
Page 287 of 405

Help with parking and manoeuvring
way, the system will require fewer manoeu-
vr es t
o complete the parking action.
Trailer mode
The Park Assist system cannot be switched
on if the factory-fitted towing bracket
››› page 306 is electrically connected to a
trailer.
After changing a wheel
If, after changing a wheel, the vehicle stops
entering and exiting parking spaces correct-
ly, the circumference of the new wheel may
be different and the system may need to
adapt to it. The adaptation is automatic and
takes place during driving. Making turns slow-
ly and in both directions (20 km/h [12 mph])
for a few minutes may contribute to this
adaptation process ››› in Introduction on
page 282. Selecting a parking mode Fig. 202
On the instrument panel display:
vie w of the parking assist syst
em with reduced
view. Fig. 203
On the instrument panel display: in-
dication of parking modes. Parking assist has the following 3 parking
modes:Reverse parallel parking.
R
e
verse angle parking.
Forward angle parking.
Selecting a parking mode after passing in
front of the space
After activating the Park Assist system and af-
ter detecting a parking space, the display on
the instrument panel proposes a parking
mode. The Park Assist system selects the
parking mode automatically. The selected
mode is shown on the instrument panel dis-
play ››› Fig. 202
. The reduced display of oth-
er possible parking modes is also shown
››› Fig. 203. If the mode selected by the sys-
tem does not correspond to the desired
mode, you can select another mode by
pressing the
Page 292 of 405
Driving
Assistance systems are not a replacement
f
or driv
er awareness. Responsibility always
lies with the driver.
Page 295 of 405

Help with parking and manoeuvring
A wake will indicate the anticipated forward
or backw ar
d trajectory, depending on the en-
gaged gear.
If an obstacle is located in the vehicle’s way,
the corresponding audible warning will
sound.
When the penultimate segment is displayed,
the vehicle has reached the collision zone. In
the collision zone, the obstacles are repre-
sented in red (including those out of the
path). Stop the vehicle! ››› in Introduction
on page 289, ››
› in Introduction on
page 290 !
In the e v
ent the car is equipped with the Top
View Camera system, Park Assist visual guid-
ance will appear in accordance with the view
selected in the Top View Camera system.
Setting the indications and audio
signals The audio indications and signals are set in
the inf
ot
ainment system ››› page 86
: Setup
Automatic activa-
tion On/off
Front volume* Volume in the front and rear
area.
R
ear volume* Volume in the rear area. Setup
Adjust volume When the parking aid is
s
wit
ched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option.
Front sound set-
tings/sharpness* Sound tone in the front area.
Rear sound set-
tings/sharpness* Sound tone in the rear area. Error messages
If a an error or fault message appears on the
instrument clust
er in P
ark Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
area A are displayed
››
› Fig. 207
. If a front
sensor is faulty, only the obstacles in area B are displayed. Symbol
Page 298 of 405

Driving
Whenever the obstacle is located in the vehi-
cl e
’s direction of travel, the corresponding
audible warning will sound.
As the vehicle approaches an obstacle, the
segments are displayed closer to the vehicle.
When the penultimate segment is displayed,
this means that the vehicle has reached the
collision zone. In the collision zone, the obsta-
cles are represented in red (including those
out of the path). Do not continue to reverse
››› in Introduction on page 289,
››
› in
Intr oduction on page 290
!
If you are equipped with the Top View
Camera*
Segments are not displayed when the vehicle
is equipped with Top View Camera*.
The Parking Aid system will issue an audible
warning for objects that are near the rear of
the vehicle, and the Top View Camera* im-
age will be available on the screen, giving a
real image of the objects around the car.
Trailer Assist
Introduction Trailer assist helps the driver to reverse and
manoeuvr
e with a tr
ailer. By moving the rotary knob of the exterior mir-
rors, the tr
ailer assist directs the trailer that is
hitched. The driver has to accelerate, change
gears and brake!
System limitations
Under certain circumstances, the camera
does not detect objects such as trailer draw
bars, bars, fences, posts or thin trees, or an
open (or opening) rear lid, which could dam-
age the vehicle.
In order to guarantee good system operation,
keep the camera clean, free of snow or ice,
and do not cover it with adhesives or other
objects. Do not allow the draw bar to be cov-
ered by external influences.
Use the trailer manoeuvre assistant only
when the rear lid is closed correctly. CAUTION
The trailer maneuver assistant does not
t ak
e the vehicle’s surrounding as a refer-
ence. No obstacle detection takes place.
The driver alone has to assess whether it is
possible to manoeuvre safely with the tow
vehicle and trailer set.
Page 320 of 405

Practical tips
Incorrect handling of the high-voltage
batt ery can cause serious injuries or
death. Maint
enance work on the high-
voltage battery must only be performed
by specialized personnel with the corre-
sponding qualifications and training. Nev-
er modify the high-voltage battery. When
the high-voltage battery is open, ensure it
does not come into contact with water or
other liquids. Liquids may cause short cir-
cuits, electrical shocks and burns.
Conservation of the high-
volt
age battery
Conservation instructions V
alid f
or: hybrid vehicles
Reliability and capacity of the high-volt-
age battery
Lithium ion batteries are subject to ageing
and wear and tear throughout their useful life
due to their physical and chemical charac-
teristics. Correct handling of the high-voltage
battery makes an essential contribution to
keeping it in a reliable state in the long term
and to achieving high battery capacity and
range. Therefore, it is extremely important to
respect the following conservation instruc-
tions for the high voltage battery. These 7 maintenance instructions are essential for
maint
aining the v
ehicle's value over time.
Please also observe the applicable SEAT
warranty conditions for the high-voltage bat-
tery.
Conservation instructions
SEAT recommends the following conserva-
tion instructions:
Page 345 of 405

Checking and refilling levels
The position of the oil filler opening is shown
in the corr esponding engine compartment il
-
lustration ››› page 340
.
Engine oil specification ››› page 340
. WARNING
Oil is highly inflammable! Ensure that no oil
comes int o cont
act with hot engine compo-
nents when topping up. CAUTION
If the oil level is above area ››
› Fig. 241
A ,
do not st ar
t the engine. This could result in
damage to the engine and catalytic con-
verter. Contact a specialised workshop. For the sake of the environment
The oil level must never be above zone
› ›
› Fig. 241
A . Otherwise oil can be drawn in
thr ough the cr
ankcase breather and leak
into the atmosphere via the exhaust sys-
tem. Note
Before a long trip, we recommend finding
an engine oil that conf orms t
o the corre-
sponding VW specifications and recom-
mend keeping it in the vehicle. This way, the
correct engine oil will always be available
for a top-up if needed. Engine oil change
We recommend that you have the engine oil
changed by a T
echnical Service
. WARNING
Only change the engine oil yourself if you
hav e the specialist kno
wledge required!
Page 370 of 405

Maintenance
Washing the vehicle The longer you take to clean the tanks, e.g.
r
emains of insects, bir
d excrements, tree resin
or anti frost salt adhered to your vehicle, the
more damage it can cause to the surface.
High temperatures, for instance strong sun-
light, further intensify the damage.
Before washing the car, soften the dirt using
plenty of water.
To remove encrusted dirt such as insects, bird
droppings or tree resin, use a lot of water and
a microfibre cloth.
Have the underside of the vehicle washed af-
ter the end of the anti frost salts in winter.
High pressure cleaning equipment
When washing the vehicle with a high-pres-
sure cleaner, always follow the operating in-
structions for the equipment. This applies
particularly to the operating pressure and the
distance between the spraying water. Do not
aim the jet directly to the side window gas-
kets, doors, covers or the panoramic sun-
roof*; the same applies to tyres, rubber ho-
ses, soundproofing material, sensors* or
camera lenses*. Keep a distance of at least
40 cm.
Do not remove snow and ice with a high-
pressure cleaner. Do not use a nozzle that sprays the water out
in a dir
ect str
eam or one that has a rotating
jet for forcing off dirt.
The water temperature must not exceed
60°C.
Automatic car washes
Spray the vehicle before starting the car
wash.
Make sure that the windows and the panor-
amic sunroof* are closed and the windscreen
wipers are deactivated. Bear in mind the in-
structions of the car wash tunnel operator,
especially if your vehicle has detachable
parts.
Use of car washes without brushes if possible.
Washing by hand
Clean your vehicle from top to bottom with a
soft sponge or with a brush. Only use clean-
ing products that do not contain solvents.
Washing vehicles with a matte paint by
hand
To prevent damage to the vehicle when
washing it, first remove the thicker dust and
dirt. To remove traces of insects, grease and
fingerprints, it is best to use a special cleaner
for matte paint. Apply the product with a microfibre cloth. To
avoid damaging the surf
ace of the paint, do
not apply too much pressure.
Rinse with plenty of water. Then clean it with
a neutral cleaning product and a soft microfi-
bre cloth.
Rinse the vehicle again with plenty of water
and then leave it to dry. Remove traces of
water with a leather cloth. WARNING