Page 284 of 353
282Vehicle careSide turn lights1. Push the lamp assembly to the right and pull at the left-hand side
of the lamp assembly to release
from the aperture.
2. Detach wiring connector from lamp assembly.
3. Remove bulb holder from lamp assembly by rotating 90° and
renew bulb.
4. Install bulb holder in lamp assembly.
5. Attach wiring connector to lamp assembly.
6. Insert lamp assembly into aperture and push to the left to
secure.
Mirror turn lights 1. Move the lower mirror assembly from the front to access the screw.
2. Remove the screw using a torx screwdriver.
3. Remove bulb holder from the rear
of the lower mirror assembly.
4. Renew bulb.
5. Install bulb holder in lower mirror assembly.
6. Replace the screw.
Centre high-mounted brake light
1. Remove cover from the inside of the rear door.
2. Unscrew the nut from the locating
pin at the rear of the lamp
assembly.
Page 285 of 353
Vehicle care283
3. Remove the lamp assembly fromthe aperture on the outer side.
4. Detach wiring connector from lamp assembly.
5. Remove bulb holder from lamp assembly and renew bulb.
6. Install bulb holder in lamp assembly and reattach wiring
connector to lamp assembly.
7. Replace lamp assembly into aperture, ensuring that it is seated
correctly.
8. Replace the nut onto the locating pin on the rear of the lamp
assembly.
9. Install cover on the inside of the rear door.
Number plate light
1. Unclip lamp assembly using a flat
blade screwdriver.
2. Detach wiring connector from lamp assembly.
3. Remove lens cover and renew bulb.
4. Install lens cover and attachwiring connector to lamp
assembly.
5. Install lamp assembly.
Crew Cab, Chassis Cab
1. Remove the two screws from the lens cover.
2. Remove lens cover and renew bulb.
3. Install the lens cover and replace the two screws.
Page 286 of 353
284Vehicle careInterior lightsLED lights
Have lights repaired by a workshop in case of failure.
Front courtesy light
1. Remove lamp assembly using a flat blade screwdriver.
2. Renew bulb.
3. Install lamp assembly.
Load compartment light
1. Remove lamp assembly using a flat blade screwdriver.
2. Detach wiring connector from lamp assembly.
3. Remove lens cover and renew bulb.
4. Install lens cover and attach wiring connector to lamp
assembly.
5. Install lamp assembly.
Front door panel light
1. Remove lamp assembly using a flat blade screwdriver.
2. Rotate bulb holder anticlockwise to disengage.
3. Renew bulb and insert the bulb holder.
4. Install lamp assembly.
Rear courtesy lights
Have bulbs replaced by a workshop.
Glovebox light
Have bulbs replaced by a workshop.
Page 287 of 353

Vehicle care285Instrument panel
illumination
Have bulbs replaced by a workshop.Electrical system
Fuses Data on the replacement fuse must
match the data on the defective fuse.
There are two fuse boxes in the
vehicle:
● on the left-hand side of the instrument panel, behind the trim
panel
● in the engine compartment located below the coolant
expansion tankCombi
An additional fuse box is located
behind a trim panel on the right-hand
side of the load compartment, beside the rear door.Bus
An additional fuse box is located on
the lower right-hand side of the load
compartment, below the step trim
panel.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its melted wire.
Caution
Do not replace the fuse until the
cause of the fault has been
remedied.
It is advisable to carry a full set of
fuses. Consult a workshop.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.
Note
Not all fuse box descriptions in this
manual may apply to your vehicle.
When inspecting the fuse box, refer
to the fuse box label.
Fuse extractor
A fuse extractor may be located in the
instrument panel fuse box. The
extractor has two sides, each side is
designed for a different type of fuses.
Page 336 of 353

334Body conversionsToolbox
Unlock using the key provided and
turn latches to open.
Close the door and turn both latches,
then lock with the key.
Caution
Ensure the toolbox door is
properly secure before setting off.
Exterior lighting
Additional exterior lights illuminate in
combination with the side lights.
Have bulbs replaced by a workshop.
Cleaning Dirt or mud which remains dry on thebody may become abrasive and can
damage paint, seals, locks and
hinges.
Clean the following parts if they
become contaminated with dirt:
● Sideboard and tailboard locking latches and hinges.
● Tipper body pivot pins and locating holes.Caution
Do not spray high-pressure water
directly at the hydraulic seals,
pump, reservoir, hydraulic ram ball
joints, or guide clamps.
After cleaning, check, and if
necessary lubricate the components
listed in the owner's checks.
9 Warning
Do not venture under the tipper
body when raised.
Vehicle checks
Check regularly the following items: ● Visually check the subframe mountings, the safety cables andthe hydraulic system. If any of the
Page 341 of 353
Body conversions339Interior lighting
Press switch: light will operate for
approx. 10 minutes.
Bulb replacement
1. Release screws using a suitable screwdriver and remove lens.
2. Remove and replace bulb.
3. Refit lens and secure screws.
Crew van
Child restraint systems9 Warning
Child restraint systems must not
be installed to any position on the
rear passenger seat.
Child restraint systems 3 65.
Storage
Storage compartments, pockets and
nets are located in the rear passenger compartment.
Page 345 of 353

343Battery.................... 21, 22, 216, 274
Battery discharge protection ......117
Battery, jump starting.................. 304
Battery replacement ...................166
Belts.............................................. 55 Bluetooth .................................... 193
Bluetooth connection ..........156, 197
Bluetooth device list ...................197
Bluetooth music .......................... 156
Bonnet ....................................... 270
Bottle holders................................ 74
Brake assist ............................... 246
Brake fluid .......................... 274, 313
Brakes ............................... 244, 274
Brake system ............................. 100
Breakdown.................................. 306
Browse map................................ 183
Bulb replacement ....................... 277
Bus Rear seats ................................. 52
C Cabin bulkhead grille ....................80
Call lists ...................................... 201
Call waiting ................................. 201
Capacities .................................. 317
Cargo management system ........78
Car Pass ...................................... 21
Catalytic converter .....................234
Central locking system ................24Centre high-mounted brake light 282
Change Home location ...............166
Change passkey for Bluetooth connection ............................... 197
Change system language ...129, 139
Changing tyre and wheel size ...295
Charging system .......................... 99
Child locks ................................... 29
Child restraint installation locations ................................... 67
Child restraints.............................. 65
Child restraint systems ........65, 339
Cigarette lighter ........................... 91
Cleaning ..................................... 334
Cleaning the vehicle ...................308
Climate control ............................. 16
Climate control systems .............208
Clock ................... 88, 129, 139, 166
Coat hooks ................................... 74
Compass .................................... 166
Connecting an audio device .......156
Connection ................................. 195
Control elements overview .........122
Control indicators.......................... 95
Control of the vehicle .................225
Controls ........................................ 85
Convex shape .............................. 38
Coolant ....................................... 272
Coolant and antifreeze ...............313
Coolant heater ............................ 216Co-ordinates....................... 166, 177
Country information ............183, 200
Cruise control ....................103, 249
Cupholders .................................. 74
D DAB ............................................ 151
Danger, Warnings and Cautions ...4
Dashboard .................................... 11
Data sharing settings ..................129
Daytime running lights ...............113
Daytime running lights setting ....129
Deactivating Bluetooth function ..197
Deactivating guidance ................183
Declaration of conformity ....319, 335
DEF ............................................ 234
Defining the priority phone .........195
Delete a favourite destination .....177
Delete device from Bluetooth device list ................................ 197
Demisting and defrosting ..............16
Destination.................................. 166
Destination input ........................177
Dialling a telephone number .......201
Diesel exhaust fluid ....................234
Diesel fuel ................................... 262
Diesel fuel system bleeding .......276
Diesel particle filter ....................233
Digital audio broadcasting ..........151
Disconnecting an audio device ...156