2019 MAZDA MODEL CX-30 engine

x(Manual transmission)
If the vehicle is stopped by the
SBS-RC operation and the clutch
pedal is not depressed, the engine
stops.
xWhen the system operates, the user
is notified by the multi-information
display.
xThe collision warning beep sounds
intermittently while the SBS-RC
brake is operating.
xIf the vehicle is stopped by the
SBS-RC operation and the brake
pedal is not depressed, displaying in
meter “Emergency Braking Activated.
Depress Brake Pedal to Hold Stop”,
after about 2 seconds and the
SBS-RC brake is automatically
released.
xIf a Mazda genuine trailer hitch is
used, the SBS-RC is automatically
turned off.
▼Collision Warning
If there is a possibility of a collision, the
collision warning sound is activated
continuously and a warning is
displayed on the active driving display
and the multi-information display.
Multi-information display
1. “BRAKE!” message is displayed

Active driving display
1. “BRAKE!” message is displayed
▼Stopping the Smart Brake Support
[Rear Crossing]
(SBS-RC) System
Operation
The SBS-RC can be changed to
inoperable.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
When the SBS-RC is cancelled, the SBS
OFF indicator light turns on.
NOTE
xWhen the ignition is switched OFF
while the SBS-RC is cancelled, the
SBS-RC is automatically enabled the
next time the ignition is switched
ON.
xWhen the SBS-RC is cancelled, the
Smart Brake Support [Rear] (SBS-R)
is also cancelled.
When Driving
i-ACTIVSENSE
4-184

30 km/h (19 mph) or more and press
the RES switch.
▼To Te m p o ra r i l y C a n c e l
To temporarily cancel the system, use
one of these methods:
xSlightly depress the brake pedal.xPress the CANCEL switch.x(Manual transmission)
Depress the clutch pedal.
If the RES switch is pressed when the
vehicle speed is 30 km/h (19 mph) or
higher, the system reverts to the
previously set speed.
NOTE
xIf any of the following conditions
occur, the cruise control system is
temporarily cancelled.
xEven when the brake pedal is
slightly depressed.
xThe DSC is operating.xThere is a problem in the system.xAny of the doors is opened.xThe driver's seat belt is unfastened.xThe parking brake is applied.x(Automatic transmission)
The selector lever is in the P or N
position.
x(Manual transmission)
The shift lever is in the neutral
position.
xWhen the cruise control system is
temporarily cancelled by even one of
the applicable cancel conditions, the
speed cannot be re-set.
x(Automatic transmission)
The cruise control cannot be
cancelled while driving in manual
mode (selector lever shifted from D
to M position). Therefore, engine
braking will not be applied even if
the transmission is shifted down to a
lower gear. If deceleration is
required, lower the set speed or
depress the brake pedal.
▼To D e a c t i va t e
Press the cruise switch again.
When Driving
Cruise Control
4-231

Petrol Particulate Filter
(SKYACTIV-X 2.0)
▼Petrol Particulate Filter
The petrol particulate filter collects and
removes most of the particulate matter
(PM) in the exhaust gas of a petrol
engine.
PM collected by the petrol particulate
filter is cleared during normal driving ,
however, PM may not be removed and
the petrol particulate filter warning
indication/warning light may
illuminate under the following
conditions:
xIf the vehicle is driven at 20 km/h
(12 mph) or less continuously.
xIf the vehicle is repeatedly driven for
a short period of time (30 minute or
less) or driven while the engine is
cold.
xIf the vehicle is idled for a long time.
Refer to Petrol Particulate Filter
Warning Indication/Warning Light on
page 7-54.
When Driving
Petrol Particulate Filter
4-236

Diesel Particulate Filter
(SKYACTIV-D 1.8)
▼Diesel Particulate Filter
The diesel particulate filter collects and
removes most of the particulate matter
(PM) in the exhaust gas of a diesel
engine.
PM collected by the diesel particulate
filter is cleared during normal driving ,
however, PM may not be removed and
the diesel particulate filter warning
indication/warning light may
illuminate under the following
conditions:
xIf the vehicle is driven at 15 km/h (9
mph) or less continuously.
xIf the vehicle is repeatedly driven for
a short period of time (10 minute or
less) or driven while the engine is
cold.
xIf the vehicle is idled for a long time.
Refer to Diesel Particulate Filter on
page 7-54.
When Driving
Diesel Particulate Filter
4-237

xThe sensor area is frozen (Returns to normal operation when the ice is thawed).xThe sensor is covered by a hand.xThe sensor is excessively shocked.xThe vehicle is excessively tilted.xUnder extremely hot or cold weather conditions.xThe vehicle is driven on bumps, inclines, gravel, grating , or grass covered roads.xAnything which generates ultrasonic waves such as another vehicle's horn, the
engine sound of a motorcycle, the air brake sound of a large-sized vehicle, or
another vehicle's sensors approaches the vehicle.
xThe vehicle is driven in heavy rain or in road conditions causing water-splash.xA commercially-available wing pole or an aerial for a radio transmitter is
installed to the vehicle.
xThe vehicle is moving towards a tall or square curbstone, or a steep grade.xAn obstruction is too close to the sensor.xThe vehicle is moving towards an uneven wall or stairs.xThere are multiple obstructions.xThe vehicle is driven in a place with low ceilings.xObstructions under the bumper cannot be detected. Obstructions which are
lower than the sensor or thin may not be detected even though they were
detected once.
xThe following types of obstructions may not be detected:
xThin objects such as wire, rope or polesxThings which absorb sonic waves easily such as cotton or snowxAngular shaped objectsxVery tall objects, and those which are wide at the topxSmall, short objectsxAlways have the system inspected at an expert repairer (we recommend an
Authorised Mazda Repairer) if any shock is applied to the bumpers, even in a
minor accident. If the sensors are deviated, they cannot detect obstructions.
xThe system may have a malfunction if the indicator light does not turn on even
when the parking sensor switch is turned on. Have your vehicle inspected by an
expert repairer (we recommend an Authorised Mazda Repairer).
xThe system may have a malfunction if a message indicating a system malfunction is
displayed. Have your vehicle inspected by an expert repairer (we recommend an
Authorised Mazda Repairer).
xA message may be displayed even when the ambient temperature is extremely
cold, or mud, ice, or snow adheres to the sensor area. Remove any foreign matter
from the sensor area.
xWhen installing a trailer hitch, consult an expert repairer (we recommend an
Authorised Mazda Repairer).
xIf a Mazda genuine trailer hitch is used, the rear side of the parking sensor system
is automatically turned
off.
When Driving
Parking Sensor System
4-253

Operating Tips
▼Operating Tips
xOperate the air-conditioning system
with the engine running.
xTo prevent the battery from being
discharged, do not leave the fan
control dial/switch on for a long
period of time with the ignition
switched ON when the engine is not
running.
x(With i-stop)
The
airflow amount may decrease
slightly while the i-stop function is
operating.
xClear all obstructions such as leaves,
snow and ice from the bonnet and
the air inlet in the cowl grille to
improve the system efficiency.
xUse the air-conditioning system to
defog the windows and dehumidify
the air.
xThe recirculate mode should be used
when driving through tunnels or
while in a
traffic jam, or when you
would like to shut off outside air for
quick cooling of the interior.
xUse the outside air position for
ventilation or windscreen defrosting.
xIf the vehicle has been parked in
direct sunlight during hot weather,
open the windows to let warm air
escape, then run the air-conditioning
system.
xRun the air conditioner about 10
minutes at least once a month to
keep internal parts lubricated.
xHave the air conditioner checked
before the weather gets hot. Lack of
refrigerant may make the air
conditioner less efficient.
The refrigerant specifications are
indicated on a label attached to the
inside of the engine compartment. If
the wrong type of refrigerant is used,
it could result in a serious
malfunction of the air conditioner.
Consult a professional, government
certified repairer for the inspection
or repair because a special device is
required for the air conditioner
maintenance.
For details, consult an expert repairer
(we recommend an Authorised
Mazda Repairer).
1. Label
Interior Features
Air-Conditioning System
5-2

NOTE
The air conditioner may not function
when the outside temperature
approaches 0 °C (32 °F).
Air intake selector switch
This switch controls the source of air
entering the vehicle.

Outside or recirculated air positions
can be selected. Press the switch to
select outside/recirculated air
positions.
Recirculated air position (indicator
light illuminated)
Outside air is shut off. Use this position
when going through tunnels, driving in
congested
traffic (high engine exhaust
areas) or when quick cooling is
desired.
Outside air position (indicator light
turned off)
Outside air is allowed to enter the
cabin. Use this mode for ventilation or
windscreen defrosting.
WARNING
Do not use the position (indicator
light turns on) in cold or rainy
weather:
Using the
position (indicator light
turns on) in cold or rainy weather is
dangerous as it will cause the windows
to fog up. Your vision will be
hampered, which could lead to a
serious accident.
Windscreen defroster switch
Press the switch to defrost the
windscreen and front door windows.
Refer to Windscreen Defrosting and
Defogging on page 5-7.
Rear window defogger switch
Press the rear window defogger switch
to defrost the rear window.
Refer to Rear Window Defogger on
page 4-66.
▼Heating
1. Press the switch.
2. Set the air intake selector to the
outside air position (indicator light
turns off).
3. Set the temperature control dial to
the hot position.
4. Set the fan control dial to the
desired speed.
5. If dehumidified heating is desired,
turn on the air conditioner.
NOTE
xIf the windscreen fogs up easily, press
the
switch.xIf cooler air is desired at face level,
press the
switch and adjust the
temperature control dial to maintain
maximum comfort.
xThe air to the
floor is warmer than air
to the face (except when the
temperature control dial is set at the
extreme hot or cold position).
▼Cooling
1. Press the switch.
2. Set the temperature control dial to
the cold position.
3. Set the fan control dial to the
desired speed.
4. Turn on the air conditioner by
pressing the A/C switch.
5. After cooling begins, adjust the fan
control dial and temperature
control dial as needed to maintain
maximum comfort.
Interior Features
Air-Conditioning System
5-6

CAUTION
If the air conditioner is used while
driving up long hills or in heavy traffic,
monitor the high engine coolant
temperature warning indication to see
if it is displayed (page 7-51).
The air conditioner may cause engine
overheating. If the warning indication
is displayed, turn the air conditioner
off (page 7-44).
NOTE
xWhen maximum cooling is desired,
set the temperature control dial to
the extreme cold position and set
the air intake selector to the
recirculated air position, then turn
the fan control dial fully clockwise.
xIf warmer air is desired at
floor level,
press the
switch and adjust the
temperature control dial to maintain
maximum comfort.
xThe air to the floor is warmer than air
to the face (except when the
temperature control dial is set at the
extreme hot or cold position).
▼Ventilation
1. Press the switch.
2. Set the air intake selector to the
outside air position (indicator light
turns off).
3. Set the temperature control dial to
the desired position.
4. Set the fan control dial to the
desired speed.
▼Windscreen Defrosting and
Defogging
1. Press the switch.
2. Set the temperature control dial to
the desired position.
3. Set the fan control dial to the
desired speed.
4. If dehumidified heating is desired,
turn on the air conditioner.
WARNING
Do not defog the windscreen using
the
switch with the temperature
control set to the cold position:
Using the
switch with the
temperature control set to the cold
position is dangerous as it will cause
the outside of the windscreen to fog
up. Your vision will be hampered,
which could lead to a serious accident.
Set the temperature control to the hot
or warm position when using the
switch.
NOTE
xFogging on the windows clears up
more easily while the air conditioner
is on, but they will fog up more easily
if the air conditioner is turned
off.
xBe careful that the windows do not
fog up when doing any of the
following:
xSwitching to recirculate modexTurning off the air conditionerxFor maximum defrosting , turn on the
air conditioner, set the temperature
control dial to the extreme hot
position, and turn the fan control
dial fully clockwise.
xIf warm air is desired at the floor,
press the
switch.
xWith the switch, the outside air
position is automatically selected to
defrost the windscreen. The air
intake selector cannot be changed to
the recirculated air position.
Interior Features
Air-Conditioning System
5-7