2019 HYUNDAI I10 brake light

4-9
04
Parking Brake & Brake
Fluid Warning Light
7his warning light illuminates
‡When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- It illuminates for approximately 3
seconds
- It remains on if the parking brake
is applied.
‡When the parking brake is applied.
‡When the brake fluid level in the
reservoir is low.
- If the warning light illuminates
with the parking brake released, it
indicates the brake fluid level in
the reservoir is low.
If the brake fluid level in the reser-
voir is low
1. Drive carefully to the nearest safe
location and stop your vehicle.
2. With the engine stopped, check
the brake fluid level immediately
and add fluid as required (For
more details, refer to “Brake
Fluid” in chapter 8). After adding
brake fluid, check all brake compo-
nents for fluid leaks. If a brake fluid
leak is found, or if the warning light
remains on, or if the brakes do not
operate properly, do not drive the
vehicle. We recommend that you
have the vehicle inspected by a
HYUNDAI authorised repairer.
'ual-diagonal braking system
Your vehicle is equipped with dual-di-
agonal braking systems. This means
you still have braking on two wheels
even if one of the dual systems should
fail.
With only one of the dual systems
working, more than normal pedal
travel and greater pedal pressure are
required to stop the vehicle.
Also, the vehicle will not stop in as
short a distance with only a portion of
the brake system working.
If the brakes fail whilst you are driv-
ing, shift to a lower gear for additional
engine braking and stop the vehicle
as soon as it is safe to do so.
WARNING
Parking Brake & Brake Fluid
Warning Light
Driving the vehicle with a warning
light ON is dangerous. If the
Parking Brake & Brake Fluid
Warning Light illuminates with the
parking brake released, it indicates
that the brake fluid level is low.
In this case, we recommend that
you have the vehicle inspected by
a HYUNDAI authorised repairer.

4-10
Instrument cluster
Anti-lock Brake
System (ABS) Warning
Light
7his warning light illuminates
‡When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- It illuminates for approximately 3
seconds and then goes off.
‡When there is a malfunction with
the ABS (The normal braking sys-
tem will still be operational without
the assistance of the anti-lock brake
system).
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
Electronic Brake Force
Distribution (EBD)
System Warning Light
7hese two warning lights illuminate
at the same time whilst driving
‡When the ABS and regular brake
system may not work normally.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
WARNING
Electronic Brake Force
Distribution (EBD) System
Warning Light
When both ABS and Parking Brake
& Brake Fluid Warning Lights are
on, the brake system will not work
normally and you may experience
an unexpected and dangerous sit-
uation during sudden braking.
In this case, avoid high speed driv-
ing and abrupt braking.
We recommend you have the vehi-
cle inspected by a HYUNDAI autho-
rised repairer as soon as possible.
i Information
- Electronic Brake Force
Distribution (EBD) System
Warning Light
When the ABS Warning Light is on or
both ABS and Parking Brake Brake
Fluid Warning Lights are on, the
speedometer, odometer, or tripmeter
may not work. Also, the (PS Warning
Light may illuminate and the steering
effort may increase or decrease.
In this case, we recommend you have
the vehicle inspected by a +<81'AI
authorised repairer as soon as possible.

4-15
04
Low Tire Pressure
Warning Light
(if equipped)
7his warning light illuminates
‡When you set the ignition switch or
Engine Start/Stop button to the ON
position.
- It illuminates for approximately 3
seconds and then goes off.
‡When one or more of your tyres are
significantly underinflated (The
location of the underinflated tyres
are displayed on the LCD display).
For more details, refer to “Tyre
Pressure Monitoring System
(TPMS)” in chapter 7.
7his warning light remains on after
blinking for appro[imately 6 sec-
onds or repeatedly blinks on and off
at appro[imately 3 second intervals
‡When there is a malfunction with
the TPMS.
In this case, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer as
soon as possible.
For more details, refer to “Tyre
Pressure Monitoring System
(TPMS)” in chapter 7.
WARNING
Safe Stopping
‡The TPMS cannot alert you to
severe and sudden tyre damage
caused by external factors.
‡If you notice any vehicle instabil-
ity, immediately take your foot
off the accelerator pedal, apply
the brakes gradually with light
force, and slowly move to a safe
position off the road.
Exhaust System (GPF)
Warning Light
(Petrol Engine,
if equipped)
7his warning light illuminates

4-19
04
Press Brake
(for Automated Manual
Transmission)
7his indicator light illuminates 

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed
when the engine oil level should be
checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as
required.
Slowly pour the recommended oil lit-
tle by little into a funnel. (Oil refill
capacity : approximately 0.15 ~ 0.26
gal. (0.6 ~ 1.0 l)
Use only the specified engine oil.
(Refer to "Recommended lubricants
and capacities" in chapter 8.)
Do not overfill the engine oil. Make
sure the oil level is not above F (Full)
mark on the dipstick.
NOTICE
If the message is displayed contin-
uously after adding the engine oil
and travelling approximately
50~100 km after the engine warms
up, we recommend that the system
be checked by a HYUNDAI autho-
rised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means
that the engine is overheated and
may be damaged.
If your vehicle is overheated, refer
to “Overheating” in chapter 7.
Check headlight (if equipped)
This warning message is displayed if
the headlamps are not operating
properly.
In addition, if a specific lamp(turn sig-
nal lamp etc.) is not operating proper-
ly, the warning message according to
a specific lamp (turn signal lamp etc.)
is displayed. A corresponding bulb
may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.
Check brake light (if equipped)
This warning message is displayed if
the stop lamps are not operating
properly. A lamp may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same watt-
age rating.

4-29
04
User settings mode
In this mode, you can change the set-
tings of the instrument cluster, doors,
lamps, etc.
1. Driver Assistance
2. Lights
3. Door
4. Convenience
5. Service interval
6. Other Features
7. Language
8. Reset
The information provided may dif-
fer depending on which functions
are applicable to your vehicle.
(ngage parking brake to edit set-
tings
This warning message illuminates if
you try to select an item from the User
Settings mode whilst driving.
For your safety, change the User
Settings after parking the vehicle,
applying the parking brake and press-
ing the P (Park) button.
4uick guide (+elp)
This mode provides quick guides for
the systems in the User Settings
mode.
Select an item, press and hold the
OK button.
For more details about each sys-
tem, refer to this Owner’s Manual.

5-30
Convenient features
Bonnet
Opening the bonnet
OAC3059017R
1. Make sure the shift lever is in N
(Neutral, for Automated manual
transmission) or first gear or R
(Reverse, for Manual transmis-
sion) and set the parking brake.
2. Pull the release lever to unlatch the
bonnet. The bonnet should pop up
slightly.
OAC3059018TU
3. Go to the front of the vehicle, raise
the bonnet slightly, push the sec-
ondary latch up (1) inside of the
bonnet centre and lift the bonnet
(2).
OAC3059019TU
4. Pull out the stay-rod from the bon-
net.
5. Hold the bonnet opened with the
stay rod.
Closing the bonnet
1. Before closing the bonnet, check
the following:


5-43
05
NOTICE
If the driver exits the vehicle
through another door besides the
driver door, the battery saver func-
tion does not operate and the
headlight delay function does not
WXUQ2))DXWRPDWLFDOO\
This may cause the battery to dis-
charge. To avoid battery dis-
FKDUJH WXUQ 2)) WKH KHDGOLJKWV
manually from the headlight switch
before exiting the vehicle.
Daytime running light (DRL)
(if equipped)
The Daytime Running Lights (DRL)
can make it easier for others to see
the front of your vehicle during the
day, especially after dawn and before
sunset.
The DRL system will turn the dedi-
cated light OFF when:
1. The parking brake is applied.
2. The engine is turned off.
Headlight levelling device
OAC3059028R
7R DGMXVW WKH KHDGOLJKW EHDP OHYHO
according to the number of the pas-
sengers and loading weight in the
luggage area, turn the beam levelling
switch.
The higher the number on the switch
position, the lower the headlight
beam level. Always keep the head-
light beam at the proper levelling
position, or headlights may dazzle
other road users.
/LVWHG EHORZ DUH H[DPSOHV RI DSSUR-
priate switch settings for varying
loads. For loading conditions other
WKDQ WKRVH OLVWHG DGMXVW WKH VZLWFK
position to the most similar situation.
Loading conditionSwitch position
Driver only0
Driver + Front pas-
senger0
Full passengers
(including driver)1
Full passengers
(including driver) +
0D[LPXPSHUPLVVLEOH
loading2
'ULYHU0D[LPXP
permissible loading 3