2020 Seat Ibiza turn signal

General views of the vehicle
Overview (left hand drive) Electric windows
››
› page 110
Exterior mirror adjustment ››› page 124
Open bonnet lever ››› page 265
Headlight switch ››› page 115
Turn signal and main beam lever
››› page 117
Cruise control ››› page 213
Warning lamps ››› page 84
Wipers and rear window wiper
››› page 122
1 2
3
4
5
6
7 Driver information system
››
› page 82
Infotainment system ››› page 86
Hazard warning lights ››› page 119
Fuses ››› page 55
Steering wheel adjustment ››› page 15
Ignition lock ››› page 191
Air conditioning ››› page 140
Starter button ››› page 192
Central locking ››› page 98
8 9
10
11
12
13
14
15 Front passenger airbag disconnection
displ
ay
›
›› page 26 16
9

General views of the vehicle
Overview (right hand drive) Open bonnet lever
››
› page 265
Infotainment system ››› page 86
Hazard warning lights ››› page 119
Turn signal and main beam lever
››› page 117
Cruise control ››› page 213
Warning lamps ››› page 84
Wipers and rear window wiper
››› page 122
Driver information system ››› page 82
1 2
3
4
5
6 Headlight switch
››
› page 115
Exterior mirror adjustment ››› page 124
Electric windows ››› page 110
Central locking ››› page 98
Air conditioning ››› page 140
Starter button ››› page 192
Front passenger airbag disconnection
display ››› page 26
Steering wheel adjustment ››› page 15
Ignition lock ››› page 191
7 8
9
10
11
12
13
14
15 Fuses
››
› page 55 16
10

Safety
Operation of the airbags Airbag syst em contr
ol lampsT
It lights up on the combi-instru-
ment
Fault in the airbag system and seat belt tensioners .
Have the syst
em checked immediately by a special-
ised workshop.  
It lights up on the dash panel
Fault in the airbag system.
Hav e the syst

em checked immediately by a special-
ised workshop.
Front passenger front airbag deactivated.
Check if the airbag shoul d be k

ept deactivated x
It lights up on the dash panel
Front passenger front airbag activated.
The control l
amp turns off automatically 60 seconds
after the ignition is switched on Several warning and control lamps light up
f
or a f

ew seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
If the airbag and seat belt tensioner system
control lamp T remains on or flashes, it indi-
cates a malfunction in the airbag and seat
belt tensioner system ››› . Have the systemchecked immediately by a specialised work-
shop
.
If the fr

ont passenger airbag is deactivated,
the warning lamp      re-
mains lit on the dash panel to remind you that
the airbag is deactivated. If, with the front
passenger airbag deactivated, this lamp
does not remain lit or if it is lit along with the
control lamp T on the instrument panel,
there is a fault in the airbag system ››› . If
the contr ol l

amp is flashing, there is a fault in
the disabling of the airbag system ››› . Have
the syst em check

ed immediately by a speci-
alised workshop. WARNING
In the event of a fault in the airbag and seat
belt t ensioner syst

em, the airbags and seat
belts may not trigger correctly, may fail to
trigger or may even trigger unexpectedly.

Operation
Opening and closing Set of v ehicl
e keys
Vehicle key Fig. 81
Assignment of buttons on the remote
contr ol k

ey. Fig. 82
Vehicle key with alarm button. Key to the
››

› Fig. 81
,
››› Fig. 82 Unlock the vehicle
Lock the v

ehicle
Unlock only the rear lid. Press the button
until all the turn signals on the vehicle
flash briefly. You have 2 minutes to open
the rear lid. Once this time has passed, it
will lock again. In addition, the lamp on
the key flashes.
Folding the key shaft in and out
Alarm button*. Only press in the event of
an emergency! When the alarm button is
pressed, the vehicle's sounds and the turn
signals light up for a short time. Press
again to disconnect.
With the vehicle key the vehicle may be
locked or unlocked remotely ››› page 98
.
The vehicle key includes an emitter and bat-
tery. The receiver is in the interior of the vehi-
cle. The range of the vehicle key with remote
control and new battery is several metres
around the vehicle.
If it is not possible to open or close the vehicle
using the remote control key, this should be
re-synchronised ››› page 98
or the battery
changed ››› page 97
.
Different keys belonging to the vehicle may
be used. 1 2
3
4
5 Control lamp on the vehicle key
When a butt
on on the v
ehicle key is pressed,
the control lamp flashes ››› Fig. 81
(arrow)
once briefly, but if the button is held down for
a longer period the control lamp flashes sev-
eral times, such as in convenience opening.
If the vehicle key control lamp does not light
up when the button is pressed, replace the
key's battery ››› page 97
.
Spare key
To obtain a spare key and other vehicle keys,
the vehicle ID number is required.
Each new key contains a microchip which
must be coded with the data from the vehicle
electronic immobiliser. A vehicle key will not
work if it does not contain a microchip or the
microchip has not been encoded. This is also
true for keys which are specially cut for the
vehicle.
The vehicle keys or new spare keys can be
obtained from a SEAT Official Service, a spe-
cialised workshop or an approved key service
qualified to create this kind of key.
New keys or spare keys must be synchronised
before use ››› page 98
. WARNING

Driving
Introduction Fig. 149
Instrument panel display: GRA status
indications. The cruise control system (CCS) is able to
maint
ain the set speed fr
om 20 km/h (15
mph).
The CSS only reduces vehicle speed by
ceasing to accelerate, not by actively braking
the vehicle ››› .
Depending on the equipment, the cruise con-
tr ol can be oper

ated using the lever of the
turn signals ››› page 215
or by the third lever
››› page 215.
Status display
GRA status ››› Fig. 149 CCS temporarily switched off. The set
speed is displayed in small or dark

ened
figures.
System error. Contact a specialised
workshop.
CCS switched on. The speed memory is
empty.
The CCS is switched on. The set speed is
displayed in large figures.
Changing gear in CCS mode
The CCS decelerates as soon as the clutch
pedal is pressed, intervening again automati-
cally after a gear is engaged.
Travelling down hills with the CCS
If the CCS cannot maintain a constant vehi-
cle speed downhill, brake and change down
a gear if necessary. The GRA is temporarily
disabled by pressing the brake.
Automatic off
The GRA disconnects automatically or is
temporarily interrupted:

Driver assistance systems
Operating the cruise control with
the t urn signal l
everFig. 150
On the turn signal lever: controls for
oper ating the GRA. Connecting

Driving
Operating the speed limiter with
the t urn signal l
everFig. 153
On the turn signal lever: buttons to
oper at

e the speed limiter. Connecting

Driving
You can cancel this regulation by changing
the set speed or by pr essing the accel
erator
pedal.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
Overtaking
When the turn signal is switched on for over-
taking, the ACC reduces the distance from
the vehicle in front to help with the overtaking
manoeuvre. The set cruising speed will not be
exceeded.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
Stop&Go function
 Valid for: vehicles with an automatic gearbox
The ACC can bring the vehicle to a standstill
(0 km/h) if the vehicle in front stops.
The ACC remains active and the message
ACC ready to start is displayed on the in-
strument cluster for a few seconds. During
this time, the vehicle will move off again if the
vehicle in front moves forwards.
If the vehicle in front does not move off, the
vehicle can be kept at a standstill with the
status ACC ready to start by pressing the
brake. The system can only keep the car stopped
for a f
ew seconds. After this, the Brake warn-
ing will be displayed and an audio warning
will be played. Press the brake pedal. The ve-
hicle may start moving forward if you do not
do this Accident hazard!
The ACC is deactivated while stopped in the
following cases: