2019 HONDA CLARITY PLUG IN HYBRID flat tire

505uu Checking and Maintaining Tires u DOT Tire Quality Grading (U.S. Vehicles)
Maintenance
The traction grades, from highest to lowest, are AA, A, B, and C.
Those grades represent the tire’s ability to stop on wet pavement
as measured under controlled conditions on specified
government test surfaces of asph alt and concrete. A tire marked
C may have poor traction performance.
The temperature grades are A (the highest), B, and C,
representing the tire’s resistance to the generation of heat and its
ability to dissipate heat when te sted under controlled conditions
on a specified indoor laboratory test wheel. Sustained high
temperature can cause the material of the tire to degenerate and
reduce tire life, and ex cessive temperature can lead to sudden tire
failure. The grade C corresponds to a level of performance which
all passenger car tires must meet under the Federal Motor Vehicle
Safety Standard No. 109. Grades B and A represent higher levels
of performance on the laboratory test wheel than the minimum
required by law.■ Traction
■ Temperature 1 Traction
Warning: The traction grade
assigned to this tire is based on
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics. 1 Temperature
Warning: The temperature grade for
this tire is establishe d for a tire that is
properly inflated and not
overloaded. Excessive speed,
underinflation, or excessive loading,
either separately or in combination,
can cause heat buildup and possible
tire failure.19 CLARITY PHEV-31TRW6100.book 505 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

506 uu Checking and Maintaining Tires u Wear Indicators
Maintenance Wear Indicators The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower than
elsewhere on the tire. If the tread has worn so
that the indicator is ex posed, replace the tire.
Worn out tires have poor traction on wet
roads.
Tire Service Life The life of your tires is dependent on many factors, including driving habits, road
conditions, vehicle loading, inflation pre ssure, maintenance history, speed, and
environmental conditions (even when the tires are not in use).
In addition to regular in spections and inflation pres sure maintenance, it is
recommended that you have annual inspecti ons performed once the tires reach five
years old. All tires should be removed fro m service after 10 years from the date of
manufacture, regardless of their condition or state of wear. Example of a Wear
Indicator mark19 CLARITY PHEV-31TRW6100.book 506 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

523Handling the Unexpected This chapter explains how to handle unexpected troubles.
If a Tire Goes Flat
Temporarily Repairi ng a Flat Tire....... 524
Handling of the Jack ......................... 536
Power System Won’t Start
Checking the Procedure ................... 537
If the Smart Entry Remote Battery is
Weak .......................................... 539
Emergency Power System Off........... 540
Jump Starting .................................... 541
Overheating
How to Handle Overheating ............. 544
Indicator, Coming On/Blinking
If the Low Oil Pressure Warning Appears .. 547 If the 12-Volt Battery Charging System
Indicator Comes On ....................... 548
If the Malfunction Indicator Lamp Comes
On or Blinks ..................................... 549
If the Brake System Indicator (Red) Comes
On or Blinks ....................................... 550
If the Electric Power Steering (EPS) System
Indicator Comes On ........................... 551
If the Brake System Indicator (Red)
Comes On or Blinks at the Same Time
When the Brake System Indicator
(Amber) Comes On ...................... 552 If the Low Tire Pressure/TPMS Indicator
Comes On or Blinks ....................... 553
If the Transmission System Indicator Blinks
along with the Warning Message .... 554
Fuses
Fuse Locations ................................. 555
Inspecting and Changing Fuses ........ 562
Emergency Towing ........................... 563
When You Cannot Unlock the Fuel Fill
Door ................................................. 564
When You Cannot Open the Charge
Lid ................................................. 565
When You Cannot Open the Trunk .. 56619 CLARITY PHEV-31TRW6100.book 523 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

524
Handling the Unexpected If a Tire Goes Flat Temporarily Repairing a Flat Tire If the tire has a large cut or is otherwise se verely damaged, you will need to have the
vehicle towed. If the tire only has a smal l puncture, from a nail for instance, you can
use the temporary tire repair kit so that you can drive to the nearest service station
for a more permanent repair.
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then stop in a safe place.
1. Park the vehicle on a firm, level, and non-slippery surface and apply the parking
brake.
2. Change the gear position to ( P
.
3. Turn on the hazard warning lights an d set the power mode to VEHICLE OFF
(LOCK). 1 Temporarily Repairing a Flat Tire
The kit should not be used in the following situations.
Instead, contact an authorized Honda Clarity Plug-In
Hybrid dealer or roadside assistance to have the
vehicle towed.
• The tire sealant has expired.
• More than one tire is punctured.
• The puncture or cut is larger than 3/16 inch (4 mm).
• The tire side wall is da maged or the puncture is
outside the contact area.
• Damage has been caused by driving with the tire
extremely under inflated.
• The tire bead is no longer seated.
• The rim is damaged.
Do not remove a nail or screw that punctured the
tire. If you remove it from the tire, you may not be
able to repair the puncture using the kit.When the puncture is: Kit Use
Smaller than 3/16 inch
(4 mm) Yes
Larger than 3/16 inch
(4 mm) NoContact
Area19 CLARITY PHEV-31TRW6100.book 524 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

Continued
525uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
Handling the Unexpected
■ Getting Ready to Temporarily Repair the Flat Tire 1 Getting Ready to Temporarily Repair the Flat Tire
Repair notificati on label and speed restriction label
are applied to the side of temporary tire repair kit.
When making a temporary repair, carefully read the
instruction manual provided with the kit.
Pressure GaugeAIR Power Plug
Pressure Relief Button
Repair Notification Label Instruction Manual
Sealant/Air Hose
REPAIR
Inflator Switch
Speed Restriction LabelSelector Knob
U.S. Canada U.S. Canada19 CLARITY PHEV-31TRW6100.book 525 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

526 uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
Handling the Unexpected 1. Remove the charging cable by releasing the
belt.
2. Pull the strap on the right side of the trunk
and open the lid.
3. Open the fastener and take the kit out of
the trunk.
4. Place the kit face up, on flat ground near
the flat tire, and away from traffic. Do not
place the kit on its side.Charging Cable
Fastener Strap
Lid19 CLARITY PHEV-31TRW6100.book 526 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

Continued
527uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
Handling the Unexpected
1. Remove the valve cap from the tire valve
stem.
2. Remove the sealant/air hose from the
packaging.
3. Attach the sealant/air hose onto the tire
valve stem. Screw it until it is tight.■ Injecting Sealant and Air 1 Injecting Sealant and Air
In cold temperatures, the sealant may not flow easily.
In this situation, warm it up for five minutes before
using.
The sealant can permanentl y stain clothing and other
materials. Be careful duri ng handling and wipe away
any spills immediately.3
WARNING Tire sealant contains substances that are
harmful and can be fatal if swallowed.
If accidentally swallowed, do not induce
vomiting. Drink plenty of water and get
medical attention immediately.
For skin or eye contact, flush with cool
water and get medical attention if
necessary.Valve Stem Valve Cap
Sealant/Air Hose
Valve Stem Sealant/Air Hose19 CLARITY PHEV-31TRW6100.book 527 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

uu If a Tire Goes Flat u Temporarily Repairing a Flat Tire
528
Handling the Unexpected 4. Plug in the compressor to the accessory
power socket.
u Be careful not to pinch the cord in a
door or window.
u Do not plug any other electronic
devices into other accessory power
sockets. 2 Accessory Power Sockets P. 189
5. Turn the power system on.
u Keep the power system on while
injecting sealant and air.
6. Turn the selector knob to REPAIR *1
,
SEALANT/AIR *2
, PRODUIT ANTIFUITE/
AIR *2
.
*1: U.S. models
*2: Canadian models 1 Injecting Sealant and Air
NOTICE
Do not operate the temporary tire repair kit
compressor for more than 15 minutes. The
compressor can overheat and become permanently
damaged.
There are two accessory power sockets:
• In the back of the console compartment
• In the console panel
2 Accessory Power Sockets P. 1893
WARNING Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with th e vehicle outdoors.U.S.
Canada19 CLARITY PHEV-31TRW6100.book 528 ページ ２０１８年１０月２５日　木曜日　午後２時２９分