2019 Seat Ateca key

Opening and closing
After closing, the hatch locks automatically. If
the compl et
e v
ehicle is unlocked, the rear lid
will not lock automatically after closing it.
Rear lid with sensor-controlled open-
ing/closing (Easy Open)
If there is a valid vehicle key in the proximity

Operation
Keyless Access temporary disconnection
function*
Y ou can deactiv
at
e the vehicle

Operation
Audible warnings to advise the driver that
the lights hav e not been s
wit
ched off
If the key is not in the ignition and the driver
door is open, an audible warning signal is
heard in the following cases: this will remind
you to turn the light off.

Introduction
Input masks with on-screen keypad Fig. 194
Input window with on-screen keypad. Input windows with on-screen keypad are
used f
or functions such as ent
ering an entry
name
, selecting a destination address or en-
tering a search term for searching long lists.
The function buttons listed below are not
available in all countries or for all topics.
Subsequent chapters only explain those
functions that differ from those in the screen
shown in the figure.
The input line with cursor is located in the top
bar of the screen. All inputs are displayed
here.
Input windows for “free text input”
In the input masks for open text, you may en-
ter letters, numbers and special characters in
any combination. Input windows for selecting a saved entry
(e.g. selection of a destination addr

ess)
It is only possible to select a sequence of let-
ters, numbers and special characters that
matches a stored entry.
Suggestions for matching destinations ap-
pear depending on the characters entered in
the input line

Infotainment System
manually change the network key. The
netw ork k
ey must hav
e a minimum of 8
characters and a maximum of 63.
WLAN Network name (maximum of 32
characters).
Activate
the checkbox to deactivate the visibility
of the wireless (WLAN) network.
The wireless (WLAN) connection is establish-
ed. To complete the connection, it may be
necessary to enter other data into the wire-
less device.
Repeat this process to connect other wireless
devices.
Wi-Fi Protected Setup (WPS) 1)Wi-Fi Protected Setup can be used t
o cr
eat
e
a ciphered local wireless network quickly and
simply.

Start and driving
Driving
St ar
t and driving
St
arting and stopping the
engine
Switching the ignition on and start-
ing the engine with the key Fig. 240
Ignition key positions. Read the additional information carefully

Start and driving
building up in the engine compartment af-
ter it has been s
wit
ched off; this could
cause engine damage. For this reason, you
should idle the engine for approximately 2
minutes before you switch it off. Note
After the engine is switched off the radiator
f an may run on f or up t

o 10 minutes, even if
the ignition is switched off. It is also possi-
ble that the fan turns itself on once more if
the coolant temperature increases due to
the heat accumulated in the engine com-
partment or due to its prolonged exposure
to solar radiation. Starter button*
Fig. 241
In the lower part of the centre con-
sol e: st
art butt

on. Fig. 242
On the right of the steering column:
emergency st art. The vehicle engine can be started with a
st
art
er butt

on (Press & Drive). To do so, there
must be a valid key inside the vehicle in the
area of the front or rear seats.
In vehicles with the Keyless Access

Driving
before switching it off, leave it idle for ap-
pro
x. 2 minut
es in neutral. Note
After switching off the engine, the cooling
f an may continue t o oper

ate in the engine
compartment for a few more minutes, even
with the ignition off. The radiator fan is au-
tomatically switched off. “My Beat” Function
For vehicles with a convenience key there is
the “My Beat” function. This f
eat
ur

e provides
an additional indication of the vehicle ignition
system.
When accessing the vehicle, e.g. by opening
the doors with the remote control, the START ENGINE STOP button flashes, calling at-
t ention t
o the r

elevant starter system button.
Upon switching the ignition on/off, the light of
the START ENGINE STOP button flashes. With
the engine s wit
ched off

, after a few seconds,
the STOP ENGINE START button stops flashing
and goes out.
With the engine running, the S T
AR

T ENGINE STOP button light stays on, indi-
cating that the engine is running. The time
that l apses betw
een the moment the user
st

arts the engine with the START ENGINE STOPbutton and the lighting changes from flashing to fixed will depend on specific engine size
char
act
eristics. Upon s

witching the ignition
off with the START ENGINE STOP button, it starts
fl ashing again.
In v ehicl

es with the Start-Stop system, the
“My Beat” function also offers additional in-
formation: