2019 Peugeot 208 light

45
Switching the system off may result in
some discomfort (humidity, misting).
Air distribution
F Press button 3 successively to direct the air
flow towards:
-

t
he windscreen, the side windows and the
footwells,
-

t
he windscreen and side windows
(demisting or defrosting),
-

t
he central and side vents,
-

t
he central vents, the side vents and the
footwells,
-

t
he footwells.
Air flow
F Press button 2 "Full fan " to increase the air
f low.
The air flow symbol (a fan) appears in the
screen. It is filled in progressively in relation to
the value required.
F

P
ress button 2 "Empty fan " to reduce the
air f low.
Deactivating the system
F Press button 2 "Empty fan " for the air flow
until the fan symbol disappears and "- - -"
appears. This action deactivates all functions of the air
conditioning system.
Temperature is no longer regulated. A slight air
flow can still be felt however, resulting from the
for ward movement of the vehicle.
Avoid driving for too long with the system
switched off – risk of misting and of
deterioration of the air quality.
Pressing button 2 "
Full fan " reactivates the
system with the values in use at the time it was
switched off.
Recirculation of interior air
The intake of exterior air prevents the formation
of mist on the windscreen and the side
windows.
Recirculation of the interior air isolates the
passenger compartment from exterior odours
and fumes.
This allows hot or cold air to be delivered
quickly when required.
F

P
ress button 4 to recirculate the interior air/
to permit the intake of outside air.
When the interior air recirculation is active, the
symbol appears or the indicator lamp comes on
(depending on version). Avoid prolonged use of the recirculation of
interior air – Risk of formation of mist and
deterioration of the air quality!
Front demisting – defrosting
With heating
F Put the controls for air
flow 2 , temperature 1
and
air distribution 3
in the
appropriately marked position.
With manual air conditioning
F Put the controls for air flow 2 ,
temperature 1 and air distribution
3
in the appropriately marked
position.
F

F

or air conditioning, press button 5 ; its
indicator lamp comes on.
3
Ease of use and comfort

46
Courtesy lamp
Rear screen demisting –
defrosting
On/Off
F Press this button to switch on/switch off
the defrosting of the rear screen and door
mirrors (if fitted to your vehicle).
Switch off the defrosting of the rear
screen and door mirrors as soon
as appropriate, as lower current
consumption results in reduced fuel
consumption.
With automatic dual-zone
air conditioning
Auto – Visibility programme
Switching on
F Press button 7 to demist or defrost the
windscreen and side windows as quickly as
possible.
The system automatically manages the air
conditioning, air flow and air intake, and
provides optimum distribution towards the
windscreen and side windows.
Switching off
F Press button 7 or button 6 again; the
indicator lamp in button 7 goes off, and the
indicator lamp in button 6
comes on.
The system starts again with the values in use
at the time it was switched off.
With Stop & Start, when demisting/
defrosting has been activated, STOP
mode is not available. The rear screen demisting/defrosting
can only operate when the engine is
running.1.
Courtesy lamp
2. Map reading lamps
In this position, the lighting comes
on gradually:
-

w
hen the vehicle is unlocked,
-

w
hen the key is removed from the ignition,
-
w

hen opening a

door,
-
w

hen unlocking remotely.
Ease of use and comfort

47
Map reading lamps
Interior ambient lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
It switches off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0

seconds after the last door is closed.
Permanently off.
Permanent lighting.
In "permanent lighting" mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-

i
n energy economy mode,
approximately 30


seconds,
-
w

ith the engine running, unlimited.
F With the ignition on, press the corresponding switch.
Take care not to put anything in contact
with the courtesy lamp.
Switching off
The interior ambient lighting switches off
automatically when the sidelamps are switched
of f. The interior ambient lighting can be
configured in the Driving/Vehicle
menu.
Sunroof blind
Opening
F Take the blind by its handle and push it rearward to the desired position.
3
Ease of use and comfort

51
Lighting control stalk
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Travelling abroad
If planning to use your vehicle in a
country
that drives on the other side of the road,
the dipped beam headlamps must be
adjusted to avoid dazzling oncoming
drivers. Contact a
PEUGEOT dealer or
a


qualified workshop.
Selection of main lighting
mode
Lighting off (ignition off)/Front daytime
running lamps (engine running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Headlamp dipping
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining
a pull on the stalk.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Turn the ring to align the desired symbol with
the marking. Pull the stalk to switch between dipped and
main beam headlamps.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
4
Lighting and visibility

52
If the lighting is switched off automatically
(version with AUTO lighting) or the dipped
beams are switched off manually, the foglamps
and sidelamps remain on.
F
T
urn the ring rear wards to switch the
foglamps off; the sidelamps will then switch
of f.
In good or rainy weather, by day and
night, using the front and rear foglamps is
prohibited. In these situations, the power
of their beams may dazzle other drivers.
They should only be used in fog or falling
snow.
In these weather conditions, it is your
responsibility to switch on the foglamps
and dipped beam headlamps manually as
the sunshine sensor may detect sufficient
light.
Do not forget to turn off the front and rear
foglamps as soon as they are no longer
necessary.
Switching off of the lighting when the
ignition is switched off
On switching off the ignition, all of the
lighting turns off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated. Switching on the lighting after the
ignition is switched off
To reactivate the lighting control stalk, set
the ring to position "
0" - lighting off, then to
the desired position.
On opening the driver's door, a
temporary
audible signal warns the driver that the
lighting is on.
The lamps, with the exception of the
sidelamps, switch off automatically after
a
maximum duration of 30 minutes to
prevent discharging of the battery.
Direction indicators
F Lower the lighting control stalk fully when turning left.
F

R
aise the lighting control stalk fully when
turning right. If you forget to cancel the direction
indicators for more than 20
seconds, the
volume of the audible signal will increase if
the speed is above 37 mph (60 km/h).
Three flashes
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
three times.
This function can be used at any speed,
but it is particularly useful for changing
lane on fast roads.
Automatic illumination of
headlamps
When a low level of ambient light is detected by
t he sunshine sensor, the number plate lamps,
sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver. They may also come
on if rain is detected, at the same time as
automatic operation of the windscreen wipers.
As soon as the brightness returns to
a
sufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Lighting and visibility

53
Switching on
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied by
a
message on the screen.
Switching off
F Turn the ring to another position. Deactivation of the function is accompanied
by a
message in the screen.
In fog or snow, the sunshine sensor may
detect sufficient light. In this case, the
lighting will not come on automatically.
Do not cover the sunshine sensor, linked
with the rain sensor and located in the
centre of the windscreen behind the rear
view mirror; the associated functions
would no longer be controlled.
Automatic guide-me-home
lighting
When associated with automatic illumination of
headlamps, the guide-me-home lighting offers
the following additional options:
-

s
election of the lighting duration of 15, 30 or
60


seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation.
The guide-me-home lighting can be
configured in the Driving/Vehicle
menu.
In the event of a
fault with the
sunshine sensor, the lighting comes
on, this warning lamp is displayed
in the instrument panel and/or
a
message appears on the screen,
accompanied by an audible signal.
Contact a
PEUGEOT dealer or
a


qualified workshop.
Manual guide-me-home
lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting control stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual guide-me-home lighting is
also available from the remote control
lighting button.
Switching off
Manual guide-me-home lighting goes off
automatically at the end of a given period of
time.
4
Lighting and visibility

54
Headlamp beam height
adjustment
To avoid causing a nuisance to other road
u sers, the height of the headlamp beams
should be adjusted according to the load in the
vehicle.
0. 1
or 2 people in the front seats.
-. Intermediate setting.
1. 5


people.
-. 5
people + maximum authorised load.
2. Driver + maximum authorised load.
The initial setting is position " 0".
Vehicle side marking by illumination of the
sidelamps on the traffic side only.
F

W

ithin one minute after switching off the
ignition, operate the lighting control stalk up
or down, depending on the traffic side (for
example, when parked on the left, move the
lighting control stalk upwards; the right-hand
sidelamps come on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Parking lamps Daytime running lamps/
Sidelamps
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
-

D
aytime running lamps (lighting control
stalk at position " 0" or " AUTO " with
adequate light level).
-

S
idelamps (lighting control stalk at " AUTO"
position with low light levels or "Sidelamps
only" or "Dipped/main beam headlamps").
The LEDs are brighter when operating as
daytime running lamps.
Lighting and visibility

55
Cornering lighting
Activation
DeactivationWith dipped or main beam headlamps, this
system makes use of the beam from a front
foglamp to illuminate the inside of a
bend,
when the vehicle speed is below 25
mph
(approximately 40
km/h) (urban driving, winding
road, intersections, parking manoeuvres, etc.).
Without cornering lighting With cornering lighting
This function operates:
-

w
hen the corresponding direction indicator
is switched on,
or
-

f
rom a certain angle of rotation of the
steering wheel.
The system does not operate:
-

b
elow a certain angle of rotation of the
steering wheel,
-

a
bove 25 mph (40 km/h),
-
w

hen reverse gear is engaged.
Programming
It is possible to activate or deactivate
the cornering lighting from the
Driving/Vehicle menu.
This system is activated by default.
Wiper control stalk
In wintry conditions, remove snow, ice or
frost present on the windscreen, around
the wiper arms and blades and the
windscreen seal, before operating the
wipers.
Do not operate the wipers on a
dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades
are not stuck to the windscreen before
operating the wipers.
4
Lighting and visibility