2019 HYUNDAI I10 window

5-27
05
The ignition switch must be in the ON
position to be able to raise or lower
the windows. Each door has a Power
:LQGRZ VZLWFK WR FRQWURO WKDW GRRU

5-28
Convenient features
To reset the power windows
If the power windows do not operate
normally, the automatic power win-
dow system must be reset as follows:
1. Place the ignition switch to the ON
position.
2. Close the window and continue
pulling up on the power window
switch for at least one second.
If the power windows do not operate
properly after resetting, it is recom-
mended that the system be checked
by a HYUNDAI authorised repairer.
WARNING
The automatic reverse feature
doesn’t activate whilst resetting
power window system. Make sure
body parts or other objects are
safely out of the way before clos-
ing the windows to avoid injuries
or vehicle damage.
Automatic reverse (if equipped)
OLF044032
If a window senses any obstacle
whilst it is closing automatically, it will
VWRS DQG ORZHU DSSUR[LPDWHO\  FP
 LQFKHV WR DOORZ WKH REMHFW WR EH
cleared.
If the window detects the resistance
whilst the power window switch is
pulled up continuously, the window
will stop upward movement then
ORZHUDSSUR[LPDWHO\FPLQFK
If the power window switch is pulled
up continuously again within 5 sec-
onds after the window is lowered by
the automatic window reverse fea-
ture, the automatic window reverse
will not operate.
i Information
7he automatic reverse feature is only
active when the “Auto 8p” feature is
used by fully pulling up the switch to
the second detent.
WARNING
Make sure body parts or other
objects are safely out of the way
before closing the windows to
avoid injuries or vehicle damage.
Objects less than 4 mm (0.16 inch)
in diameter caught between the
window glass and the upper win-
dow channel may not be detected
by the automatic reverse window
and the window will not stop and
reverse direction.
NOTICE
Do not install any accessories on
the windows. The automatic reverse
feature may not operate.

5-29
05
Power window lock switch
OAC3059016R
The driver can disable the power win-
GRZVZLWFKHVRQWKHUHDUSDVVHQJHUV

5-32
Convenient features
NOTICE
Make certain that you close the
tailgate before driving your vehi-
FOH3RVVLEOHGDPDJHPD\RFFXUWR
the tailgate lift cylinders and
attaching hardware if the tailgate
is not closed prior to driving.
Closing the tailgate
To close the tailgate, lower and push
down the tailgate firmly. Make sure
that the tailgate is securely latched.
WARNING
Make sure your hands, feet and
other parts of your body are safely
out of the way before closing the
tailgate.
CAUTION
Make sure nothing is near the tail-
gate latch and striker whilst clos-
ing the tailgate. It may damage the
tailgate's latch.
WARNING
Exhaust fumes
If you drive with the tailgate
opened, you will draw dangerous
exhaust fumes into your vehicle
which can cause serious injury or
death to vehicle occupants.
If you must drive with the tailgate
opened, keep the air vents and all
windows open so that additional
outside air comes into the vehicle.
WARNING
Always keep the tailgate lid com-
pletely closed whilst the vehicle is
in motion. If it is left open or ajar,
poisonous exhaust gases contain-
ing carbon monoxide (CO) may
enter the vehicle and serious ill-
ness or death may result.
WARNING
Rear cargo area
Occupants should never ride in the
rear cargo area where no restraints
are available. To avoid injury in the
event of an accident or sudden
stops, occupants should always be
properly restrained.

5-53
05
MANUAL CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059100
1. Temperature control knob
2. Fan speed control knob
3. Mode selection knob
4. Air intake control button
(recirculated air position or outside
(fresh) air position)$&$LUFRQGLWLRQLQJEXWWRQ
(if equipped)
6. Rear window defroster button
(if equipped)

5-55
05
OAI3059118
The mode selection knob controls the
direction of the air flow through the
ventilation system.
Air can be directed to the floor, dash-
board outlets, or windscreen. Five
symbols are used to represent Face,
Bi-Level, Floor, Floor-Defrost and
Defrost air position.
Face-Level (B, ')
Air flow is directed toward the upper
body and face. Additionally, each out-
let can be controlled to direct the air
discharged from the outlet.
Bi-Level (B, C, ')
Air flow is directed towards the face
and the floor.
Floor-Level (A, C, ')
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windscreen,
side window defrosters and side
vents.
Floor/'efrost-Level (A, C, ')
Most of the air flow is directed to the
floor and the windscreen with a small
amount directed to the side window
defrosters and side vents.
'efrost-Level (A, ')
Most of the air flow is directed to the
windscreen with a small amount of air
directed to the side vents.

5-59
05
i Information
‡ When using the air conditioning sys-
tem, monitor the temperature gauge
closely whilst driving up hills or in
heavy traffic when outside tempera-
tures are high. Air conditioning sys-
tem operation may cause engine
overheating. Continue to use the
blower fan but turn the air condi-
tioning system off if the temperature
gauge indicates engine overheating.
‡ When opening the windows in humid
weather, air conditioning may create
water droplets inside the vehicle.
Since excessive water droplets may
cause damage to electrical equip-
ment, air conditioning should only
be used with the windows closed.
Air conditioning system operation
tips

5-62
Convenient features
AUTOMATIC CLIMATE CONTROL SYSTEM
ãIF EQUIPPED
ä
OAI3059101I
1. Fan speed control knob
$&$LUFRQGLWLRQLQJEXWWRQ
5HFLUFXODWLRQPRGH)UHVKPRGH
4. Mode selection button
5. Rear window defroster button
(if equipped)6. Front windscreen defroster button
7. OFF button
8. Temperature control knob
9. AUTO (automatic control) button
10. Climate control screen