15Your Warranties in Detail
WARRANTY
  
 
Maintenance Expense
Normal maintenance services such as:
• Engine tune-ups
• Replacement of fluids and filters
• Lubrication
• Cleaning and polishing
• Replacement of spark plugs and fuses 
• Replacement of worn wiper blades,  
brake pads/linings and clutch linings 
Vehicles with Altered Odometer 
Failure of a vehicle on which the odometer  
has been altered so that actual vehicle 
mileage cannot be readily determined.
Salvage or Total-Loss Vehicles 
Any vehicle that has ever been issued a 
“salvage” title or similar title under any  
state’s law; or has ever been declared a 
“total loss” or equivalent by a financial 
institution or insurer, such as by payment  
for a claim in lieu of repairs because the  
cost of repairs exceeded the cash value of  
the vehicle. This exclusion does not apply to 
the emission control warranties, including 
Emission Control Warranty Enhancements,  
or any open Safety Recalls.
  
 
Incidental Damages
Incidental or consequential damages  
associated with a vehicle failure. Such 
damages include but are not limited to 
inconvenience; the cost of transportation, 
telephone calls and lodging; the loss of 
personal or commercial property; and the  
loss of pay or revenue.
Disclaimer of Extra  
Expenses and Damages
The performance of necessary repairs 
and adjustments is the exclusive remedy 
under this warranty or any implied 
warranty. Toyota does not authorize 
any person to create for it any other 
obligation or liability in connection with 
this vehicle. Toyota shall not be liable 
for incidental or consequential damages 
resulting from breach of this written 
warranty or any implied warranty. Any 
implied warranty of merchantability or 
fitness for a particular purpose is limited 
to the duration of this written warranty, 
except in states where this limitation  
is not allowed.
NEW VEHICLE LIMITED WARRANTY 
56Maintenance Log
MAINTENANCE
EXPLANATION OF MAINTENANCE ITEMS
Engine Oil and Oil Filter
Replace the oil filter and drain and refill  
the engine oil at specified intervals. For 
recommended oil grade and viscosity,  
refer to the Owner’s Manual. 
NOTE: Your vehicle is certified with  
Genuine Toyota 0W-20 motor oil. For  
VEHICLES CERTIFIED FOR 0W-20 motor  
oil, the oil change interval is 10,000 miles  
or 12 months IF 0W-20 MOTOR OIL IS  
BEING USED. If 0W-20 is not available,  
5W-20 mineral oil may be used. However,  
it must be replaced at a 5,000-miles or  
six-month INTERVAL with 0W-20 motor oil. 
For customers who primarily drive their  
vehicle under any of the listed Special 
Operating Conditions, the motor oil and  
filter should be replaced at 5,000 miles or  
six months, REGARDLESS OF THE OIL USED 
(OR CERTIFICATION OF THE VEHICLE).
Exhaust Pipes and Mountings 
Visually inspect the exhaust pipes, muffler  
and hangers for cracks, deterioration and 
damage. Start the engine and listen  
carefully for any exhaust gas leakage.  
Tighten connections or replace parts  
as necessary.
Front and Rear Differential Oil 
Inspect or replace at specified intervals. 
When performing inspections, check each 
component for signs of leakage. If you 
discover any leakage, have it repaired by  
a qualified technician immediately.
Fuel Lines and Connections,   
Fuel Tank Band and Fuel Tank 
Vapor Vent System Hoses
Visually inspect for corrosion, damage,  
cracks, and loose or leaking connections.  
Tighten connections or replace parts  
as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration  
and damage and replace if necessary.
Nuts and Bolts on Chassis   
and Body
Retighten the seat-mounting bolts and  
front /rear suspension member retaining  
bolts to specified torque.
Propeller Shaft
Re-torque the propeller shaft bolt. Only  
a qualified technician should perform  
this operation.
Radiator and Condenser
Inspect for debris, corrosion and signs  
of damage. Have any problem repaired 
immediately by a qualified technician.
Spark Plugs
Replace at specified intervals. Install new 
plugs of the same type as originally  
equipped. A qualified technician should 
perform this operation.