Page 265 of 408

Start and driving
Foresight when driving
Accel er
ation causes the v
ehicle to consume
more fuel. If you think ahead when driving,
you will need to brake less and thus acceler-
ate less. Wherever possible, let the car roll
slowly to a stop, with a gear engaged (for in-
stance when you can see that the next traffic
lights are red). This takes advantage of the
engine braking effect, reducing wear on the
brakes and tyres. Emissions and fuel con-
sumption will drop to zero due to the overrun
fuel cut-off.
Changing gear to save energy
An effective way of saving is to change in ad-
vance to a higher gear. Running the engine at
high rpm in the lower gears uses an unneces-
sary amount of fuel.
Manual transmission: shift up from first to
second gear as soon as possible. In any case,
we recommend that you change to a higher
gear upon reaching 2,000 rpm. Choosing the
right gear enables fuel savings. Select the
highest possible gear appropriate for the
driving situation (the engine should continue
functioning with cyclical regularity).
Automatic transmission: accelerate gradu-
ally and without reaching the “kick-down”
position. Avoid driving at high speed
Avoid trav
elling at top speed, whenever pos-
sible. Fuel consumption, emission of harmful
gases and noise pollution multiply dispropor-
tionately as speed is increased. Driving at
moderate speeds will help to save fuel.
Reduce idling time
In vehicles with the Start-Stop system idling is
automatically reduced. In vehicles without
the Start-Stop system it is worth switching off
the engine, for example, at level crossings
and at traffic lights that remain red for long
periods of time. When an engine has reached
operating temperature, and depending on
the cylinder capacity, keeping it switched off
for a minimum of about 5 seconds already
saves more than the amount of fuel necessa-
ry for restarting.
The engine takes a long time to warm up
when it is idling. Mechanical wear and pollu-
tant emissions are also especially high during
this initial warm-up phase. It is therefore best
to drive off immediately after starting the en-
gine. Avoid running the engine at high speed.
Regular maintenance
Regular servicing helps in saving fuel even
before the engine is started. A well-serviced
engine gives you the benefit of improved fuel
efficiency as well as maximum reliability and
an enhanced resale value. A badly serviced engine can consume up to 10% more fuel
than necessary.
Avoid short journeys
The engine and cat
alytic converter need to
reach their optimal operating temperature
in order to minimise fuel consumption and
emissions.
A cold engine consumes a disproportionate
amount of fuel. The engine reaches its work-
ing temperature after about four kilometres
(2.5 miles), when fuel consumption will return
to a normal level.
Check tyre pressure
Always make sure the tyres are inflated to the
correct pressures
Page 342 of 408
Practical tips
Practical tips
Car e and maint
enance
Accessories and modifica-
tions t
o the vehicle
Accessories, replacement parts
and repair work Always ask your dealer or specialist retailer
f
or advice bef
or
e purchasing accessories
and replacement parts.
Your vehicle is designed to offer a high stand-
ard of active and passive safety. For this rea-
son, we recommend that you ask a SEAT Offi-
cial Service for advice before fitting accesso-
ries or replacement parts. Your SEAT Official
Service has the latest information from the
manufacturer and can recommend accesso-
ries and replacement parts which are suita-
ble for your requirements. They can also an-
swer any questions you might have regarding
official regulations.
We recommend you to use only SEAT acces-
sories and Genuine SEAT parts
Page 351 of 408
Checking and refilling levels
Checking levels Fig. 303
Diagram for the location of the various el-
ements. From time to time, the levels of the different
fluids in the v
ehicl
e must be check
ed. Never
fill with incorrect fluids, otherwise serious
damage to the engine may be caused.
Coolant expansion tank
Engine oil dipstick
Engine oil filler cap
Brake fluid reservoir
Vehicle battery (underneath the cover)
Windscreen washer reservoir
The checking and refilling of service fluids are
carried out on the components mentioned 1 2
3
4
5
6 above. These operations are described in
Page 360 of 408

Practical tips
If the rims and tyres have received a heavy
impact or hav e been damaged, hav
e them
check
ed and, if required, replaced at a speci-
alised workshop.
Low profile tyres may deteriorate more quick-
ly than standard tyres.
Concealed damage
Damage to tyres and rims is often not readily
visible. If you notice unusual vibration or the
car pulling to one side, this may indicate
that one of the tyres is damaged. Reduce
speed immediately if there is any reason to
suspect that damage may have occurred. In-
spect the tyres for damage. If no external
damage is visible, drive slowly and carefully
to the nearest specialised workshop and
have the car inspected.
Tyres with directional tread pattern
An arrow on the tyre sidewall indicates the di-
rection of rotation on single drive tyres. Al-
ways note the direction of rotation indicated
when mounting the wheel. This guarantees
optimum grip and helps to avoid aquaplan-
ing, excessive noise and wear.
Retrofitting accessories
If you wish to change or fit wheels, rims or
wheel trims, we recommend that you consult
with a SEAT Official Service centre for advice
regarding current techniques. Service life of tyres
Fig. 306
Location of the tyre pressure sticker. Correct inflation pressures and sensible driv-
ing habits will incr
ease the useful lif
e of your
t
yres.
Page 369 of 408
Service
Maintenance
ServiceService int erv
al
s
Servicing and Digital Maintenance
Plan Log of services performed (“Digital Main-
tenance Pl
an”)
The SEAT deal
ership or a specialised work-
shop records Service receipts in a central
system. Thanks to this comprehensive docu-
mentation of the service history, it is possible
to reproduce the services performed any
time. SEAT recommends requesting a Service
receipt after every service carried out con-
taining all the services carried out on the sys-
tem.
Whenever there is a new service the receipt is
replaced with a current one.
The Digital Maintenance Plan is not avail-
able in some markets. In this case, your
SEAT dealer will inform you about the cur-
rent documentation of the work. Service works
In the Digital Maint
enance Pl
an, your SEAT
authorised service or specialised workshop
documents the following information:
Page 370 of 408
Maintenance
Oil change service
a)
PR No. Type of
service Service interval
QI1
FixedEvery 5000 km or after
1 year b)
QI2 Every
7500 km or after
1 year b)
QI3 Ev
ery
10000 km or after
1 year b)
QI4 Ev
ery
15000 km or after
1 year b)
QI6 Fle
xible According to the service in-
t
erv
al displ
ay a)
The data are based on normal conditions of use.
b) Whatever happens first. Inspection Service
a)
According to the service interval display a)
The data are based on normal conditions of use.
Bear in mind the inf ormation about the speci-
fications of the engine oil accor ding t
o the
VW standard
Page 371 of 408
Service
normal service intervals, always considering
the conditions of use of your v ehicl
e
.WARNING
If the services are insufficient or not per-
formed and if the service int erv
als are not
observed, the vehicle may be immobilised
in traffic and cause accidents and severe
injuries.
Page 372 of 408

Maintenance
If your SEAT vehicle is immobilised due to a
f ault or an accident, our assist
ance services
will help you k
eep moving.
Take into account that the SEAT Mobility
Service differs depending on the country in
which the vehicle was purchased. For further
information ask your SEAT dealership or the
SEAT website in your country.
Warranty
Fault-fr
ee operation warrantySEAT Authorised Services ensure the perfect
condition of ne
w v
ehicl
es. Check the pur-
chase agreement or complementary addi-
tional documentation provided by your Tech-
nical Service to see the conditions and the
terms of the warranty. Consult further infor-
mation in this regard in your SEAT Official
Service. Vehicle maintenance
Maint enance and cl
eaning
Basic consider
ations Regular and careful care helps to maintain
the value of your v
ehicl
e. In addition, it may
become a prerequisite to demand the war-
ranty in the event of corrosion damage and
deficiencies in the paint coat of the body-
work.
Specialised workshops have the necessary
care products. Please follow the instructions
for application on the packaging. WARNING