2019 CITROEN DS3 ignition

Safety
Seat belts Front seat
belts
The front seat belts are fitted with a pretensionin
g and
force limitin
g system.

This s
ystem improves sa
fety in the
front seats
in the event o
f a front impact. Depending on the
severity of the impact, the pretensioning systeminstantly tightens the seat belts against the body of the occupants.
The pretensionin
g seat belts are active when
t
he ignition
is on.
The force limiter reduces the pressure of theseat belt on the chest o
f the occu
pant,
so improving their protection.
Fastenin
g
) Pull the strap, then insert the tongue in the
buc
kle.
) Check that the seat belt is fastenedcorrectl
y by pullin
g the strap.
Unfastening ) Press the red button on the buckle.) Guide the seat belt as it is reeled in.
Seat
be
lt not faste
ned
/
unfastened warnin
g lamp
When the ignition is switched on,
this warning lamp comes on in theinstrument panel, if the driver and/o
r
the
front passen
ger has not
fastened
t
hei
r sea
t bel
t.
From approximatel
y 12 mph
(20 km
/h)
this warning lamp
flashes
for two minutes
accompanied by an audible signal o
f increasing
volume. Once these two minutes have elapsed,
this warning lamp remains on until the drive
r
and/or the front passenger fastens thei
r
sea
t belt.

Airbags System desi
gned to maximise the sa
fety of the
occupants
(with the exception o
f the rear centre
passen
ger) in the event o
f violent collisions.
It supplements the action of the
force-limiting
seat belts (with the exception of the rear centre passenger).If a collision occurs, the electronic detectors record and anal
yse the front and side impacts
sustained in the impact detection zones: - in the case of a serious impact, the airbags
are tr
igg
ere
d instant
ly an
d protect t
he
occupants o
f the vehicle
(with the exception
o
f the rear centre passenger
); immediately
after the impact, the airbags deflate rapidly
so that they do not hinder visibility or the
exit of the occupants,
- in the case of a minor or rear impact or in
certa
in ro
ll-over con
ditions, t
he a
irbags
will
not
be tr
igg
ere
d; the seat
belt alone
is
su
fficient to
provide o
ptimum
protection in
these s
ituat
ions.
The airbags do not operate when theignition is switched off
.
This equipment will onl
y deplo
y once.
If a second impact occurs
(durin
g the
same or a subsequent accident
), the
airbag will not
be tr
igg
ere
d again.
Impact
detect
ion zones
A.
Front
impact zone.
B.Side im
pact zone.
Tr iggerin
g of the airba
g(s) is
accompan
ied by a s
ligh
t em
ission
of harmless smoke and a noise, due to the activation of the pyrotechniccartridge incorporated in the system. This smoke is not harmful
, but sensitive
individuals ma
y experience sli
ght
irrit
ation.

The noise o
f the detonation ma
y result
in a sli
ght loss o
f hearin
g for a short time.

DeactivationOnly the passenger's front airbag can be deact
ivate
d:
)
with the ignition off
, insert t
he key in the
f
passenger airbag deactivation switch
1 ,
)
turn it t
o the "OFF
"position,
)
then, remove the key keeping the switch in the new position.
This warning lamp comes on in theinstrument panel when the ignition is
on and until the airbag is re-activated.
To assure the safety of your child, the passenger's front airbag must be deactivated when you install a "rear facin
g" child seat on the front
passen
ger sea
t.
Other wise, the child would risk bein
g
seriousl
y injured or killed i
f the airba
g
were tr
iggere
d.
React
ivat
ion
Wh
en
you remove t
he child
seat, turn sw
itch 1
to
the "ON"
pos
ition to re-act
ivate t
he a
irbag an
d
so assure the sa
fety o
f your
front passenger in
the event of an impact.
With the ignition on, t
his warn
ing
lam
p comes on
in the instrument
panel for approximately one minute, if the passenger's front airbag is activated.
Operatin
g fault
If this warning lamp
flashes, contact
a CITRO
ËN dealer. The passenger's
front airbag may no longer be
triggered in the event of a serious
impact.
If at least one of the two airbag warning lamps come on continuously,do not in
stall a child sea
t on th
e front
passenger sea
t.
Have the s
ystem checked b
y a
CITR
OË
N dealer.
I
f this warning lamp comes on on theinstrument panel, accompanied by an audible warning and a message on
the multifunction screen
, contact a CITROËN
dealer to have the s
ystem checked. The
airba
gs ma
y no lon
ger be tri
ggered in the event
o
f a serious im
pact.

Manual operation
D disappears an
d the gears en
gaged
app
ear
in success
ion on t
he
instrument
pane
l.
In the event of the engine labouring
or over-revving, the gear selected flashes for afew seconds, then the actual gear engaged isdisplayed. It is possible to change from position
D
(automatic) to position
M
(manual) at any time.
Wh
en t
he ve
hicle is stat
ionar
y or mov
ing
very slowly, the gearbox selects gear
M1
automatically. The sport and snow programmes do not operate in manual mode.

Invalid value durin
g manual
operation
)
Select
position
M for sequent
ialchanging
o
f the
four gears.
)
Push the lever towar
ds the +
sign to
change up a gear.
)
Pull th
e lever towards the - sign to change
down a gear.
It is onl
y possible to chan
ge from one
gear to
another i
f the vehicle speed and en
gine speed
permit; other wise, the gearbox will operate temporarily in automatic mode.

This s
ymbol is displa
yed i
f a gear
is not en
gaged correctl
y (selector
between two positions
).

Stoppin
g the vehicle

Before switchin
g off the en
gine,
you can en
gage
position
Por N
to p
lace t
he gear
box in neutra
l.

In both cases, app
ly the par
king
brake to
immo
bilise t
he ve
hicle.
Wh
en t
he ignition is on, t
he
lighting of this warning lamp,
accompanied by an audible
signal and a message on the multifunction screen,
indicates a
gearbox malfunction.
In this case, the
gearbox switches to back-up mode
and is locked in 3rd gear. You ma
y feel a substantial
knock when chan
ging from
Pto R and from R
Nto R.R
This w
ill not cause an
y dama
ge to t
he gear
box.
Do not exceed 60 mph
(10 0 km
/h), local speed
restrictions permitting.
Contact a CITROËN dealer as soon as possible.
Operatin
g fault
If the lever is not in position
P ,P
when the driver's door is opened or approximatel
y 45 seconds after the
ignition is switched o
ff, a messa
ge
app
ears in the multi
function screen.
)
Return t
he lever to
position
P; the
message
disappears.
There is a risk o
f dama
ge to the
gearbox:
- i
f you press the accelerator and brake pedals at t
he same t
ime,
- i
f you
force the movement o
f the
gear lever from the
Pposition to
another position when the battery is flat.

To reduce fuel consumption when at a prolon
ged standstill with the en
gine
runnin
g (traffic
jam...
), put the
gear
lever in th
e Nposition and appl
y the
parkin
g brake.

151
Driving
System which prevents the vehicle fromexcee
ding the spee
d pro
gramme
d by the driver.

When the programmed speed limit is reached,pressing the accelerator pedal in the normal manner no longer has any effect. The speed limiter is
switched
on
manua
lly:
it requires a programmed speed of at least 20 mph (30 km/h). The speed limiter is
switched off
by manual f
operation of the control. The programmed speed can be exceeded temporaril
y by pressin
g the accelerator
firml
y.

To return to t
he pro
gramme
d spee
d, simp
ly
slow
down to a spee
d below t
he pro
gramme
d
speed.
The programmed speed remains in the memory when the ignition is switched off. Speed limiter
The spee
d limiter cannot,
in an
y
circumstances, re
place t
he nee
d to
res
pect s
peed limits, nor can
it re
place
the need
for vi
gilance and responsibilit
y
on the
part o
f the driver. The controls of this s
ystem are
grouped
together on stalk
A.
1.
Speed limiter mode selection thumb wheel
2. Value
decrease
button
3. Value
increase
button
4.
Speed limiter on
/off button
Steerin
g mounted controls
The pro
grammed information is
grouped
to
gether on the instrument panel displa
y.
5. Speed limiter on
/off indication
6. Speed limiter mode selection indication
7. Programme
d spee
d va
lue

Displa
ys on the instrument panel

153
Driving
Cruise control
System which automatically maintains the speed of the vehicle at the value programmedby the driver, w
ithout an
y act
ion on t
he
accelerator pedal. The cru
ise contro
l is switched
on
manua
lly: it
re
quires a minimum vehicle s
peed o
f 25 m
ph
(40 km/h), as well as the engagement of: - fourth gear on a manual gearbox,
- second gear on an automatic gearbox, in
sequential mode,
- position
D on an automatic gearbox.
The
cruise
control is switched off
manually f
or by press
ing the brake or c
lutc
h pe
dal or
on triggering of the ESP system for safetyreasons
.
It is possible to exceed the programmed speed
temporarily by pressing the accelerator pedal.
To return to the programmed speed, simply
release the accelerator pedal.
Switching off the ignition cancels any programmed speed value.
The controls of this s
ystem are
grouped
together on stalk
A.
1.
Cruise control mode selection thumb whel
2. Value
decrease
button
3. Value
increase
button
4.
Cruise control o
ff/resume button
Steerin
g mounted controls
The cru
ise contro
l cannot,
in an
y
circumstances, re
place t
he nee
d to
respect s
peed limits, nor can
it re
place
the need
for vi
gilance and responsibilit
y
on the
part o
f the driver. The pro
grammed information is
grouped
to
gether on the instrument panel displa
y.
5. Cruise control o
ff/resume indication
6. Cruise control mode selection indication
7. Programme
d spee
d va
lue
Displa
ys on the instrument panel

Pro
grammin
g
Operatin
g faults
If there is an operating
fault, when reverse gear
is engaged this warning lamp comes on on the
instrument panel, accompanied by an audible
signal (short beep) and a message on the
m
ultifunction screen.
You can act
ivate or
deact
ivate t
he system
by
means of the multifunction screen configuration menu. The system state is memorised whenswitching off the ignition.
For more information on access to the parkin
g
assistance menu, re
fer to vehicle con
figuration
in the "Multifunction screens" section correspon
ding to
your screen.
The system w
ill be deact
ivate
d
automat
ically w
hen tow
ing a tra
iler or
when a bicycle carrier is fitted (vehicle fitted with a towbar or bicycle carrier recommended by CITROËN).
In bad or w
intry weat
her, ensure t
hat
the sensors are not covere
d with mu
d,
frost or snow.

Practical information
Removing the wheel

Parking the vehicle
Imm
obilise the vehicle wh
ere it does

not block traffic: the ground must belevel, stable and not slipper
y.
Appl
y the parkin
g brake, switch o
ff the
ignition and en
gage first
gear
* to lock
the w
heels.
If necessary, place a chock under thewheel diagona
lly oppos
ite t
he w
heel to
be changed.
It is imperative that you ensure that the occupants get out of the vehicle andwait where the
y are safe.
Never
go un
derneat
h a ve
hicle ra
ised
using a jack; use an axle stand.
List of o
perations
)
Remove the chromed bolt cover from eac
h
o
f the bolts usin
g the tool
3(allo
y wheels
only).
)
Fit the socket
4 on t
he w
heelbrace
1
to
slacken the security bolt.
)
Slacken the other bolts using the wheelbrace
1 only.
* position
P for an automatic
gearbox.