2020 AUDI TT COUPE wheel bolt torque

8S1012721BB
Emergency assistance

> Slide the wheel wrench from the vehicle tool kit
all the way onto the wheel bolt).
> Turn the wheel bolt approximately one turn to
the left. To achieve the required torque, hold
the end of the wheel wrench. If the wheel bolt
will not loosen, press carefully on the wheel
wrench with your foot. Hold onto the vehicle se-
curely while doing this and make sure your foot-
ing is stable.

ZA WARNING
To reduce the risk of an accident, only loosen
the wheel bolts gently one turn before raising
the vehicle with the vehicle jack*.
Raising the vehicle
Applies to: vehicles with vehicle jack





A_,
BFv-0094

BFV-0265



Fig. 190 Sill: positioning the vehicle jack
> Place the vehicle jack from the vehicle tool kit
ona firm surface. Use a flat, stable support if
necessary. On a slippery surface such as tile,
you should use a non-slip pad such as a rubber
mat > /A\.

D_ You need the matching adapter in order to loosen and
tighten anti-theft wheel bolts* > page 244.
> Find the marking on the sill that is closest to
the tire that will be changed > fig. 189. Behind
the marking, there is a lifting point on the side
sill for the vehicle jack.
> Turn the vehicle jack located under the mount-
ing point on the sill to raise the jack until its
arm @) ° fig. 190 is located under the desig-
nated mounting point.
> Align the vehicle jack so the arm (@) engages in
the designated mounting point in the side sill
and the base (2) lies flat on the ground. The
base (2) must be directly under the mounting
point @.
> Continue raising the vehicle jack until the wheel
lifts off the ground slightly.

ZA WARNING
—To reduce the risk of injury, make sure no
one is in the vehicle before raising it.
— Make sure the vehicle jack is stable. The risk
of injury is increased when the ground is
slippery or soft, because the vehicle jack
could slide or sink.
— Only raise your vehicle with the vehicle jack
provided by the factory. If you use a vehicle
jack designed for another vehicle, your vehi-
cle could slip and cause injury.
— Position the vehicle jack only at the desig-
nated mounting points on the side sill and
align the jack. Otherwise, the vehicle jack
could slip and cause an injury if it does not
have sufficient hold on the vehicle.
—To reduce the risk of injury, do not raise any
other vehicles or other loads using the vehi-
cle jack provided by the factory.
—To reduce the risk of an accident, never start
the engine when the vehicle is raised.
—To reduce the risk of injury, no work should
be performed under the vehicle while it is

raised.

@) Note
Do not lift the vehicle by the sill. Position the
vehicle jack only at the designated mounting
245
>

Emergency assistance

points on the side sill. Otherwise, your vehicle
could be damaged.
Removing and mounting a wheel
@ £
+
“% 0 oO

| B8k-1477


y
Fig. 192 Wheel: alignment pin in the top hole
Removing a wheel
> Remove the top wheel bolt completely using
the hex socket in the screwdriver handle from
the vehicle tool kit > fig. 191 and place it ona
clean surface.
> Then install the alignment pin from the vehicle
tool kit by hand in the empty wheel bolt hole
> fig. 192”.
> Remove the rest of the wheel bolts.
> Remove the wheel >(). The alignment pin re-
mains in the hole while doing this.
Installing a wheel
Read the directions on > page 246 when instal-
ling unidirectional tires.
> Slide the wheel on over the alignment pin >@®.

D Applies to: vehicles with ceramic brake rotors*: Use a sec-
ond alignment pin* from the vehicle tool kit for the lowest
hole according to the steps described for the first align-
ment pin.
246
> Install the wheel bolts and tighten them gently
using the hex socket.
>» Remove the alignment pin and tighten the re-
maining wheel bolt.
> Carefully lower the vehicle using the vehicle
jack*.
> Tighten the wheel bolts in a diagonal pattern
using the wheel wrench.
The wheel bolts must be clean and loosen and
tighten easily. Check the contact surfaces for the
wheel and hub. Contaminants on these surfaces
must be removed before installing the wheel.

Z\ WARNING
— Read and follow the important information
and notes under > page 220.
— Never use the hex socket in the screwdriver
handle to tighten the wheel bolts. Using the
hex
socket will not achieve the required
tightening torque, which increases the risk
of an accident.

@) Note
When removing or installing the wheel, the
rim
could hit the brake rotor and damage the
rotor. Work carefully and have a second per-
son help you.
Unidirectional tires
A unidirectional tire profile is identified by arrows
on the tire sidewall that point in the running di-
rection. You must always maintain the specified
running direction. This is necessary to ensure the
tire's optimal performance in regard to adhesion,
running noise, and friction, and to reduce the risk
of
hydroplaning.
To benefit fully from the advantages of the uni-
directional tire design, you should replace faulty
tires as soon as possible and restore the correct
running direction on all of the tires.

8S1012721BB
Emergency assistance

> Reinstall the caps on the wheel bolts if necessa-
ry.
> Store the vehicle tool kit in its designated
place.
> If the removed wheel does not fit in the spare
wheel well, store it securely in the luggage
compartment > page 64.
> Check the tire pressure on the installed wheel
as soon as possible.
> Check the tire pressure and store it in the Info-
tainment system.
> The wheel bolt tightening specification must be
90 ft lbs (120 Nm). Have it checked as soon as
possible with a torque wrench. Drive carefully
until then.
> Have the faulty wheel replaced as quickly as
possible.
Spare tire

General information
Applies to: vehicles with space-saving spare tire (compact
spare tire)

Fig. 193 Luggage compartment: spare tire
The spare tire is intended for short-term use only.
Have the damaged tire checked and replaced if
necessary by an authorized Audi dealer or author-
ized Audi Service Facility as soon as possible.
There are some restrictions on the use of the
compact spare tire. The compact spare tire has
been designed specifically for your type of vehi-
cle. Do not replace it with the spare tire from an-
other type of vehicle.
Removing the spare tire
> Turn the handle > fig. 193 @ counter-clock-
wise.
> Remove the spare tire.
Removing the vehicle jack
> Lift up the cover on the right side of the lug-
gage compartment and remove the vehicle
jack.
Snow chains
For technical reasons, the use of snow chains on
the compact spare tire is not permitted.
If you have to drive with snow chains and a front
tire fails, mount the spare tire in place of a rear
tire. Install the snow chains on the rear tire that
you removed, and install that in place of the
front tire that failed.

Z\ WARNING
— After installing a spare tire, the tire pressure
must be checked as soon as possible.
— Do not drive faster than 50 mph (80 km/h)
with a compact spare tire. Driving faster
than that increases the risk of an accident.
— To reduce the risk of an accident, avoid hard
acceleration or braking and driving fast
around curves with the compact spare tire.
— To reduce the risk of an accident, never drive
with more than one compact spare tire.
— Normal summer or winter tires must not be
mounted on the compact spare wheel rim.

Jump starting
You should only perform the steps that follow if
you have the necessary tools and technical ex-
pertise.
If the engine does not start because the vehicle
battery is drained, you can jump start your vehi-
cle using another vehicle. Jump start cables are
needed to do this.
Both vehicle batteries must have 12 V nominal
voltage. The voltage capacity (Ah) of the vehicle
247
>

Index

Recinculationimode sxcviss 2 x cisco 0 causes 2 axees 70
R@CUPerAtOMieas. & + ines ao anes @ 2 owe ow Hare 15
Refueling « & sso s 2 sews ao es + o sew so oe 196
Remote control
Garage door opener............-.00-055 28
Remote'control-key 0.0522 eee 22 eee ee eee 19
Convenience opening and closing......... 27
Key replacement............. eee eee ee 19
LED « cone a omen 2 2 wens 8 o women = 2 meme oe wens 20
Mechanical key......... 0.00 eee e ee eee 20
Personalization..............00000000. 19
Replacing the battery.................. 20
Unlocking and locking............-...0. 21
Removing the caps (wheel bolts)......... 244
Removing the wheel hub covers.......... 244
Repait'S sews o ¢ eau sy nee 2 2 eee ga ewe ge 257
Replacement key... 0.6... c0e sec enone eee 19
Replacement parts..............-.0 eee ee 259
Replacing windshield wiper blades......... 42
Reporting Safety Defects..............-. 259
Reset
refer'to Restart (MMI) .....cc.0. ceases 194
Restart (MMI)... 0... cece eee 194
Reverse
(automatic transmission) .......... 80
Rewinding (audio/video file)............. 178
RiIMS& « seas 1 + vases © 6 spss © < semen aH emmem oF 228
Cleaning. ....... ccc eee eee eee 236
Ringtone settingS.......... 0c s eee eae 140
Roof load... ... 2... cece eee eee 67, 263
Roof rack... eee eee 67
also refer to Roof rack............000005 67
Route criteria... 1.6... eee eee eee eee 156
Route guidance
refer to Navigation................-.. 149
Running direction (tires)..............-. 246
S
Safety
Telephone ss = s seus = y exws te eee se ees 129
Safety belt microphone................. 141
Safety belts... 0... ... eee cece eee 49
GCLEAMING's + + seis = weer + ¢ ewe = Hae G2 Re 238
LOCKING sie 5 6 svsiie oo eeweee vo ween @ @ seen 9 we 61
Securing child safety seats.............. 60
272
Saving fuel
Energy consumers ...... 0.002 cece cease 15
REGUPECRAELON s + maze a s neue 5s moeE wo See 8 15
Scan (fad O)iewws ¢ s sess a o aeas ss ee oP ES 166
Screwdriver. .... 2... cece cece eee eee 241
SD card reader............0 eee eee eee 171.
SDS
refer to Voice recognition system........ 123
Search
refer to Free text search............... 119
Search area (point of interest)............ 152
Searching for anentry.............-.... 119
Seat heating. ...... 0... cee eee eee eee 71
Seats
ACjUStING aexx sv ose% s ree es eee ep eee 46
Adjusting the rearseats..............0. 48
Cleaning......... cee eee eee eee 238
Easy S@at entry: sens « y sae ¢ 5 sae go ees 47
POlAING isis « = essen ow recon vo eS = HEHE Be Ae 66
Secondary phone.............+..-. 130, 190
Selecting a source (media).............. 178
Selection Menu... .....ceeeaes 112; 116; 117
Selective door unlocking............00005 18
Selective wheel torque control........... 105
Selector lever (automatic transmission)
Emergency operation...............00. 86
POSIEOM es 3 2 cei: yo cere 2 o ore oo ee Yo 79
Service interval display................. 212
Settings
DireGtony’s s ssasw + iawem a 2 manera © araeom @ 2 ae 140
Map... .. 2. cc eee eee ee eee 160
Medidios ¢ 5 seus x cea & game & 3 Heeee § Eee 181
NaVvigatlOnssin s wasn + wasen as eam w ¥ memes 156
Radio... ieee eee eee eee 168
SVSUEIIx ¢ & nevaw » E NATH S E BGR % & SGEUR TS Re 189
Tele PhONe wscea <2 vow ve meee oo sem oo a 140
Wi-Fi hotspot........... 0.00 cece eee 147
Setting the language ..........ceee veces 189
Shiftlightiindicator’s « sss x x wm o v vmnwm 6 2 3 15
Shift paddles (automatic transmission) ..... 83
SHUPPlG cs s = gow = e sees ep Hewes ee pee 181
Sid@aSsiStewe 2 wan: 2 y weme xs seme 5 5 ewer 8 2 93
Adjusting the brightness................ 95
Cleaning the sensors..........-....--- 236
SENSOFTANGE » aeons «2 sem s Yea 4 ese EG 94
Switching on and off................... 95