2019.75 VAUXHALL COMBO E headlights

Vehicle care217Discharge protection
Battery voltage
When the vehicle battery voltage is
running low, a warning message will
appear in the Driver Information
Centre.
When the vehicle is being driven, the
load reduction function temporarily
deactivates certain functions, e.g. the heated rear window.
The deactivated functions are
reactivated automatically as soon as
conditions permit.
Idle boost
If charging of the vehicle battery is
required due to battery condition, the
power output of the generator must be increased. This will be achieved by an idle boost which may be audible.
A message appears in the Driver
Information Centre.
Power outlet
The power outlets are deactivated in
the event of low vehicle battery
voltage.Warning label
Meaning of symbols:
● No sparks, naked flames or smoking.
● Always shield eyes. Explosive gases can cause blindness or
injury.
● Keep the vehicle battery out of reach of children.
● The vehicle battery contains sulphuric acid which could cause
blindness or serious burn
injuries.
● See the Owner's Manual for further information.
● Explosive gas may be present in the vicinity of the vehicle battery.
Power saving mode This mode deactivates electrical
consumers to avoid excessive
discharging of the vehicle battery.
These consumers, such as the
infotainment system, windscreen
wipers, low beam headlights,
courtesy light, etc. can be used for a
total maximum time of about
40 minutes after ignition is switched
off.
Changing into power saving mode
When power saving mode is
activated, a message appears in the
Driver Information Centre indicating
Power saving mode .
An active telephone call using the
hands-free option will be maintained
for around 10 minutes longer.

Vehicle care219Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check After a bulb replacement switch on
the ignition, operate and check the
lights.
Halogen headlights Halogen headlights with separate
bulbs for low beam and high beam.
Low beam ( 1) outer bulb
High beam ( 2) inner bulb
Low beam (1)
1. Remove the protective cover by pulling the tab.
2.Withdraw the bulb socket from the
reflector housing.

Vehicle care221Sidelight / daytime running light
with bulbs
1. Rotate the bulb socket anticlockwise to disengage and
withdraw from the reflector.
2. Remove the bulb from the socket by pulling.
3. Replace and insert the new bulb into the socket.
4. Insert the bulb socket into the headlamp housing and turn
clockwise.
Sidelight / daytime running light
with LEDs
In case of defective LEDs, have them replaced by a workshop.
LED headlights Daytime running lights are designedas LEDs and can not be changed.
Have lights repaired by a workshop in
case of failure.
Front fog lights
1. Wrap a cloth around the tip of a flat
screwdriver to prevent paint
damage. Insert the screwdriver in
the recess at the edge of the
cover. Release the cover by
levering it out carefully.

Vehicle care243● A discharged vehicle battery canalready freeze at a temperature
of 0 °C. Defrost the frozen battery before connecting jump leads.
● Wear eye protection and protective clothing when
handling a battery.
● Use a booster battery with the same voltage (12 V). Its capacity
(Ah) must not be much less than
that of the discharged vehicle
battery.
● Use jump leads with insulated terminals and a cross section of
at least 16 mm 2
(25 mm 2
for
diesel engines).
● Do not disconnect the discharged
vehicle battery from the vehicle.
● Switch off all unnecessary electrical consumers.
● Do not lean over the vehicle battery during jump starting.
● Do not allow the terminals of one
lead to touch those of the other
lead.● The vehicles must not come into contact with each other during
the jump starting process.
● Apply the parking brake, transmission in neutral,
automatic transmission in P.
Open the positive terminal protection
caps of both vehicle batteries.
Lead connection order: 1. Connect the red lead to the positive terminal of the booster
battery.
2. Connect the other end of the red lead to the positive terminal of the
discharged battery.
3. Connect the black lead to the negative terminal of the boosterbattery.
4. Connect the other end of the black
lead to a vehicle grounding point
of your vehicle in the engine
compartment.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After five minutes, start the other engine. Start attempts should be
made for no longer than 15 s at an interval of 1 min.
3. Allow both engines to idle for approx. three minutes with the
leads connected.
4. Switch on electrical consumers e.g. headlights, heated rear
window of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.

276Gear shifting............................... 103
General information ...................205
Glass panel .................................. 43
Glovebox ..................................... 69
Glovebox cooler ......................... 141
Graphic Info Display ...................115
H Halogen headlights ....................219
Hand brake ................................. 160
Hazard warning flashers ............124
Headlight flash ........................... 123
Headlight range adjustment ......124
Headlights................................... 121 Headlights when driving abroad 124
Head restraint adjustment .............8
Head restraints ............................ 44
Head-up display.......................... 112 Heated mirrors ............................. 38
Heated rear window ..................... 42
Heated steering wheel .................89
Heating ........................................ 49
Heating and ventilation system . 130
High beam ......................... 106, 122
High beam assist ................106, 122
Hill start assist ........................... 162
Horn ....................................... 13, 90
I
Identification plate .....................256
Ignition switch positions .............143Immobiliser .................................. 36
Indicators ...................................... 97
Inductive charging ........................94
Info Display ................................. 110
Installing seats .............................. 51
Instrument cluster ........................96
Instrument panel fuse box .........228
Instrument panel illumination control .................................... 127
Instrument panel overview ........... 10
Interior care ............................... 248
Interior lighting ............................ 127
Interior lights ...................... 127, 226
Interior mirrors .............................. 38
Introduction .................................... 3
J Jump starting ............................. 242
K Keys ............................................. 20
Keys, locks ................................... 20
L Ladder flap.................................... 74
Lane keep assist ................104, 198
Lashing eyes ............................... 78
LED headlights ...................106, 221
Lighting features .........................128
Light switch ................................ 121
Load compartment ................31, 74Load compartment cover .............75
Load compartment grille ...............81
Loading ............................. 47, 50, 51
Loading information .....................85
Low beam ................................... 106
Low fuel ..................................... 106
M
Malfunction indicator light ..........102
Manual anti-dazzle ......................38
Manual mode ............................. 156
Manual transmission .................. 158
Mirror adjustment ........................... 8
Misted light covers .....................126
Multimedia .................................. 115
Multimedia Navi Pro ...................115
N
New vehicle running-in ..............143
Number plate light .....................226
O Object detection systems ...........183
Odometer ..................................... 97
Oil, engine .......................... 254, 258
Outside temperature ....................92
Overhead console .......................71
Overload indicator ................86, 103
Overrun cut-off ........................... 147