2019 MAZDA MODEL CX-5 lights

[x] Cancel search: lights

Page 493 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) (Type B)
The illumination entry system does not
operate in conjunction with the
overhead lights when the overhead
lights are turned on using the overhead
light ON/OFF switch.Accessory Sockets
Only

Page 509 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) ▼Schedule 2
U.S.A. and Puerto Rico residents - Severe driving conditions ma
intenance interval
Maintenance IntervalNumber of months or kilometers (miles), whichever comes first.
Months 6 12182430364

Page 511 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) Maintenance IntervalNumber of months or kilometers (miles), whichever comes first.
Months 6 1218243036424854606672
×1000 km 8 1624324048566472808896
×1000 miles 5 10 15 20 25 30 35 40 45 50 55 60
Ai

Page 515 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) ▼Schedule 2
Maintenance Interval Number of months or kilometers, whichever comes first
Months 3 6 9 121518212427303336
×1000 km 5 1015202530354045505560
Drive belts I
Engine oil & filter 
*1RRRRRRR

Page 516 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) Chart symbols:
I: Inspect: Inspect and clean, r epair, adjust, fill up, or replac e if necessary.
R:  Replace
L:  Lubricate
C:  Clean
T:  Tighten
D:  Drain
Remarks:
*1 Reset the engine oil data whenev

Page 547 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) Light Bulbs
Side turn signal 
lights
Vanity mirror 
lights
Type A
Type B
Overhead lights/Front map 
lights
Side turn 
signal lights
Vanity mirror lights
Overhead lights/Front map 
lights Front turn si

Page 548 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) CAUTION
When removing the lens or lamp unit using
a flathead screwdriver, make sure that the
flathead screwdriver does not contact the
interior terminal. If the flathead screwdriver
contacts the termi

Page 549 of 701

MAZDA MODEL CX-5 2019  Owners Manual (in English) 3. Pull the center of each plastic retainerusing a flathead screwdriver and
remove the retainers, and then partially
peel back the over fender.
Removal
Installation
4. Pull the center of each plastic