54Maintenance Log
MAINTENANCE
EXPLANATION OF MAINTENANCE ITEMS
T
he following descriptions are  
provided to give you a better  
understanding of the maintenance  
items that should be performed on your 
vehicle. The scheduled maintenance log 
indicates at which mileage/time intervals  
each item should be performed. Please  
note that many maintenance items should  
be performed only by a qualified technician.
For further information on maintenance 
items you can perform yourself, see the 
“Maintenance and Care” section of the 
Owner’s Manual.
Automatic Transmission Fluid 
Inspect or replace at specified intervals. 
When performing inspections, check each 
component for signs of leakage. If you 
discover any leakage, have it repaired by  
a qualified technician immediately.
Ball Joints and Dust Covers 
Check the suspension and steering  
linkage ball joints for looseness and  
damage. Check all dust covers for 
deterioration and damage. Replace  
any deteriorated or damaged parts.  
A qualified technician should perform  
these operations.
Brake Lines and Hoses
Visually inspect for proper installation.  
Check for chafing, cracks, deterioration  
and signs of leakage. Replace any 
deteriorated or damaged parts. A qualified 
technician should perform these operations.
Brake Linings/Drums and   
Brake Pads/Discs
Check the brake linings (shoes) and  
drums for scoring, burning, fluid leakage,  
broken parts and excessive wear. Check  
the pads for excessive wear and the discs 
for runout, excessive wear and fluid  
leakage. Replace any deteriorated or  
damaged parts. A qualified technician  
should perform these operations.
Cabin Air Filter
Replace at specified intervals. Driving in  
heavy traffic, on dirt roads or in urban,  
desert or dusty areas may shorten filter’s  
life. More frequent replacement may  
be necessary.
Drive Belts
Inspect for cracks, excessive wear and 
oiliness. Check the belt tension and adjust  
if necessary. Replace the belts if they  
are damaged. 
56Maintenance Log
MAINTENANCE
EXPLANATION OF MAINTENANCE ITEMS
Engine Oil and Oil Filter
Replace the oil filter and drain and refill  
the engine oil at specified intervals. For 
recommended oil grade and viscosity,  
refer to the Owner’s Manual. 
NOTE: Your vehicle is certified with  
Genuine Toyota 0W-20 motor oil. For  
VEHICLES CERTIFIED FOR 0W-20 motor  
oil, the oil change interval is 10,000 miles  
or 12 months IF 0W-20 MOTOR OIL IS  
BEING USED. If 0W-20 is not available,  
5W-20 mineral oil may be used. However,  
it must be replaced at a 5,000-miles or  
six-month INTERVAL with 0W-20 motor oil. 
For customers who primarily drive their  
vehicle under any of the listed Special 
Operating Conditions, the motor oil and  
filter should be replaced at 5,000 miles or  
six months, REGARDLESS OF THE OIL USED 
(OR CERTIFICATION OF THE VEHICLE).
Exhaust Pipes and Mountings 
Visually inspect the exhaust pipes, muffler  
and hangers for cracks, deterioration and 
damage. Start the engine and listen  
carefully for any exhaust gas leakage.  
Tighten connections or replace parts  
as necessary.
Front and Rear Differential Oil 
Inspect or replace at specified intervals. 
When performing inspections, check each 
component for signs of leakage. If you 
discover any leakage, have it repaired by  
a qualified technician immediately.
Fuel Lines and Connections,   
Fuel Tank Band and Fuel Tank 
Vapor Vent System Hoses
Visually inspect for corrosion, damage,  
cracks, and loose or leaking connections.  
Tighten connections or replace parts  
as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration  
and damage and replace if necessary.
Nuts and Bolts on Chassis   
and Body
Retighten the seat-mounting bolts and  
front /rear suspension member retaining  
bolts to specified torque.
Propeller Shaft
Re-torque the propeller shaft bolt. Only  
a qualified technician should perform  
this operation.
Radiator and Condenser
Inspect for debris, corrosion and signs  
of damage. Have any problem repaired 
immediately by a qualified technician.
Spark Plugs
Replace at specified intervals. Install new 
plugs of the same type as originally  
equipped. A qualified technician should 
perform this operation.