REPLACING FUSES
INTRODUCTION
133) 134) 135) 136) 137)
60) 61)
Fuses protect the electrical system: they
intervene (blow) in the event of a failure
or improper action on the system.
Fuse extracting pliers
To replace a fuse, use the pliers hooked
to the boot fusebox cover fig. 133.
Grab the pliers from the upper tabs,
press them and extract the pliers pulling
upwards.
The pliers fig. 134 have two different
ends, specifically designed to remove the
different types of fuses present in the
vehicle.
1: MINI fuse;
2: J-CASE fuse.After use, refit the pliers in position,
proceeding as follows:
grasp the pliers from the upper tabs;
press the pliers in their housing,
pushing downwards, until they click into
place.
FUSE LOCATION
The fuses, which can be replaced by the
user, are grouped in two boxes below the
passenger side foot board and inside the
boot.
CONTROL UNIT UNDER PASSENGER
SIDE FOOTBOARD
To access the fuses, proceed as follows:
lift the upper end of the footboard 1
fig. 135 on the passenger side, pulling it
to release the 2 buttons;
remove the panel 2 fig. 136,
extracting it downward, after unscrewing
the two fixing hooks;
the fuses are freely accessible on the
control unit.
The number identifying the electrical
component corresponding to each fuse is
shown on the control unit cover.13308036S0053EM
13408036S0005EM13508036S0010EM
13608036S0011EM
146
IN AN EMERGENCY
