7
Hood Latch
To open the hood, pull the hood release handle located
below the instrument panel . Slightly lift the hood upward
and pull the lever to the left to unlock the hood. Then insert
the support rod into the slot.
To close the hood, drop it from a height of 8-12 inches
(20-30 cm). If the hood sensor detects the hood is not
completely latched shut, the wipers will not function.
Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.
Sun Visors
Pull down the sun visor to block glare from the front.
Remove the sun visor from the center mount by lifting
it slightly and swing it to the side to block glare from
the side window.
Slide the sun visor out from the mount to further
extend the visor location.
Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.
To apply the parking brake, press the
electric parking brake handle
located
below the instrument panel, regardless of
the ignition switch position.
To release the parking brake, pull the
electric parking brake handle
toward
you while the ignition is on. The parking
brake will be automatically released when
you depress the accelerator pedal as long
as certain conditions are met, such as
having your seatbelt fastened.
Please see your Owner’s Manual for important safety
information, system limitations, and additional operating
and feature information.
Parking Brake
8
MANUAL SEAT ADJUSTMENTS (IF SO EQUIPPED)
Forward and backward adjustment:
Pull the lever
, located under the seat, up and hold it while sliding
the seat forward or backward and release it to lock the seat in the
preferred position. When returning the seatback to the upright position,
always be certain it is completely secured in the latched position.
Seat angle adjustment:
Turn the hand-wheel
forward or backward to adjust the angles so
that your thighs are lightly supported.
Seat lifter:
Repeatedly pull up or push down the adjusting lever
to adjust the
seat height to the desired position.
Seatback angle:
Relieve the pressure on the seatback and turn the hand-wheel
forward or backward to adjust the seatback angle.
Seat Adjustments
LUMBAR SUPPORT
Push each side of the adjusting switch
to adjust the seat lumbar area
until the desired position is achieved.
POWER SEAT ADJUSTMENTS (IF SO EQUIPPED)
Forward and backward adjustment:
Move the adjusting switch
, located on the door, forward or backward
to the desired position.
Reclining:
Move the adjusting switch
forward or backward to the desired position.
Seat lifter (if so equipped):
1.
Pull up or
push down the adjusting switch
to adjust the seat
height until the desired position is achieved.
2.
T
ilt up or down the adjusting switch
to adjust the front angle of
the seat until the desired position is achieved.
Please see your Owner’s Manual for important safety information, system limitations, and
additional operating and feature information.
