Page 33 of 48
31
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
ADJUSTING DISTANCE
To change the vehicle-to-
vehicle distance
Push the “
” button
to cycle through the
settings, which will change
progressively.
This mode employs a radar sensor to detect the presence of vehicles up t\
o
approximately 328ft (100m) ahead, determines the current vehicle-to-ve\
hicle
following distance and operates to maintain a preset following distance \
from the
vehicle ahead. These distances vary based on vehicle speed.
Note: Vehicle-to-vehicle distance will close in when traveling on long d\
ownhill
slopes.
MIDDLE SHORT
(default setting)
LONG
Preceding vehicle
mark
(1)Constant speed cruising when there are no vehicles ahead
The vehicle travels at the speed set by the driver. The desired vehicle-\
to-
vehicle distance can also be set by operating the vehicle-to-vehicle dis\
tance
control.
(2) Deceleration cruising and follow-up cruising when a preceding vehicle
driving slower than the set speed appears When a vehicle is detected running ahead of you, the system automaticall\
y
decelerates your vehicle. When a greater reduction in vehicle speed is
necessary, the system applies the brakes (the brake lights will come on\
at this
time). The system will respond to changes in the speed of the vehicle a\
head
in order to maintain the vehicle-to-vehicle distance set by the driver. \
A warning
tone warns you when the system cannot decelerate sufficiently to prevent\
your
vehicle from closing in on the vehicle ahead.
(1) (2) (3)
ADJUSTING DISTANCE (CONTINUED)
Page 34 of 48
32
4 8 * 5 $ ) * / ( 5 0 $ 0 / 4 5 " / 5 4 1 & & % $ 3 6 * 4 &
$ 0 / 5 3 0 - . 0 % &
If you are already using DRCC “ w
Q V T I 0 / 0 ' ' C V U U P O U P U V S O U I F T Z T U F N P G G
first, then push and hold ON-OFF button for at least 1.5 seconds to swit\
ch.
Note: When the engine is turned off, it will automatically default to DR\
CC.
Refer to a Toyota Owner’s Manual for additional information on DRCC o\
peration,
settings adjustments, limitations, and precautions before attempting to \
use it.
1.5 seconds
Acceleration when there are no longer any preceding vehicles driving
slower than the set speed The system accelerates until the set speed is reached. The system then
returns to constant speed cruising.
Note: When your vehicle is too close to a vehicle ahead, and sufficient \
automatic deceleration via the cruise control is not possible, the displ\
ay will
flash and the buzzer will sound to alert the driver. An example of this \
would be
if another driver cuts in front of you while you are following a vehicle\
. Depress
the brake pedal to ensure an appropriate vehicle-to-vehicle distance.
" % + 6 4 5 * / ( % * 4 5 " / $ & $ 0 / 5 * / 6 & %
TOYOTA SAFETY SENSE™
4 & 5 5 * / ( $ 0 / 4 5 " / 5 4 1 & & % $ 3 6 * 4 &
$ 0 / 5 3 0 -
Refer to a Toyota Owner’s Manual for additional information on DRCC o\
peration,
settings adjustments, limitations, and precautions before attempting to \
use it.
Set
To adjust speed or cancel, see steps (2) and (3) of ADJUSTING SET SP\
EED on
page 30.
Page 35 of 48
![TOYOTA C-HR 2019 Owners Manual (in English) 33
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
AHB is a safety system designed to help drivers see more of what’s ah\
ead at
nighttime](/manual-img/14/42409/w960_42409-34.png "TOYOTA C-HR 2019 Owners Manual (in English) 33
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
AHB is a safety system designed to help drivers see more of what’s ah\
ead at
nighttime")
33
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Automatic High Beams (AHB)
AHB is a safety system designed to help drivers see more of what’s ah\
ead at
nighttime and reduce glare for oncoming drivers. When enabled, AHB uses \
an
in-vehicle camera to help detect the headlights of oncoming vehicles and\
tail lights
of preceding vehicles, then automatically switches between high and low \
beams
as appropriate to provide the most light possible and enhance forward vi\
sibility.
# Z V T J O H I J H I C F B N T N P S F G S F R V F O U M Z
U I F T Z T U F N N B Z B M M P X F B S M J F S E F U F D U J P O P G
pedestrians and obstacles.
Refer to a Toyota Owner’s Manual for additional information on AHB op\
eration,
settings adjustments, limitations, and precautions before attempting to \
use it.
8 J U I U I F F O H J O F T X J U D I J O 0 / * ( / * 5 * 0 / 0 / N P E F
U V S O U I F I F B E M J H I U T X J U D I U P i
w P S i " 6 5 0 w Q P T J U J P O
1 V T I M F W F S B X B Z G S P N Z P V
1 S F T T U I F i
w T X J U D I
The AHB indicator will come on when the headlights are turned on automat\
ically
to indicate that the system is active.
Note: Pull the lever back toward you to turn the AHB system off.
The AHB indicator will turn off. To turn switch to “
w Q P T J U J P O B O E U I F N B O V B M
high beam indicator “
w U V S O T P O
When all of these conditions are met, high beams will be automatically t\
urned on
B G U F S B Q Q S P Y J N B U F M Z T F D P O E
t 7 F I J D M F T Q F F E J T B C P W F B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail ligh\
ts turned on.
• There are few street lights on the road ahead.
If any of these conditions occur, the system is designed to automaticall\
y turn off
high beams: t 7 F I J D M F T Q F F E E S P Q T C F M P X B Q Q S P Y J N B U F M Z N Q I L N I
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lightsturned on.
• There are many streetlights on the road ahead.
" $ 5 * 7 " 5 * / ( 5 ) & " ) # 4 : 4 5 & .
$ 0 / % * 5 * 0 / 4 8 ) & 3 & " ) # 8 * - - 5 6 3 / 0 / 0 ' ' " 6 5 0 . " 5 * $ " - - :
(2) (1)
Page 36 of 48
34
Rear door child safety locks
Keep as low on
hips as possible
Take up slack
1 2 7 ( , I D S D V V H Q J H U
Page 37 of 48
35
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Tire Pressure Monitoring (warning) System (TPMS)
The tire pressure detected by the tire pressure warning system can
C F E J T Q M B Z F E P O U I F N V M U J J O G P S N B U J P O E J T Q M B Z . * %
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
The tire pressure warning system can be selected on “ w P G U I F N V M U J J O G P S N B U J P O
E J T Q M B Z . * %
System rest initialization
4 F M F D U i 7 F I J D M F 4 F U U J O H T w B O E U I F N Q V T I B O E I P M E i w
4 F M F D U i
Setup w U I F O Q V T I B O E I P M E i w
Page 38 of 48
36
Spare tire & tools
SAFETY & EMERGENCY FEATURES
TOOL LOCATION
REMOVE THE SPARE TIRE
Refer to the Toyota Owner’s Manual for tire changing and jack positioning
procedures.
Remove the deck board and cushion.
Take out jack.
Loosen the center fastener that secures the
spare tire.
Towing eyelet
Wheel nut wrench
Jack
Jack handle
Spare tire
Page 39 of 48
37
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
4 . " 3 5 4 5 0 1 5 & $ ) / 0 - 0 ( : 4 4 5
Smart Stop Technology automatically reduces engine power when the accelerator
and brake pedals are pressed simultaneously under certain conditions.
SST engages when the accelerator is depressed first and the brakes are applied
firmly for longer than one-half second at speeds greater than five miles per hour.
SST doesn’t engage if the brake pedal is depressed before the accelerator pedal,
allowing vehicles to start on a steep hill and safely accelerate without rolling
backward.
Star Safety System™
" / 5 * - 0 $ , # 3 " , & 4 : 4 5 & . " # 4
Toyota’s ABS sensors detect which wheels are locking up and limits wheel lockup
C Z i Q V M T J O H w F B D I X I F F M T C S B L F T J O E F Q F O E F O U M Z 1 V M T J O H S F M F B T F T C S B L F Q S F T T V S F
repeatedly for fractions of a second. This helps the tires attain the traction that
current road conditions will allow, helping you to stay in directional control.
# 3 " , & " 4 4 * 4 5 # "
# S B L F " T T J T U J T E F T J H O F E U P E F U F D U T V E E F O P S i Q B O J D w C S B L J O H
B O E U I F O B E E C S B L J O H
pressure to help decrease the vehicle’s stopping distance. When there’s only a split
T F D P O E U P S F B D U
# S B L F " T T J T U D B O B E E B E E J U J P O B M C S B L F Q S F T T V S F N P S F R V J D L M Z U I B O
just the driver alone can.
& - & $ 5 3 0 / * $ # 3 " , & ' 0 3 $ & % * 4 5 3 * # 6 5 * 0 / & # %
5 P Z P U B T " # 4 U F D I O P M P H Z I B T & M F D U S P O J D # S B L F G P S D F % J T U S J C V U J P O & # %
U P I F M Q
maintain control and balance when braking. Abrupt stops can cause a vehicle to tilt
forward, reducing the braking power of the rear wheels. EBD responds to sudden
stops by redistributing brake force to enhance the braking effectiveness of all four
wheels. : P V S W F I J D M F D P N F T T U B O E B S E X J U I U I F 4 U B S 4 B G F U Z 4 Z T U F N
TM, which combines Anti-
M P D L # S B L J O H 4 Z T U F N " # 4
# S B L F " T T J T U # "
& M F D U S P O J D # S B L F G P S D F % J T U S J C V U J P O
& # %
4 N B S U 4 U P Q 5 F D I O P M P H Z 4 4 5
5 S B D U J P O $ P O U S P M 5 3 " $
B O E 7 F I J D M F 4 U B C J M J U Z
$ P O U S P M 7 4 $
5 H I H U W R W K H 2 Z Q H U
Page 40 of 48
![TOYOTA C-HR 2019 Owners Manual (in English) 38
Floor mat installation
There are two types of Toyota floor mats: carpeted and all-weather. Each\
vehicle
has model-specific floor mats. Installation is easy.
To keep your floor mat properly posi](/manual-img/14/42409/w960_42409-39.png "TOYOTA C-HR 2019 Owners Manual (in English) 38
Floor mat installation
There are two types of Toyota floor mats: carpeted and all-weather. Each\
vehicle
has model-specific floor mats. Installation is easy.
To keep your floor mat properly posi")
38
Floor mat installation
There are two types of Toyota floor mats: carpeted and all-weather. Each\
vehicle
has model-specific floor mats. Installation is easy.
To keep your floor mat properly positioned, follow these steps:
• Only use Toyota floor mats designed for your specific model.
• Use only one floor mat at a time, using the retaining hooks to keep the \
mat inplace.
• Install floor mats right side up.
Always align the marks
5 3 " $ 5 * 0 / $ 0 / 5 3 0 - 5 3 " $
VSC helps prevent loss of traction during cornering by reducing engine p\
ower, and
Traction Control helps maintain traction on loose gravel and wet, icy, o\
r uneven
T V S G B D F T C Z B Q Q M Z J O H C S B L F G P S D F U P U I F T Q J O O J O H X I F F M T
Toyota’s TRAC sensors are activated when one of the drive wheels star\
ts to slip.
TRAC limits engine output and applies the brakes to the spinning wheel. \
This
transfers power to the wheels that still have traction to help keep you \
on track.
SAFETY & EMERGENCY FEATURES
