2019 SUBARU LEGACY brake light

8
Seatbelt warning
Front passenger
seatbelt warning
(Located on overhead console)
SRS airbag system
Security indicator light
Charge warning
Oil pressure warning
Brake system
Power steering warning
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Headlight leveler
(if equipped)
Immediate Attention
Caution
Informational
Legacy 2.5 L
Gauges
Tachometer ECO gauge
Temperature gaugeTrip meter and odometerTrip meter reset button
3645634_19b_Subaru_Legacy_QG_082818.indd 88/28/18 1:26 PM

10
Gauges
Legacy 2.5 L Premium
Legacy 2.5 L Sport
Legacy 2.5 L Limited
Legacy 3.6 L Limited
Immediate Attention
Caution
Informational
Tachometer
Temperature gauge Trip meter and odometer
Trip meter reset buttonECO gauge
Seatbelt warning
Front passenger
seatbelt warning
(Located on overhead console)
SRS airbag system
Security indicator light
Charge warning
Oil pressure warning
Brake system
Power steering warning
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Headlight leveler
(if equipped)
3645634_19b_Subaru_Legacy_QG_082818.indd 108/28/18 1:26 PM

15
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only the front daytime
running lights will be automatically turned on when the engine has started,
the parking brake is fully released and the light switch is in the “OFF”,
“AUTO” or “
” position. The brightness of the illumination of the high
beam headlights is reduced by the daytime running light system. You must
always switch on your headlights when it is dark outside by turning the light
switch to the “
” position or have the switch in the “AUTO” position.
1
2
3
INT.
LOW
HIGH OFF
Controls
3645634_19b_Subaru_Legacy_QG_082818.indd 158/28/18 1:27 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

22
Electronic Parking Brake
To apply, depress the brake pedal and pull up the
parking brake switch. The brake system warning light
on the instrument panel and the indicator light on the
parking brake switch will illuminate.
To release, make sure all doors are closed and your
seatbelt is fastened, then gently push the accelerator
pedal. Or, while the ignition switch is in the ON position
and the brake pedal is depressed in, push down the
parking brake switch.
Hill Holder™ Function
To activate, press the Hill Holder switch. To deactivate,
press the Hill Holder switch again. When the Hill
Holder function is activated, the parking brake will be
automatically applied when stopped on an uphill or
downhill slope with the brake pedal pushed down.
The brake system warning light on the instrument
panel and the indicator light on the parking brake
switch will illuminate.
While Operating
Paddle Shift Control Switches (if equipped)
• Temporary use: Even when the selector is in the
“D” (Drive) position, you can temporarily shift the
gear by pulling the “+” or “–” paddle shift control
switch. The transmission will automatically
switch back to Normal Mode.
• When the selector lever is in Manual Mode, shift to the next higher gear\
by pulling the “+”
paddle shift control switch on the steering wheel. Pull the “–” paddle shift cont\
rol switch
to shift into the next lower gear.
Manual Shifting Operation

Arrow-shaped lights in the center of the instrument panel show whether an u\
pshift is possible
and whether a downshift is possible.
3645634_19b_Subaru_Legacy_QG_082818.indd 228/28/18 1:27 PM