Page 366 of 486
7-14
Emergency situations
/ R Z W \ U H S U H V V X U H
W H O O W D O H
/ R Z W \ U H S U H V V X U H S R V L W L R Q W H O O-
W D O H D Q G W \ U H S U H V V X U H W H O O W D O H
OAC3079037R
When the tyre pressure monitoring
system warning indicators are illumi-
nated and warning message dis-
played on the cluster LCD display,
one or more of your tyres is signifi-
cantly under-inflated. The Low Tyre
Pressure Position Telltale will indi-
cate which tyre is significantly
under-inflated.If either telltale illuminates, immedi-
ately reduce your speed, avoid hard
cornering and anticipate increased
stopping distances. You should stop
and check your tyres as soon as pos-
sible. Inflate the tyres to the proper
pressure as indicated on the vehicle’s
placard or tyre inflation pressure label
located on the driver’s side centre pil-
lar outer panel. Then, reset TPMS
according TPMS reset procedure.
If you cannot reach a service station
or if the tyre cannot hold the newly
added air, replace the low pressure
tyre with the spare tyre.
The Low Tyre Pressure Telltale will
remain on and the TPMS Malfunction
Indicator may blink for one minute
and then remain illuminated until you
have the low pressure tyre repaired
and replaced on the vehicle.
Page 367 of 486
7-15
07
CAUTION
, Q Z L Q W H U R U F R O G Z H D W K H U W K H / R Z
7 \ U H 3 U H V V X U H 7 H O O W D O H P D \ E H L O O X-
P L Q D W H G L I W K H W \ U H S U H V V X U H Z D V
D G M X V W H G W R W K H U H F R P P H Q G H G W \ U H
L Q I O D W L R Q S U H V V X U H L Q Z D U P Z H D W K-
H U , W G R H V Q R W P H D Q \ R X U 7 3 0 6 L V
P D O I X Q F W L R Q L Q J E H F D X V H W K H
G H F U H D V H G W H P S H U D W X U H O H D G V W R D
S U R S R U W L R Q D O O R Z H U L Q J R I W \ U H S U H V-
V X U H
: K H Q \ R X G U L Y H \ R X U Y H K L F O H I U R P
D Z D U P D U H D W R D F R O G D U H D R U I U R P
D F R O G D U H D W R D Z D U P D U H D R U W K H
R X W V L G H W H P S H U D W X U H L V J U H D W O \
K L J K H U R U O R Z H U \ R X V K R X O G F K H F N
W K H W \ U H L Q I O D W L R Q S U H V V X U H D Q G
D G M X V W W K H W \ U H V W R W K H U H F R P P H Q G-
H G W \ U H L Q I O D W L R Q S U H V V X U H
7 K H Q U H V H W 7 3 0 6 D F F R U G L Q J 7 3 0 6
U H V H W S U R F H G X U H
7 K H 7 3 0 6 P D \ Q R W F D O L E U D W H S U R S-
H U O \ L Q E H O R Z F R Q G L W L R Q V
< R X G R Q R W U H V H W 7 3 0 6 S U R S H U O \
< R X G R Q R W X V H R U L J L Q D O W \ U H V
< R X G U L Y H R Q V Q R Z \ R U V O L S S H U \
U R D G V
< R X U D S L G O \ D F F H O H U D W H G H F H O H U D W H
R U W X U Q W K H V W H H U L Q J Z K H H O
' U L Y L Q J W R R V O R Z R U W R R I D V W
7 K H U H L V K H D Y L H U D Q G X Q H Y H Q O R D G
R Q W K H W \ U H V
6 S D U H W \ U H R U V Q R Z F K D L Q V D U H
X V H G
WARNING
/ R Z S U H V V X U H G D P D J H
6 L J Q L I L F D Q W O \ O R Z W \ U H S U H V V X U H
P D N H V W K H Y H K L F O H X Q V W D E O H D Q G
F D Q F R Q W U L E X W H W R O R V V R I Y H K L F O H
F R Q W U R O D Q G L Q F U H D V H G E U D N L Q J G L V-
W D Q F H V
& R Q W L Q X H G G U L Y L Q J R Q O R Z S U H V V X U H
W \ U H V F D Q F D X V H W K H W \ U H V W R R Y H U-
K H D W D Q G I D L O
7 3 0 6 7 \ U H 3 U H V V X U H
0 R Q L W R U L Q J 6 \ V W H P
P D O I X Q F W L R Q L Q G L F D W R U
The TPMS Malfunction Indicator will
illuminate after it blinks for approxi-
mately one minute when there is a
problem with the Tyre Pressure
Monitoring System.
We recommend that the system be
checked by a HYUNDAI authorised
repairer.
Page 368 of 486
7-16
Emergency situations
NOTICE
, I W K H U H L V D P D O I X Q F W L R Q Z L W K W K H
7 3 0 6 W K H / R Z 7 \ U H 3 U H V V X U H
3 R V L W L R Q 7 H O O W D O H Z L O O Q R W E H G L V-
S O D \ H G H Y H Q W K R X J K W K H Y H K L F O H
K D V D Q X Q G H U L Q I O D W H G W \ U H
& K D Q J L Q J D W \ U H Z L W K 7 3 0 6
If you have a flat tyre, the Low Tyre
Pressure and Position telltales will
come on. We recommend that the flat
tyre be repaired by a HYUNDAI
authorised repairer as soon as possi-
ble or replace the flat tyre with the
spare tyre.
CAUTION
1 H Y H U X V H D S X Q F W X U H U H S D L U L Q J
D J H Q W Q R W D S S U R Y H G E \ + < 8 1 ' $ ,
G H D O H U W R U H S D L U D Q G R U L Q I O D W H D O R Z
S U H V V X U H W \ U H
Page 369 of 486
7-17
07
You may not be able to identify a tyre
with low pressure by simply looking at
it. Always use a good quality tyre
pressure gauge to measure. Please
note that a tyre that is hot (from being
driven) will have a higher pressure
measurement than a tyre that is cold.
A cold tyre means the vehicle has
been sitting for 3 hours and driven for
less than 1 mile (1.6 km) in that 3
hour period.
Allow the tyre to cool before measur-
ing the inflation pressure. Always be
sure the tyre is cold before inflating to
the recommended pressure.
WARNING
Page 373 of 486
7-21
07
If you have a tyre gauge, check the
tyre pressure (see “Tyres and
Wheels” in chapter 2 for tyre pressure
instructions.). If the pressure is lower
or higher than recommended, drive
slowly to the nearest service station
and adjust it to the recommended
pressure. Always reinstall the valve
cap after checking or adjusting tyre
pressure. If the cap is not replaced,
air may leak from the tyre. If you lose
a valve cap, buy another and install it
as soon as possible. After changing
tyres, secure the flat tyre and return
the jack and tools to their proper stor-
age locations.
NOTICE
Page 377 of 486
7-25
07
OAC3079010TU
For safe operation, carefully read and
follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tyre Mobility Kit is a temporary
fix to the tyre and we recommend that
the system be inspected by a
HYUNDAI authorised repairer.
CAUTION
: K H Q W Z R R U P R U H W \ U H V D U H I O D W G R
Q R W X V H W K H W \ U H P R E L O L W \ N L W
E H F D X V H W K H V X S S R U W H G R Q H V H D O-
D Q W R I 7 \ U H 0 R E L O L W \ . L W L V R Q O \ X V H G
I R U R Q H I O D W W \ U H
WARNING
' R Q R W X V H W K H 7 \ U H 0 R E L O L W \ . L W W R
U H S D L U S X Q F W X U H V L Q W K H W \ U H Z D O O V
7 K L V F D Q U H V X O W L Q D Q D F F L G H Q W G X H
W R W \ U H I D L O X U H
WARNING
+ D Y H \ R X U W \ U H U H S D L U H G D V V R R Q D V
S R V V L E O H 7 K H W \ U H P D \ O R V H D L U
S U H V V X U H D W D Q \ W L P H D I W H U L Q I O D W L Q J
Z L W K W K H 7 \ U H 0 R E L O L W \ . L W
, Q W U R G X F W L R Q
With the Tyre Mobility Kit you stay
mobile even after experiencing a tyre
puncture.
The system of compressor and seal-
ing compound effectively and com-
fortably seals most punctures in a
passenger car tyre caused by nails or
similar objects and reinflates the tyre.
After you ensured that the tyre is
properly sealed you can drive cau-
tiously on the tyre (distance up to 120
miles (200 km)) at a max. speed 50
mph (80 km/h) in order to reach a ser-
vice station or tyre dealer to have the
tyre replaced.
It is possible that some tyres, espe-
cially with larger punctures or dam-
age to the sidewall, cannot be sealed
completely.
Air pressure loss in the tyre may
adversely affect tyre performance.
For this reason, you should avoid
abrupt steering or other driving
manoeuvres, especially if the vehicle
is heavily loaded or if a trailer is in
use.
The Tyre Mobility Kit is not designed
or intended as a permanent tyre
repair method and is to be used for
one tyre only. This instruction shows
you step by step how to temporarily
seal the puncture simply and reliably.
Read the section “Notes on the safe
use of the Tyre Mobility Kit”.
IF YOU HAVE A FLAT TYRE ãWITH TYRE MOBILITY KIT
IF EQUIPPEDä
Page 379 of 486
7-27
07
& R P S R Q H Q W V R I W K H 7 \ U H 0 R E L O L W \ . L W
1. Speed-restriction label
2. Sealant bottle and label with speed
restriction
3. Filling hose from sealant bottle to
wheel
4. Connectors and cable for the
power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. ON/OFF switch8. Pressure gauge for displaying the
tyre inflation pressure
9. Button for reducing the tyre infla-
tion pressure
Connectors, cable and connection
hose are stored in the compressor
housing.
Strictly follow the specified sequence,
otherwise the sealant may escape
under high pressure.
ODE067044
Page 381 of 486
7-29
07
OAC3079013R
5. Plug the compressor power cord
(4) into the vehicle power outlet.
6. With the ignition switch in the ON
position, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
and Wheels, chapter 2). The infla-
tion pressure of the tyre after filling
is unimportant and will be checked/
corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
CAUTION
7 \ U H S U H V V X U H
' R Q R W D W W H P S W W R G U L Y H \ R X U Y H K L-
F O H L I W K H W \ U H S U H V V X U H L V E H O R Z
S V L N 3 D 7 K L V F R X O G U H V X O W L Q
D Q D F F L G H Q W G X H W R V X G G H Q W \ U H
I D L O X U H
7. Switch off the compressor.
8. Detach the hoses from the sealant
bottle connector and from the tyre
valve.
Return the Tyre Mobility Kit to its stor-
age location in the vehicle.
WARNING
& D U E R Q P R Q R [ L G H
' R Q R W O H D Y H \ R X U Y H K L F O H U X Q Q L Q J
L Q D S R R U O \ Y H Q W L O D W H G D U H D I R U
H [ W H Q G H G S H U L R G V R I W L P H & D U E R Q
P R Q R [ L G H S R L V R Q L Q J D Q G V X I I R F D-
W L R Q F D Q R F F X U
