2019 SUBARU FORESTER low beam

8
Trip meter reset button
Gauges
Forester
Forester Premium
Forester Sport
Forester Limited
Forester Touring
Immediate Attention

Caution
Informational
Tachometer
Fuel gauge
Seatbelt warning
Front passenger seatbelt
warning (Located on
overhead console)
SRS airbag system
Security indicator light
Charge warning
Oil pressure warning
Power steering warning
Brake system
Hot coolant temperature/
Cold coolant temperature
High beam indicator light
AT OIL TEMP
ABS warning
Low fuel
All-Wheel Drive
3495150_19a_Subaru_Forester_QRG_070318.indd 87/3/18 1:06 PM

12
Controls
While the light switch is on, rotate the dial downward to dim the instrument panel illumination. Rotate the dial upward to make the illumination brighter. When the dial is fully rotated upward
(dots aligned), the instrument panel illumination stays at full bright\
ness.
Light Controls

Turns on instrument panel
lights, tail lights, parking lights
and license plate lights.
Turns on headlights, instrument
panel illumination, parking lights,
tail lights and license plate lights.
Rotate to
turn on
fog lights
(if equipped).AUTO: The vehicle’s lights are
automatically on or off, depending
on the level of outside light.
Push forward to change from low
beam to high beam. Pull the lever
back to center to return to low beam.
Push slightly down
for lane change
or fully down for
left turn signal.
Push slightly up
for lane change
or fully up for
right turn signal.
3495150_19a_Subaru_Forester_QRG_070318.indd 127/3/18 1:07 PM

13
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob downward
to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only the front daytime running
lights will be automatically turned on when the engine has started, the parking
brake is fully released and the light switch is in the “OFF”, “AUTO” or “\
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position or have the
switch in the “AUTO” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
3495150_19a_Subaru_Forester_QRG_070318.indd 137/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information