Page 65 of 701
64
uuChild Safety uSafety of Infants and Small Children
Safe Driving
Second row bench seat
3. Put the outer head restraint to its
uppermost position, then route the tether
strap between the head restraint legs, and
secure the tether strap hook to the anchor.
Make sure the strap is not twisted.
3. Put the outer head restraint to its upper
most position, then route the tether strap
outside the head restraint legs, and secure
the tether strap hook to the anchor. Make
sure the strap is not twisted.
3. Put the center head re straint to its lowest
position, then route the tether strap over
the top of the head restraint and secure the
tether strap hook to the anchor. Make sure
the strap is not twisted.
Tether Strap Hook
Anchor
Straight Top Tether Type
Tether Strap Hook
Anchor
Other Top Tether Type
Outer position
Straight Top Tether Type
Outer position
Other Top Tether Type
Center position
20 ACURA MDX-31TZ56600.book 64 ページ 2019年4月24日 水曜日 午後5時44分
Page 66 of 701
65
uuChild Safety uSafety of Infants and Small Children
Continued
Safe Driving
4. Tighten the tether strap as instructed by the
child seat manufacturer.
5. Make sure the child seat is firmly secured by
rocking it forward and back and side to
side; little movement should be felt.
6. Make sure any unused seat belt that a child
can reach is buckled, the lockable retractor
is activated, and the be lt is fully retracted
and locked.
2 Protecting Child Passengers P. 56
All positions
20 ACURA MDX-31TZ56600.book 65 ページ 2019年4月24日 水曜日 午後5時44分
Page 67 of 701

uuChild Safety uSafety of Infants and Small Children
66
Safe DrivingA child seat can be installed with a lap/should er belt in any rear seat or, if absolutely
necessary, the front passenger seat. 1.Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat
according to the seat manufacturer’s
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all
the way out until it stops. This activates the
lockable retractor.
4. Let the seat belt retract a few inches and
check that the retractor has switched
modes by pulling on the webbing. It should
not pull out again until it is reset by
removing the latch plate from the buckle.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Slowly pull the seat belt all the
way out, and repeat steps 3 – 4.
■Installing a Child Seat with a Lap/Shoulder Seat Belt1Installing a Child Seat with a Lap/Shoulder Seat Belt
A child seat that is not properly secured will not
adequately protect a child in a crash and may cause
injury to the child or other vehicle occupants.
20 ACURA MDX-31TZ56600.book 66 ページ 2019年4月24日 水曜日 午後5時44分
Page 68 of 701
Continued67
uuChild Safety uSafety of Infants and Small Children
Safe Driving
5. Grab the shoulder part of the seat belt near
the buckle, and pull up to remove any slack
from the lap part of the belt.
u When doing this, place your weight on
the child seat and push it into the vehicle
seat.
6. Make sure the child seat is firmly secured by
rocking it forward and back and side to
side; less than one inch of movement
should occur near the seat belt.
7. Make sure any unused seat belt that a child
can reach is buckled, the lockable retractor
is activated, and the be lt is fully retracted
and locked.1 Installing a Child Seat with a Lap/Shoulder Seat Belt
To deactivate a lockable retractor, release the buckle
and allow the seat belt to wind up all the way.
20 ACURA MDX-31TZ56600.book 67 ページ 2019年4月24日 水曜日 午後5時44分
Page 69 of 701
uuChild Safety uSafety of Infants and Small Children
68
Safe DrivingA tether anchorage point is provided behind
each second and third row seating position.
If you have a child seat that comes with a
tether but can be installe d with a seat belt, the
tether may be used for additional security.
■Adding Security with a Tether1 Adding Security with a Tether
Always use a tether for forward-facing child seats
when using the seat be lt or lower anchors.
Models with second row captain seat
Tether Anchorage Points
Tether Anchorage Points
Models with second row bench seat
Tether Anchorage Points
Third row seat
20 ACURA MDX-31TZ56600.book 68 ページ 2019年4月24日 水曜日 午後5時44分
Page 70 of 701
69
uuChild Safety uSafety of Infants and Small Children
Continued
Safe Driving
■Using a second row anchor
1. Put the outer head restraint to its upper-
most position, then route the tether strap
between the head restra int legs, and secure
the tether strap hook to the anchor. Make
sure the strap is not twisted.
1. Put the outer head restraint to its upper
most position, then route the tether strap
outside the head restra int legs, and secure
the tether strap hook to the anchor. Make
sure the strap is not twisted.Models with second row captain seat
Anchor
Tether Strap Hook
Tether Strap Hook
Anchor
Other Top Tether Type Straight Top Tether Type
Outer positions
Straight Top Tether Type
Outer positions
Other Top Tether Type
20 ACURA MDX-31TZ56600.book 69 ページ 2019年4月24日 水曜日 午後5時44分
Page 71 of 701
70
uuChild Safety uSafety of Infants and Small Children
Safe Driving
1. Put the center head re straint to its lowest
position, then route the tether strap over
the top of the head restraint and secure the
tether strap hook to the anchor. Make sure
the strap is not twisted.
2. Tighten the tether strap as instructed by the
child seat manufacturer.
Anchor
Models with second row bench seat
Tether Strap Hook
Tether Strap Hook
Anchor
Other Top Tether Type Straight Top Tether Type
Center position of second row bench seat
All positions
20 ACURA MDX-31TZ56600.book 70 ページ 2019年4月24日 水曜日 午後5時44分
Page 72 of 701
71
uuChild Safety uSafety of Infants and Small Children
Safe Driving
■Using a third row anchor
1. Pull up the head restraint and push
rearwards until it latches, then route the
tether strap through the head restraint legs.
Make sure the strap is not twisted.
1. Pull up the head restraint and push
rearwards until it latches, then route the
tether strap outside the head restraint legs.
Make sure the strap is not twisted.
2. Open the anchor cover.
3. Secure the tether strap hook to the anchor.
4. Tighten the tether strap as instructed by the
child seat manufacturer.
Other Top Tether Type
Tether Strap Hook
Anchor
Third row seat
Straight Top Tether Type
Anchor
Tether Strap Hook
Straight Top Tether Type
Other Top Tether Type
All Types
20 ACURA MDX-31TZ56600.book 71 ページ 2019年4月24日 水曜日 午後5時44分