2019 MAZDA MODEL 2 oil change

¾The front doors or the boot is not fully closed.
¾The vehicle is on a road incline.
¾The door mirrors are retracted.
¾Do not hit the front/rear camera, front bumper, and door mirrors forcefully. The camera
position or installation angle may shift.
¾The cameras are of a waterproof structure. Do not disassemble, modify, or remove a
camera.
¾The camera cover is made of hard plastic, therefore do not apply oil film remover, organic
solvents, wax, or coating agents. If any such agent gets on the camera cover, wipe it off
using a soft cloth immediately.
¾Do not rub the camera lens forcefully, or clean it with an abrasive or hard brush. Otherwise,
it could scratch the camera lens and negatively affect the images.
¾Consult an expert repairer (we recommend an Authorised Mazda Repairer) for repair,
painting, or replacement of the front/rear camera, front bumper and door mirrors.
¾Heed the following cautions to assure that the 360°View Monitor operates normally.
¾Do not modify the vehicle suspensions or lower/raise the vehicle body, or both.
¾Always use wheels of the specified type and size for the front and rear wheels. Consult an
expert repairer (we recommend an Authorised Mazda Repairer) for tyre replacement.
¾When the display is cold, images may leave trails or the screen might be darker than usual,
making it difficult to check the vehicle surroundings. Always confirm the safety at the front
and around the vehicle visually when driving.
¾The method for parking/stopping the vehicle using the 360°View Monitor differs depending
on the road circumstances/conditions and the vehicle conditions. When and how much you
turn the steering wheel will differ depending on the situation, , therefore always check the
vehicle surroundings directly with your eyes while using the system.
Also, before using the system, always make sure that the vehicle can be parked/stopped in
the parking/stopping space.
NOTE
xIf there are water droplets, snow, or mud on the camera lens, wipe it off using a soft cloth.
If the camera lens is especially dirty, wash it off with mild detergent.
xIf the area where the camera is installed, such as the boot (Saloon)/rear bumper
(Hatchback) or door mirrors, has been damaged in a vehicle accident, the camera
(position, installation angle) may have shifted. Always consult an expert repairer (we
recommend an Authorised Mazda Repairer) to have the vehicle inspected.
xIf the camera is subjected to excessive changes in temperature such as by pouring hot
water on the camera during cold weather, the 360°View Monitor may not operate
normally.
xIf the battery voltage is low, the screen might be temporarily difficult to view, however,
this does not indicate a problem.
:KHQ'ULYLQJ
L$&7,96(16(


¾Do not hit or apply strong force to the Forward Sensing Camera (FSC) or the area around
it. If the Forward Sensing Camera (FSC) is severely hit or if there are cracks or damage
caused by
flying gravel or debris in the area around it, stop using the following systems
and consult an expert repairer (we recommend an Authorised Mazda Repairer).
¾High Beam Control System (HBC)
¾Adaptive LED Headlights (ALH)
¾Lane Departure Warning System (LDWS)
¾Driver Attention Alert (DAA)
¾Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
¾Traffic Sign Recognition System (TSR)
¾Advanced Smart City Brake Support (Advanced SCBS)
¾Smart City Brake Support [Forward] (SCBS F)
¾Smart Brake Support (SBS)
¾The direction in which the Forward Sensing Camera (FSC) is pointed has been finely
adjusted. Do not change the installation position of the Forward Sensing Camera (FSC) or
remove it. Otherwise, it could result in damage or malfunction.
¾Always use tyres for all wheels that are of the
specified size, and the same manufacturer,
brand, and tread pattern. In addition, do not use tyres with significantly different wear
patterns on the same vehicle as the system may not operate normally.
¾The Forward Sensing Camera (FSC) includes a function for detecting a soiled windscreen
and informing the driver, however, depending on the conditions, it may not detect plastic
shopping bags, ice or snow on the windscreen. In such cases, the system cannot accurately
determine a vehicle ahead and may not be able to operate normally. Always drive carefully
and pay attention to the road ahead.
NOTE
xIn the following cases, the Forward Sensing Camera (FSC) cannot detect target objects
correctly, and each system may be unable to operate normally.
xThe height of the vehicle ahead is low.
xYou drive your vehicle at the same speed as the vehicle ahead.
xHeadlights are not turned on during the night or when going through a tunnel.
xIn the following cases, the Forward Sensing Camera (FSC) may not be able to detect
target objects correctly.
xUnder bad weather condition, such as rain, fog and snow.
xThe window washer is being used or the windscreen wipers are not used when it's
raining.
xIce, fog, snow, frost, rainfall, dirt, or foreign matter such as a plastic bag is stuck on the
windscreen.
xTrucks with low loading platforms and vehicles with an extremely low or high profile.
:KHQ'ULYLQJ
L$&7,96(16(


&$87,21
Heed the following precautions to assure correct operation of each system.
¾Do not adhere stickers (including transparent stickers) to the surface of the radiator grille
and front emblem in and around the radar sensor (front), and do not replace the radiator
grille and front emblem with any product that is not a genuine product designed for use
with the radar sensor (front).
¾The radar sensor (front) includes a function for detecting soiling of the radar sensor's front
surface and informing the driver, however, depending on the conditions, it may require
time to detect or it may not detect plastic shopping bags, ice or snow. If this occurs, the
system may not operate correctly, therefore always keep the radar sensor (front) clean.
¾Do not install a grille guard.
¾If the front part of the vehicle has been damaged in a vehicle accident, the position of the
radar sensor (front) may have moved. Stop the system immediately and always have the
vehicle inspected at an expert repairer (we recommend an Authorised Mazda Repairer).
¾Do not use the front bumper to push other vehicles or obstructions such as when pulling
out of a parking space. Otherwise, the radar sensor (front) could be hit and its position
deviated.
¾Do not remove, disassemble, or modify the radar sensor (front).
¾For repairs, replacement or paint work around the radar sensor (front), consult an expert
repairer (we recommend an Authorised Mazda Repairer).
¾Do not modify the suspension. If the suspension are
modified, the vehicle's posture could
change and the radar sensor (front) may not be able to correctly detect a vehicle ahead or
an obstruction.
:KHQ'ULYLQJ
L$&7,96(16(