2019 MAZDA MODEL CX-30 ignition

NOTE
xOnly make calls manually for conditions requiring urgent treatment such as illness
or serious injury.
xWhen making emergency calls manually, stop the vehicle in a safe location before
making the call.
xThe call centre will end an emergency call. The user cannot end the emergency
call.
xIf a call is disconnected or a call cannot be made to the call centre correctly, an
automatic call is made again to the call centre. To cancel the redialing, refer to
Manual emergency call cancellation.
1. Make sure that the ignition is switched ON.
2. Long-press the Emergency call switch on the overhead console and then release
your finger from the switch.
1. Emergency call switch
3. The indicator light (green) on the Emergency call switch flashes slowly (0.5
second intervals) and the call is made to the call centre.
1. Green
4. When the connection is established with the call centre, the indicator light
(green) flashes somewhat quickly (0.3 second intervals) and the beep sounds
simultaneously, and the transmission of the vehicle information begins.
5. When the transmission of the vehicle information is completed or about 20
seconds have elapsed since the transmission began, the beep sounds and the
voice call with the call centre starts.
If Trouble Arises
Mazda
ERA-GLONASS
7-18

6. If the connection fails, the indicator light (red) turns on and the indicator light
(green) flashes quickly (0.15 second intervals), and the beep sounds
simultaneously.
Make a manual emergency call again.
1. Red (Turns on)
2. Green (Flashes)
NOTE
If a call to the call centre does not connect even though the indicator light shows a
call is possible, make a call to the police or other authority by means other than the
Mazda
ERA-GLONASS.
Manual emergency call cancellation
A manual emergency call can be cancelled even after the Emergency call switch has
been pressed by pressing the switch again, as long as the call with the call centre has
not begun. If the call cannot be cancelled and the call with the call centre has
begun, tell the operator that the call is mistaken.
▼Indicator Light/Beep Sound
The indicator light turns on/flashes and beep sounds are activated to notify the
driver of the system operation status or if there is a problem with the system.
StatusIndicator light
Beep sound
statusOn/flashing conditions
Green Red Flash interval
Diagnosis Turns on Turns onŠŠWhen the ignition is switched
ON, it turns on and then
turns off after a few seconds.
NOTE
A manual emergency call is
not possible during diagnosis.
Normal Turns off Turns offŠŠThe system is operating nor-
mally.
If Trouble Arises
Mazda
ERA-GLONASS
7-19

StatusIndicator light
Beep sound
statusOn/flashing conditions
Green Red Flash interval
Malfunction Turns off Turns onŠ3 beeps
(Slow intermit-
tent sound)
xA system malfunction is
detected.
xThe remaining power of
the built-in battery is low.
CAUTION
If the indicator light (red) re-
mains on constantly, the sys-
tem will not operate normal-
ly. Have the vehicle inspected
at an expert repairer (we rec-
ommend an Authorised Maz-
da Repairer) as soon as possi-
ble.
Call being
made with call
centreFlashes Turns offSlow
(0.5 second
intervals)The beep does
not sound, but
the ringback
tone can be
heard.An emergency call is being
made by the Mazda
ERA-GLONASS.
Vehicle infor-
mation is be-
ing transmittedFlashes Turns
offSomewhat
quick
(0.3 second
intervals)Continuous in-
termittent
soundVehicle information is being
transmitted to the call centre.
Start of voice
callTu r n s o n Tu r n s o ffŠ1 beep
During a voice call with the
call centre.
During voice
callTu r n s o n Tu r n s
offŠŠ
Connection
failureFlashes Turns onQuick
(0.15 second
intervals)3 beeps
(Fast intermit-
tent sound)When an emergency call fails
to connect.
▼Te s t M o d e
The test mode function makes sure that the Mazda ERA-GLONASS can operate
normally.
Have your vehicle tested at an Authorised Mazda Repairer when performing the test
mode.
Method to start test mode
Switch the ignition ON while the parking brake is applied, and wait 2 minutes with
the vehicle stopped.
If Trouble Arises
Mazda
ERA-GLONASS
7-20

13.Install the compressor hose to the
tyre valve.

1. Valve
2. Compressor hose
14.Insert the compressor plug into the
interior accessory socket and switch
the ignition to ACC (page 5-35).

1. Compressor
2. Compressor plug
CAUTION
¾Before pulling out the compressor
plug from the electrical socket,
make sure the compressor power
switch is
off.
¾The compressor turns on and off
with the push-button switch.
15.Turn the compressor switch on and
inflate the tyre carefully to the
correct inflation pressure.
WARNING
Never operate the compressor
above 300 kPa (3.1 kgf/cm2, 3
bar, 43.5 psi):
Operating the compressor above
300 kPa (3.1 kgf/cm
2, 3 bar, 43.5
psi) is dangerous. When the
inflation pressure rises above 300
kPa (3.1 kgf/cm
2, 3 bar, 43.5 psi),
heated air will be exhausted from
the back of the compressor and you
could be burned.
NOTE
xCheck the tyre inflation pressure
label (driver's door frame) for the
correct tyre inflation pressure.
xDo not use the compressor for
longer than 10 minutes because
using the compressor for long
periods could damage it.
If Trouble Arises
Flat Tyre
7-31

Route the jumper leads away from parts that will be moving:
Connecting a jumper lead near or to moving parts (cooling fans, belts) is dangerous.
The lead could get caught when the engine starts and cause serious injury.
CAUTION
Use only a 12 V booster system. You can damage a 12 V starter, ignition system, and
other electrical parts beyond repair with a 24 V power supply (two 12 V batteries in
series or a 24 V motor generator set).
1. Move the booster vehicle so that its battery is as close as possible to your
vehicle's battery.
2. Make sure that the power such as for the headlights and air conditioner is turned
off.
3. Remove the battery cover.
4. Turn off the booster vehicle's engine and connect the jumper leads in the
following order.
Make sure that the jumper leads are securely connected so that they do not
disconnect due to engine vibrations.
1st lead
Positive (+) terminal on the discharged battery
Positive (+) terminal on booster vehicle's battery
2nd lead
Negative (-) terminal on booster vehicle's battery
If Trouble Arises
Battery Runs Out
7-40

Overheating
▼Overheating
If the engine coolant temperature
gauge indicates overheating and the
high engine coolant temperature
warning indication is displayed, the
vehicle loses power or you hear a loud
knocking or pinging noise, the engine
is probably too hot.
WARNING
Pull over to a safe location, then
switch the ignition off and make sure
the fan is not running before
attempting to work near the cooling
fan:
Working near the cooling fan when it is
running is dangerous. The fan could
continue running
indefinitely even if
the engine has stopped and the engine
compartment temperature is high. You
could be hit by the fan and seriously
injured.
Do not remove either
cooling system cap when the engine
and radiator are hot:
When the engine and radiator are hot,
scalding coolant and steam may shoot
out under pressure and cause serious
injury.
Open the bonnet ONLY after steam is
no longer escaping from the engine:
Steam from an overheated engine is
dangerous. The escaping steam could
seriously burn you.
If the engine coolant temperature
gauge indicates overheating and the
high engine coolant temperature
warning indication is displayed:

1. Drive safely to the side of the road
and park off the right-of-way.
2. Put a vehicle with an automatic
transmission in park (P), a manual
transmission in neutral.
3. Apply the parking brake.
4. Turn off the air conditioner.
5. Check whether coolant or steam is
escaping from the engine
compartment.

If steam is coming from the engine
compartment:
Do not go near the front of the
vehicle. Stop the engine.
Wait until the steam dissipates,
then open the bonnet and start the
engine.

If neither coolant nor steam is
escaping:
Open the bonnet and idle the
engine until it cools.
CAUTION
If the cooling fan does not operate
while the engine is running, the
engine temperature will increase.
Stop the engine and call an expert
repairer (we recommend an
Authorised Mazda Repairer).
6. Make sure the cooling fan is
operating, then turn off the engine
after the temperature has
decreased.
7. When cool, check the coolant level.
If Trouble Arises
Overheating
7-44

¾If the parking brake cannot be
released when towing the vehicle,
transport the vehicle with all front
and rear wheels raised off the ground
as shown in the figure. If the vehicle
is towed without raising the wheels
off the ground, the brake system
could be damaged.
1. Wheel dollies
If towing service is not available in an
emergency, the vehicle may be towed
with all four wheels on the ground
using the towing hook at the front of
the vehicle.
Only tow the vehicle on paved surfaces
for short distances at low speeds.
CAUTION
Follow these instructions when towing
the vehicle with all wheels on the
ground.
1. Shift to neutral (Manual
transmission), or the N position
(Automatic transmission).
2. Switch the ignition to ON.
3. Release the parking brake.
Refer to Electric Parking Brake (EPB)
on page 4-70.
Remember that power assist for the
brakes and steering will not be
available when the engine is not
running.
Towing Hooks
▼Towing Hooks
CAUTION
¾The towing eyelet should be used in
an emergency (to get the vehicle out
of a ditch or a snow bank, for
example).
¾When using the towing eyelets,
always pull the lead or chain in a
straight direction with respect to the
eyelet. Never apply a sideways force.
NOTE
When towing with chain or lead, wrap
the chain or lead with a soft cloth near
the bumper to prevent damage to the
bumper.
1. Remove the towing eyelet, wheel
brace, and the jack lever or
equivalent from the luggage
compartment (page 7-24).
2. Wrap a flathead screwdriver or jack
lever or a similar tool with a soft
cloth to prevent damage to a
painted bumper, and open the cap
located on the front or rear
bumper.
Front
If Trouble Arises
Emergency Towing
7-47

If a Warning Light Turns
On or Flashes
▼If a Warning Light Turns On or
Flashes
If any warning light turns on/flashes,
take appropriate action for each light.
There is no problem if the light turns
off, however if the light does not turn
off or turns
on/flashes again, consult
an expert repairer (we recommend an
Authorised Mazda Repairer).
The details for some warnings can be
viewed on the centre display or
multi-information display in the
instrument cluster.
Centre display
1. Select “Information” on the home
screen.
2. Select “Vehicle Status Monitor”.
3. Select the applicable warning to
view the warning details.
NOTE
You can also display the currently
occurring warning by sliding the
commander knob to the left while on
the home screen of the centre display.
Multi-information display
1. Press the INFO switch on the
steering switch to display the
warning indication screen.
Refer to Multi-information Display
on page 4-23.
▼Brake System Warning Indication/
Warning Light (Red)
This warning has the following
functions:
Warning light inspection
For an operation check, make sure that
the light turns on when the ignition is
switched on, and turns off a few
seconds later or when the engine is
started.
When the light turns on
If the brake system warning light
remains illuminated the brake fluid
may be low or there could be a
problem with the brake system. Park
the vehicle in a safe place immediately
and contact an expert repairer (we
recommend an Authorised Mazda
Repairer).
Refer to Inspecting Brake/Clutch Fluid
Level on page 6-30.
WARNING
Do not drive with the brake system
warning light illuminated. Contact an
expert repairer (we recommend an
Authorised Mazda Repairer) to have
the brakes inspected as soon as
possible:
Driving with the brake system warning
light illuminated is dangerous. It
indicates that your brakes may not
work at all or that they could
completely fail at any time. If this light
remains illuminated, after checking
that the parking brake is fully released,
have the brakes inspected
immediately.
CAUTION
¾In addition, the
effectiveness of the
braking may diminish so you may
need to depress the brake pedal
more strongly than normal to stop
the vehicle.
¾(With M Hybrid)
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-49