729
Maintenance
Check the condition and connections
of all cooling system hoses and
heater hoses. Replace any swollen
or deteriorated hoses.
The coolant level should be filled
between F and L marks on the side
of the coolant reservoir when the
engine is cool.
If the coolant level is low, add enough
specified coolant to provide protec-
tion against freezing and corrosion.
Bring the level to F, but do not over-
fill. If frequent additions are required,
see an authorized Kia dealer for a
cooling system inspection.
Recommended engine coolant
When adding coolant, use onlydeionized water or soft water for
your vehicle and never mix hard
water in the coolant filled at the fac-
tory. An improper coolant mixture
can result in serious malfunction or
engine damage.
The engine in your vehicle has alu- minum engine parts and must be
protected by an ethylene-glycol
with phosphate based coolant to
prevent corrosion and freezing.
DO NOT USE alcohol or methanol coolant or mix them with the spec-
ified coolant.
Do not use a solution that contains more than 60% antifreeze or less
than 35% antifreeze. This would
reduce the effectiveness of the
solution.
OJF075006
WARNING- Cooling fan
Use caution when working near
the blade of the cooling fan. The
electric motor (cooling fan) is
controlled by engine coolant
temperature, refrigerant pres-
sure and vehicle speed. it may
sometimes operate even when
the engine is not running.
JFa PE USA 7.qxp 5/15/2019 3:12 PM Page 29
Maintenance
32
7
WASHER FLUID
Checking the washer fluid
level
The reservoir is translucent so that
you can check the level with a quick
visual inspection.
Check the fluid level in the washer
fluid reservoir and add fluid if neces-
sary. In warm climate, plain water
may be used if washer fluid is not
available; however, in cold climates
washer fluid with anti-freezing char-
acteristics is required to prevent
freezing.
WARNING- Flammable
fluid
Do not allow the washer fluid to
come in contact with open
flames or sparks. The windshield
washer fluid reservoir is flamma-
ble under certain circumstances.
This can result in a fire.WARNING- Windshield fluid
Do not drink the windshield
washer fluid. The windshield
washer fluid is poisonous to
humans and animals.
WARNING- Coolant
Do not use radiator coolant or antifreeze in the washer fluid
reservoir.
Radiator coolant can severely obscure visibility when sprayed
on the windshield and may
cause loss of vehicle control.
OJF075009
JFa PE USA 7.qxp 5/15/2019 3:13 PM Page 32
Maintenance
54
7
Temperature -A, B & C
The temperature grades are A (the
highest), B and C representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled condi-
tions on a specified indoor laboratory
test wheel.
Sustained high temperature can
cause the material of the tire to
degenerate and reduce tire life, and
excessive temperature can lead to
sudden tire failure. The grade C cor-
responds to a level of performance
which all passenger car tires must
meet under the Federal Motor
Vehicle Safety Standard No. 109.
Grades B and A represent higher
levels of performance on the labora-
tory test wheel than the minimum
required by law. Tire terminology and definitions
Air Pressure:
The amount of air
inside the tire pressing outward on
the tire. Air pressure is expressed in
kilopascal (kPa) or pounds per
square inch (psi).
Accessory Weight: This means the
combined weight of optional acces-
sories. Some examples of optional
accessories are, automatic transmis-
sion, power seats, and air condition-
ing.
Aspect Ratio: The relationship of a
tire's height to its width.
Belt: A rubber coated layer of cords
that is located between the plies and
the tread. Cords may be made from
steel or other reinforcing materials.
Bead: The tire bead contains steel
wires wrapped by steel cords that
hold the tire onto the rim.
Bias Ply Tire: A pneumatic tire in
which the plies are laid at alternate
angles less than 90 degrees to the
centerline of the tread. Cold Tire Pressure:
The amount of
air pressure in a tire, measured in
kilopascals (kPa) or pounds per
square inch (psi) before a tire has
built up heat from driving.
Curb Weight: This means the weight
of a motor vehicle with standard and
optional equipment including the
maximum capacity of fuel, oil and
coolant, but without passengers and
cargo.
DOT Markings: A code molded into
the sidewall of a tire signifying that
the tire is in compliance with the U.S.
Department of Transportation motor
vehicle safety standards. The DOT
code includes the Tire Identification
Number (TIN), an alphanumeric des-
ignator which can also identify the
tire manufacturer, production plant,
brand and date of production.
JFa PE USA 7.qxp 5/15/2019 3:13 PM Page 54
I5
Index
Dual clutch transmission . . . . . . . . . . . . . . . . . . . . . . . 5-22Dual clutch transmission operation . . . . . . . . . . . . . 5-22
Good driving practices . . . . . . . . . . . . . . . . . . . . . . . 5-34
Dynamic Bending Light (DBL) . . . . . . . . . . . . . . . . . 4-111
Economical operation . . . . . . . . . . . . . . . . . . . . . . . . . 5-148
Electric Chromic Mirror (ECM) with UVO link . . . . . 4-54
Electric power steering . . . . . . . . . . . . . . . . . . . . . . . . . 4-49
Electrical equipment (U.S. ONLY) . . . . . . . . . . . . . . . 8-16
Electronic Parking Brake (EPB). . . . . . . . . . . . . . . . . . 5-40
Electronic Stability Control (ESC) . . . . . . . . . . . . . . . . 5-53
Emergency starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-5 Jump starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-5
Emergency while driving . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Emission control system . . . . . . . . . . . . . . . . . . . . . . . 7-102 Crankcase emission control system . . . . . . . . . . . . 7-102
Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system . . . 7-102
Exhaust emission control system . . . . . . . . . . . . . . 7-103
Engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . 8-2
Engine compartment . . . . . . . . . . . . . . . . . . . . . . . . 2-6, 7-4
Engine coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-28 Checking the coolant level . . . . . . . . . . . . . . . . . . . . 7-28
Changing the coolant . . . . . . . . . . . . . . . . . . . . . . . . 7-30
Engine coolant temperature gauge . . . . . . . . . . . . . . . . 4-62
Engine number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-11 Engine oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-\
26
Checking the engine oil level. . . . . . . . . . . . . . . . . . 7-26
Changing the engine oil and filter . . . . . . . . . . . . . . 7-27
Engine overheats. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
Engine start/stop button . . . . . . . . . . . . . . . . . . . . . . . . 5-10 Illuminated engine start/stop button. . . . . . . . . . . . . 5-10
Engine start/stop button position . . . . . . . . . . . . . . . 5-10
Starting the engine . . . . . . . . . . . . . . . . . . . . . . . . . . 5-12
Engine start/stop button illumination . . . . . . . . . . . . . . 5-10
Engine start/stop button position . . . . . . . . . . . . . . . . . 5-10
Engine will not start . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-4
Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system . . . . . . . . . . . . 7-102
Exhaust emission control system . . . . . . . . . . . . . . . . 7-103
Explanation of scheduled maintenance items . . . . . . . 7-22 Engine oil and filter . . . . . . . . . . . . . . . . . . . . . . . . . 7-22
Drive belts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-22
Fuel filter (for gasoline) . . . . . . . . . . . . . . . . . . . . . . 7-22
Fuel lines, fuel hoses and connections . . . . . . . . . . . 7-22
Vapor hose and fuel filler cap . . . . . . . . . . . . . . . . . 7-22
Vacuum crankcase ventilation hoses . . . . . . . . . . . . 7-23
Air cleaner filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-23
Spark plugs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-23
Valve clearance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-23
Cooling system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-23
Coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-\
23
Automatic transmission fluid . . . . . . . . . . . . . . . . . . 7-23
Dual clutch transmission fluid . . . . . . . . . . . . . . . . . 7-24
E
JFa PE USA Index.qxp 5/15/2019 3:10 PM Page 5